Engineering topics

Tsui, C. K. (ORCID:0000000273468312)

Publications and source records attributed to Tsui, C. K. (ORCID:0000000273468312).

9 records

DOE OSTI2024

Filamentary velocity scaling validation and spin dynamics in the DIII-D tokamak

Measured filament velocities in the DIII-D tokamak are compared against theoretical scalings, finding that the latter often represents an upper limit on experimental velocity distributions with most filaments possessing lower velocity. Filament spin from internal E × B drift is experimentally demonstrated to alter filament radial velocity. A critical spin velocity, where filament radial velocity peaks, is observed and corresponds to approximately 5 km/s. This transition is corroborated using a less direct measure of filament spin in the form of a temperature ratio. These techniques are combined to find that the critical spin velocity closely aligns with transport times along and across filaments becoming comparable. The normalized filament size distribution is consistent with the most stable size as dictated by Kelvin–Helmholtz and curvature-driven instabilities. Overall, the findings suggest filament stability and spin alter filamentary transport that may threaten the integrity of first walls in fusion devices.

70 PLASMA PHYSICS AND FUSION TECHNOLOGY↗

DOE OSTI2024

Comparison of detachment in Ohmic plasmas with positive and negative triangularity

Abstract In recent years, negative triangularity (NT) has emerged as a potential high-confinement L-mode reactor solution. In this work, detachment is investigated using core density ramps in lower single null Ohmic L-mode plasmas across a wide range of upper, lower, and average triangularity (the mean of upper and lower triangularity: δ ) in the TCV tokamak. It is universally found that detachment is more difficult to access for NT shaping. The outer divertor leg of discharges with δ ≈ − 0.3 could not be cooled to below 5 eV through core density ramps alone. The behavior of the upstream plasma and geometrical divertor effects (e.g. a reduced connection length with negative lower triangularity) do not fully explain the challenges in detaching NT plasmas. Langmuir probe measurements of the target heat flux widths ( λ q ) were constant to within 30% across an upper triangularity scan, while the spreading factor S was lower by up to 50% for NT, indicating a generally lower integral scrape-off layer width, λ int . The line-averaged core density was typically higher for NT discharges for a given fuelling rate, possibly linked to higher particle confinement in NT. Conversely, the divertor neutral pressure and integrated particle fluxes to the targets were typically lower for the same line-averaged density, indicating that NT configurations may be closer to the sheath-limited regime than their PT counterparts, which may explain why NT is more challenging to detach.

Physics↗

DOE OSTI2024

Divertor turbulent transport in the single null and snowflake in the TCV tokamak

The relative importance of divertor radial turbulent particle fluxes is considered by comparing it against the fluxes in the main-chamber outer midplane (OMP) in a variety of conditions and divertor geometries in the tokamak à configuration variable. Within the first power falloff length, the radial turbulent fluxes in the leg of the outer divertor are consistently found to be small, and about 1/5th the magnitude measured at the OMP. In a low-density single null divertor, magnetic shear is found to play a strong role in isolating the main-chamber turbulence from the divertor. The snowflake divertor is purported to have turbulence-enhancing properties in the volume between the two X-points but was instead found to further reduce the divertor turbulent fluxes compared to the single null. Depending on the collisionality, the electric field fluctuations and radial turbulent fluxes were higher near the X-point than at the outer midplane, which is likely due to the binormal compression of the flux bundles consistent with analytical models of the resistive X-point mode. Density and potential fluctuation amplitudes decrease monotonically with distance from the OMP with a slope that depends on collisionality.

Physics↗

DOE OSTI2023

Validation of 2D Te and ne measurements made with Helium imaging spectroscopy in the volume of the TCV divertor

Abstract Multi-spectral imaging of helium atomic emission (HeMSI) has been used to create 2D poloidal maps of T e and n e in TCV’s divertor. To achieve these measurements, TCV’s MANTIS multispectral cameras (Perek et al 2019 Rev. Sci. Instrum. 90 123514) simultaneously imaged four He I lines (two singlet and two triplet) and a He II line (468 nm) from passively present He and He + . The images, which were absolutely calibrated and covered the whole divertor region, were inverted through the assumption of toroidal symmetry to create emissivity profiles and, consequently, line-ratio profiles. A collisional-radiative model (CRM) was applied to the line-ratio profiles to produce 2D poloidal maps of T e and n e . The collisional-radiative modeling was accomplished with the Goto helium CRM code (Zholobenko et al 2018 Nucl. Fusion 58 126006, Zholobenko et al 2018 Technical Report , Goto 2003 J. Quant. Spectrosc. Radiat. Transfer 76 331–44) which accounts for electron-impact excitation (EIE) and deexcitation, and electron–ion recombination (EIR) with He + . The HeMSI T e and n e measurements were compared with co-local Thomson scattering measurements. The two sets of measurements exhibited good agreement for ionizing plasmas: ( 5 eV ⩽ T e ⩽ 60 eV , and 2 × 10 18 m − 3 ⩽ n e ⩽ 3 × 10 19 m − 3 ) in the case of majority helium plasmas, and ( 10 eV ⩽ T e ⩽ 40 eV , 2 × 10 18 m − 3 ⩽ n e ⩽ 3 × 10 19 m − 3 ) in the case of majority deuterium plasmas. However, there were instances where HeMSI measurements diverged from Thomson scattering. When T e ⩽ 10 eV in majority deuterium plasmas, HeMSI deduced inaccurately high values of T e . This disagreement cannot be rectified within the CRM’s EIE and EIR framework. Second, on sporadic occasions within the private flux region, HeMSI produced erroneously high measurements of n e . Multi-spectral imaging of Helium emission has been demonstrated to produce accurate 2D poloidal maps of T e and n e within the divertor of a tokamak for plasma conditions relevant to contemporary divertor studies.

