Search NASA⌕ Search

Engineering topics

Trugman, Daniel T.

Publications and source records attributed to Trugman, Daniel T..

Foreshock properties illuminate nucleation processes of slow and fast laboratory earthquakes

Understanding the connection between seismic activity and the earthquake nucleation process is a fundamental goal in earthquake seismology with important implications for earthquake early warning systems and forecasting. We use high-resolution acoustic emission (AE) waveform measurements from laboratory stick-slip experiments that span a spectrum of slow to fast slip rates to probe spatiotemporal properties of laboratory foreshocks and nucleation processes. We measure waveform similarity and pairwise differential travel-times (DTT) between AEs throughout the seismic cycle. AEs broadcasted prior to slow labquakes have small DTT and high waveform similarity relative to fast labquakes. We show that during slow stick-slip, the fault never fully locks, and waveform similarity and pairwise differential travel times do not evolve throughout the seismic cycle. In contrast, fast laboratory earthquakes are preceded by a rapid increase in waveform similarity late in the seismic cycle and a reduction in differential travel times, indicating that AEs begin to coalesce as the fault slip velocity increases leading up to failure. These observations point to key differences in the nucleation process of slow and fast labquakes and suggest that the spatiotemporal evolution of laboratory foreshocks is linked to fault slip velocity.

58 GEOSCIENCES↗

The High-Frequency Signature of Slow and Fast Laboratory Earthquakes

Tectonic faults fail through a spectrum of slip modes, ranging from slow aseismic creep to rapid slip during earthquakes. Understanding the seismic radiation emitted during these slip modes is key for advancing earthquake science and earthquake hazard assessment. In this work, we use laboratory friction experiments instrumented with ultrasonic sensors to document the seismic radiation properties of slow and fast laboratory earthquakes. Stick-slip experiments were conducted at a constant loading rate of 8 μm/s and the normal stress was systematically increased from 7 to 15 MPa. We produced a full spectrum of slip modes by modulating the loading stiffness in tandem with the fault zone normal stress. Acoustic emission data were recorded continuously at 5 MHz. We demonstrate that the full continuum of slip modes radiate measurable high-frequency energy between 100 and 500 kHz, including the slowest events that have peak fault slip rates <100 μm/s. The peak amplitude of the high-frequency time-domain signals scales systematically with fault slip velocity. Stable sliding experiments further support the connection between fault slip rate and high-frequency radiation. Experiments demonstrate that the origin of the high-frequency energy is fundamentally linked to changes in fault slip rate, shear strain, and breaking of contact junctions within the fault gouge. Our results suggest that having measurements close to the fault zone may be key for documenting seismic radiation properties and fully understanding the connection between different slip modes.

58 GEOSCIENCES↗

Big Data Seismology

The discipline of seismology is based on observations of ground motion that are inherently undersampled in space and time. Our basic understanding of earthquake processes and our ability to resolve 4D Earth structure are fundamentally limited by data volume. Currently, Big Data Seismology is an emergent revolution involving the use of large, data-dense inquiries that is providing new opportunities to make fundamental advances in these areas. This article reviews recent scientific advances enabled by Big Data Seismology through the context of three major drivers: the development of new data-dense sensor systems, improvements in computing, and the development of new types of techniques and algorithms. Each driver is explored in the context of both global and exploration seismology, alongside collaborative opportunities that combine the features of long-duration data collections (common to global seismology) with dense networks of sensors (common to exploration seismology). The review explores some of the unique challenges and opportunities that Big Data Seismology presents, drawing on parallels from other fields facing similar issues. Finally, recent scientific findings enabled by dense seismic data sets are discussed, and we assess the opportunities for significant advances made possible with Big Data Seismology. This review is designed to be a primer for seismologists who are interested in getting up-to-speed with how the Big Data revolution is advancing the field of seismology.

58 GEOSCIENCES↗

The Spatiotemporal Evolution of Granular Microslip Precursors to Laboratory Earthquakes

Laboratory earthquake experiments provide important observational constraints for our understanding of earthquake physics. Here we leverage continuous waveform data from a network of piezoceramic sensors to study the spatial and temporal evolution of microslip activity during a shear experiment with synthetic fault gouge. We combine machine learning techniques with ray theoretical seismology to detect, associate, and locate tens of thousands of microslip events within the gouge layer. Microslip activity is concentrated near the center of the system but is highly variable in space and time. While microslip activity rate increases as failure approaches, the spatiotemporal evolution can differ substantially between stick-slip cycles. These results illustrate that even within a single, well-constrained laboratory experiment, the dynamics of earthquake nucleation can be highly complex.

