Engineering topics

Trivisonno, R. J.

Publications and source records attributed to Trivisonno, R. J..

5 records

NASA NTRS1981

The effect of minority carrier mobility variations on solar cell spectral response

Analysis of multistep diffused, high voltage 0.1 ohm-cm solar cells suggests that the increased voltage capability of these cells is correlated with localized variations in the base minority carrier mobility. An attempt to calculate the behavior of those cells revealed unexpected results. It is shown, contrary to what was expected, that spatial variations in the mobility effects severe changes in the short-circuit current and the spectral response. Variations in cell output as a result of imposing abrupt, linear, and exponential mobility variations are presented.

Weizer, V. G.↗

NASA NTRS1979

Graphics program for charts

GASPLOT program is reliable, economical, and easy-to-use method of producing variety of thermophysical-property charts.

Hendricks, R. C.↗

NASA NTRS1977

GASPLOT - A computer graphics program that draws a variety of thermophysical property charts

A FORTRAN V computer program, written for the UNIVAC 1100 series, is used to draw a variety of precision thermophysical property charts on the Calcomp plotter. In addition to the program (GASPLOT), which requires (15 160) sub 10 storages, a thermophysical properties routine needed to produce plots. The program is designed so that any two of the state variables, the derived variables, or the transport variables may be plotted as the ordinate - abscissa pair with as many as five parametric variables. The parameters may be temperature, pressure, density, enthalpy, and entropy. Each parameter may have as many a 49 values, and the range of the variables is limited only by the thermophysical properties routine.

Trivisonno, R. J.↗

NASA NTRS1974

Computer program for calculating critical speeds of rotating shafts

Shaft may include bearings, couplings, extra masses, and disks for gyroscopic effect. Shaft deflection is taken into account and provision is made in program for sections of shaft that are tapered. Plotter produces drawing of shaft with superimposed deflection curves at critical speeds together with all pertinent information related to shaft.

Trivisonno, R. J.↗

NASA NTRS1973

FORTRAN 4 computer program for calculating critical speeds of rotating shafts

A FORTRAN 4 computer program, written for the IBM DCS 7094/7044 computer, that calculates the critical speeds of rotating shafts is described. The shaft may include bearings, couplings, extra masses (nonshaft mass), and disks for the gyroscopic effect. Shear deflection is also taken into account, and provision is made in the program for sections of the shaft that are tapered. The boundary conditions at the ends of the shaft can be fixed (deflection and slope equal to zero) or free (shear and moment equal to zero). The fixed end condition enables the program to calculate the natural frequencies of cantilever beams. Instead of using the lumped-parameter method, the program uses continuous integration of the differential equations of beam flexure across different shaft sections. The advantages of this method over the usual lumped-parameter method are less data preparation and better approximation of the distribution of the mass of the shaft. A main feature of the program is the nature of the output. The Calcomp plotter is used to produce a drawing of the shaft with superimposed deflection curves at the critical speeds, together with all pertinent information related to the shaft.

Trivisonno, R. J.↗