Troy Lyons | Search NASA

NASA NTRSDate not supplied

Modeling Uprighting of the Orion Crew Module using a Finite Element Method with Wave Coupling and Structural Deformability

The Crew Module Uprighting System (CMUS) for the Orion Crew Module (CM) includes five bags that inflate after splashdown to rotate and upright the CM as necessary. Wave conditions can be severe enough to damage the bags and tethers, which could make the recovery operation hazardous. The CMUS therefore has design limits that ultimately constrain where the CM can land based upon sea conditions. This manuscript describes a full fluid-structure interaction computational model being used for the CMUS. It is a finite element model that uses explicit time integration to directly simulate uprighting, a computational approach usually reserved for short duration, highly transient phenomena and novelly applied here. The goal of this current effort is to determine the feasibility of this approach for CMUS uprighting, and to estimate the loads the CMUS bags experience in different wave conditions. The results from this work will be used to supplement other experimental and computational data in support of NASA’s Artemis program.

John Puryear↗

NASA NTRSDate not supplied

Application of the MAT 213 Composite Impact Model to NASA Problems of Interest

As composite materials are gaining increased use in aircraft components where impact resistance under high-energy impact conditions is important (such as the turbine engine fan case), the need for accurate material models to simulate the deformation, damage, and failure response of polymer matrix composites under impact conditions is becoming more critical.

Polymer Matrix Composites↗

NASA NTRSDate not supplied

Application of the MAT 213 Composite Impact Model to NASA Problems of Interest

A material model has been developed which incorporates several key capabilities which have been identified as lacking in currently available composite impact models. The material model utilizes experimentally based tabulated input to define the evolution of plasticity and damage as opposed to specifying discrete input parameters (such as modulus and strength). The material model has been implemented into LS-DYNA® as MAT 213. The model can simulate the nonlinear deformation, damage and failure that takes place in a composite under dynamic loading conditions. The deformation model utilizes an orthotropic plasticity formulation. For the damage model, the nonlinear unloading response that is observed prior to the point where the peak stress is reached can be simulated, as well as the stress degradation response that occurs after the peak stress is reached. A variety of failure models, including a generalized tabulated failure model which facilitates the utilization of general failure surfaces, have been implemented into MAT 213. Recent studies at NASA have concentrated on using MAT 213 to analyze both the impact and crush response of a variety of laminated and textile architectures. Several of these studies will be discussed in the presented paper. For example, a woven carbon/Kevlar composite is currently being examined for use in an energy absorber system for rotorcraft structures. MAT 213 analyses have been conducted to examine the ability of the model to accurately simulate the dynamic crush response of this material. Studies are also being conducted to examine the ability of MAT 213 to simulate the ballistic impact response of representative laminated and woven thermoplastic and thermoset matrix composites. NASA efforts are also concentrated on developing methods and processes for improving characterization methods and developing “best practices” for using MAT 213, a summary of which will be discussed in the paper.

Polymer Matrix Composites↗