58 GEOSCIENCES↗

3D fault architecture controls the dynamism of earthquake swarms

The vibrant evolutionary patterns made by earthquake swarms are incompatible with standard, effectively two-dimensional (2D) models for general fault architecture. Here we leverage advances in earthquake monitoring with a deep-learning algorithm to image a fault zone hosting a 4-year-long swarm in southern California. We infer that fluids are naturally injected into the fault zone from below and diffuse through strike-parallel channels while triggering earthquakes. A permeability barrier initially limits up-dip swarm migration but ultimately is circumvented. This enables fluid migration within a shallower section of the fault with fundamentally different mechanical properties. Our observations provide high-resolution constraints on the processes by which swarms initiate, grow, and arrest. These findings illustrate how swarm evolution is strongly controlled by 3D variations in fault architecture.

58 GEOSCIENCES↗

Stress-Drop and Source Scaling of the 2019 Ridgecrest, California, Earthquake Sequence

Stress drop, while difficult to measure reliably and at scale, is a key source parameter for understanding the earthquake rupture process and its relationship to strong ground motion. Here, we use a P-wave spectral decomposition approach, designed for large and densely sampled datasets, to measure earthquake stress drop in the region surrounding the 2019 Ridgecrest, California, earthquake sequence. With more than 11,000 measurements of earthquake stress drop in the 20-yr time period from 2000 through 2019, this dataset provides an opportunity to understand how coseismic stress changes and how other geophysical factors relate to the distribution of stress drop and its evolution in space and time. We observe a mild but persistent deviation from self-similar scaling, with larger events having systematically higher stress drops, though this trend depends on the assumption of an omega-square source spectral model. Earthquake stress drop increases with hypocentral depth in this study region, and the Ridgecrest aftershocks tend to have higher stress drops than the pre-event seismicity. This is in part due to their deeper hypocenters. Coherent spatial patterns of stress drop in the aftershock sequence correlate with the slip distribution of the M 7.1 mainshock, whose northwest rupture tip terminated in a long-lived zone of enervated stress drop. Although physical interpretation of these results is complicated by the trade-offs between the timing, depth, and location of these earthquakes, the observations provide new insight into the physics of the earthquake source in an area of renewed seismic activity in southern California.

58 GEOSCIENCES↗

Deciphering the Stress State of Seismogenic Faults in Oklahoma and Southern Kansas Based on an Improved Stress Map

Fault location and geometry are prime considerations in the reactivation of preexisting faults. Here, we combine relocated earthquake catalogs and focal mechanisms to delineate seismogenic faults in Oklahoma and southern Kansas and analyze their stress state. Initially, we identify and map seismogenic faults based on earthquake clustering. We then obtain an improved stress map using 2,047 high-quality focal mechanisms. The regional stress map shows a gradual transition from oblique normal faulting in western Oklahoma to strike-slip faulting in central and eastern Oklahoma. Stress amplitude ratio shows a strong correlation with pore pressure from hydrogeologic models, suggesting that pore pressure exhibits a measurable influence on stress patterns. Finally, we assess fault stress state via 3-D Mohr circles; a parameter understress is used to quantify the level of fault criticality (with 0 meaning critically stressed faults and 1 meaning faults with no applied shear stress). Our findings suggest that most active faults have near vertical planes (planarity >0.8 and dip >70°), and there is a strong correlation between fault length and maximum magnitude on each fault. The fault trends show prominent conjugate sets that strike [55–75°] and [105–125°]. A comparison with mapped sedimentary faults and basement fractures reveals common tectonic control. Based on 3-D Mohr circles, we find that 78% of the faults are critically stressed (understress ≤0.2), while several seismogenic faults are misoriented with high understress (>0.4). Fault geometry and local stress fields may be used to evaluate potential seismic hazard, as the largest earthquakes tend to occur on long, critically stressed faults.

58 GEOSCIENCES↗

Pervasive Foreshock Activity Across Southern California

Foreshocks have been recorded as preceding less than half of all mainshock earthquakes. These observations are difficult to reconcile with laboratory earthquake experiments and theoretical models of earthquake nucleation, which both suggest that foreshock activity should be nearly ubiquitous. In this work, we use a state-of-the-art, high-resolution earthquake catalog to study foreshock sequences of magnitude M4 and greater mainshocks in southern California from 2008–2017. This highly complete catalog provides a new opportunity to examine smaller magnitude precursory seismicity. Seventy-two percent of mainshocks within this catalog are preceded by foreshock activity that is significantly elevated compared to the local background seismicity rate. Foreshock sequences vary in duration from several days to weeks, with a median of 16.6 days. The results imply that foreshock occurrence in nature is more prevalent than previously thought and that our understanding of earthquake nucleation may improve in tandem with advances in our ability to detect small earthquakes.

58 GEOSCIENCES↗

Searching for hidden earthquakes in Southern California

Earthquakes follow a well-known power-law size relation, with smaller events occurring much more often than larger events. Earthquake catalogs are thus dominated by small earthquakes yet are still missing a much larger number of even smaller events because of signal fidelity issues. To overcome these limitations, we applied a template-matching detection technique to the entire waveform archive of the regional seismic network in Southern California. This effort resulted in a catalog with 1.81 million earthquakes, a 10-fold increase, which provides important insights into the geometry of fault zones at depth, foreshock behavior and nucleation processes, and earthquake-triggering mechanisms. The rich detail resolved in this type of catalog will facilitate the next generation of analyses of earthquakes and faults.

58 GEOSCIENCES↗

Peak Ground Displacement Saturates Exactly When Expected: Implications for Earthquake Early Warning

The scaling of rupture properties with magnitude is of critical importance to earthquake early warning (EEW) systems that rely on source characterization using limited snapshots of waveform data. ShakeAlert, a prototype EEW system that is being developed for the western United States, provides real-time estimates of earthquake magnitude based on P-wave peak ground displacements calculated at stations triggered by the event. The algorithms used in ShakeAlert assume that the displacement measurements at each station are statistically independent and that there exists a linear and time-independent relation between log peak ground displacement and earthquake magnitude. Here we challenge this basic assumption using the largest dataset assembled for this purpose to date: a comprehensive database of more than 140,000 vertical-component waveforms from M4.5–M9 earthquakes occurring near Japan from 1997 through 2018 and recorded by the K-NET and KiK-net strong-motion networks. By analyzing the time-evolution of P-wave peak ground displacements for these earthquakes, we show that there is a break, or saturation, in the magnitude-displacement scaling that depends on the length of the measurement time window. We demonstrate that the magnitude at which this saturation occurs is well-explained by a simple and non-deterministic model of earthquake rupture growth. We then utilize the predictions of this saturation model to develop a Bayesian framework for estimating posterior uncertainties in real-time magnitude estimates.

58 GEOSCIENCES↗

Comparing EGF Methods for Estimating Corner Frequency and Stress Drop from P-wave Spectra

Empirical Green's functions (EGF) are widely applied to correct earthquake spectra for attenuation and other path effects in order to estimate corner frequencies and stress drops, but these source parameter estimates often exhibit poor agreement between different studies. We investigate this issue by analyzing a compact cluster of over 3000 aftershocks of the 1992 Landers earthquake. We apply and compare two different analysis and modeling methods: (1) the spectral decomposition and global EGF fitting approach, and (2) a more traditional EGF method of modeling spectral ratios. We find that spectral decomposition yields event terms that are consistent with stacks of spectral ratios for individual events, but source-parameter estimates nonetheless vary between the methods. The main source of differences comes from the modeling approach used to estimate the EGF. The global EGF-fitting approach suffers from parameter tradeoffs among the absolute stress drop, the stress-drop scaling with moment, and the high-frequency falloff rate, but has the advantage that the relative spectral shapes and stress drops among the different events in the cluster are well-resolved even if their absolute levels are not. The spectral-ratio approach solves for a different EGF for each target event without imposing any constraint on the corner frequency, f c , of the smaller events, and so can produce biased results for target-event f c . Placing constraints on the small-event f c improves the performance of the spectral-ratio method and allows the two methods to yield very similar results.

58 GEOSCIENCES↗

Statistical tests on clustered global earthquake synthetic data sets

Abstract We study the ability of statistical tests to identify nonrandom features of earthquake catalogs, with a focus on the global earthquake record since 1900. We construct four types of synthetic data sets containing varying strengths of clustering, with each data set containing on average 10,000 events over 100 years with magnitudes above M = 6. We apply a suite of statistical tests to each synthetic realization in order to evaluate the ability of each test to identify the sequences of events as nonrandom. Our results show that detection ability is dependent on the quantity of data, the nature of the type of clustering, and the specific signal used in the statistical test. Data sets that exhibit a stronger variation in the seismicity rate are generally easier to identify as nonrandom for a given background rate. We also show that we can address this problem in a Bayesian framework, with the clustered data sets as prior distributions. Using this new Bayesian approach, we can place quantitative bounds on the range of possible clustering strengths that are consistent with the global earthquake data. At M = 7, we can estimate 99th percentile confidence bounds on the number of triggered events, with an upper bound of 20% of the catalog for global aftershock sequences, with a stronger upper bound on the fraction of triggered events of 10% for long‐term event clusters. At M = 8, the bounds are less strict due to the reduced number of events. However, our analysis shows that other types of clustering could be present in the data that we are unable to detect. Our results aid in the interpretation of the results of statistical tests on earthquake catalogs, both worldwide and regionally.

Daub, Eric G.↗