70 PLASMA PHYSICS AND FUSION TECHNOLOGY↗

DOE OSTI2022

X-point and divertor filament dynamics from gas puff imaging on TCV

Abstract A new gas puff imaging diagnostic has been installed on the TCV tokamak, providing two-dimensional insights into scrape-off-layer (SOL) turbulence dynamics above, at and below the magnetic X-point. A detailed study in L-mode, attached, lower single-null discharges shows that statistical properties have little poloidal variations, while vast differences are present in the 2D behaviour of intermittent filaments. Strongly elongated filaments, just above the X-point and in the divertor far-SOL, show a good consistency in shape and dynamics with field-line tracing from filaments at the outboard midplane, highlighting their connection. In the near-SOL of the outer divertor leg, short-lived, high frequency and more circular (diameter ∼15 sound Larmor radii) filaments are observed. These divertor-localised filaments appear born radially at the position of maximum density and display a radially outward motion with velocity ≈400 m s −1 that is comparable to radial velocities of upstream-connected filaments. Conversely, in these discharges ( B → × ∇ B pointing away from the divertor), these divertor filaments’ poloidal velocities differ strongly from those of upstream-connected filaments. The importance of divertor-localised filaments upon radial transport and profile broadening is explored using filament statistics and in situ kinetic profile measurements along the divertor leg. This suggests that these filaments contribute significantly to electron density profile broadening in the divertor.

70 PLASMA PHYSICS AND FUSION TECHNOLOGY↗

DOE OSTI2022

New insights on divertor parallel flows,E × B drifts, and fluctuations from in situ, two-dimensional probe measurement in the Tokamak à Configuration Variable

Abstract In situ , two-dimensional (2D) Langmuir probe measurements across a large part of the TCV outer divertor are reported in L-mode discharges with and without divertor baffles. This provides detailed insights into time averaged profiles, particle fluxes, and fluctuation behavior in different divertor regimes. The presence of the baffles is shown to substantially increase the divertor neutral pressure for a given upstream density and to facilitate the access to detachment, an effect that increases with plasma current. The detailed, 2D probe measurements allow for a divertor particle balance, including ion flux contributions from parallel flows and E × B drifts. The poloidal flux contribution from the latter is often comparable or even larger than the former, and the divertor parallel flow direction reverses in some conditions, pointing away from the target. In most conditions, the integrated particle flux at the outer target can be predominantly ascribed to ionization along the outer divertor leg, consistent with a closed-box approximation of the divertor. The exception is a strongly detached divertor, achieved here only with baffles, where the total poloidal ion flux even decreases towards the outer target, indicative of significant plasma recombination. The most striking observation from relative density fluctuation measurements along the outer divertor leg is the transition from poloidally uniform fluctuation levels in attached conditions to fluctuations strongly peaking near the X-point when approaching detachment.

70 PLASMA PHYSICS AND FUSION TECHNOLOGY↗

DOE OSTI2022

Cross-field and parallel dynamics of SOL filaments in TCV

Using recently installed scrape-off layer diagnostics on the tokamak à configuration variable, we characterise the poloidal and parallel properties of turbulent filaments. We access both attached and detached divertor conditions across a wide range of core densities (f G ϵ [0.09, 0.66]) in diverted L-mode plasma configurations. With a gas puff imaging (GPI) diagnostic at the outer midplane we observed filaments with a monotonic increase in radial velocity (from 390 m s –1 to 800 m s –1 ) and cross-field radii (from 8.5 mm to 13.4 mm) with increasing core density. Interpreting the filament behaviour in the context of the two-region model, we find that they populate the ideal-interchange regime (C i ) in discharges at very low densities, and the resistive X (RX)-point regime for all other discharges. The scaling of filament velocity versus size shows good agreement with this interpretation. These results are discussed and compared with previous probe-based measurements for similar conditions, which mostly placed filaments in TCV in the resistive ballooning (RB) regime. In addition, for the first time in TCV, the parallel filament extension is studied by magnetically aligning the GPI measurements at the outboard midplane with a reciprocating probe in the divertor. In agreement with the filaments being in the ideal-interchange and the RX-point regimes, they are found to extend beyond the X-point into the outer divertor leg.

70 PLASMA PHYSICS AND FUSION TECHNOLOGY↗

DOE OSTI2022

Validation of edge turbulence codes against the TCV-X21 diverted L-mode reference case

Self-consistent full-size turbulent-transport simulations of the divertor and scrape-off-layer (SOL) of existing tokamaks have recently become feasible. This enables the direct comparison of turbulence simulations against experimental measurements. In this work, we perform a series of diverted ohmic L-mode discharges on the tokamak à configuration variable (TCV) tokamak, building a first-of-a-kind dataset for the validation of edge turbulence models. This dataset, referred to as TCV-X21, contains measurements from five diagnostic systems from the outboard midplane (OMP) to the divertor targets—giving a total of 45 one- and two-dimensional comparison observables in two toroidal magnetic field directions. The experimental dataset is used to validate three flux-driven 3D fluid-turbulence models—GBS, GRILLIX and TOKAM3X. With each model, we perform simulations of the TCV-X21 scenario, individually tuning the particle and power source rates to achieve a reasonable match of the upstream separatrix value of density and electron temperature. We find that the simulations match the experimental profiles for most observables at the OMP—both in terms of profile shape and absolute magnitude—while a comparatively poorer agreement is found towards the divertor targets. The match between simulation and experiment is seen to be sensitive to the value of the resistivity, the heat conductivities, the power injection rate and the choice of sheath boundary conditions. Additionally, despite targeting a sheath-limited regime, the discrepancy between simulations and experiment also suggests that the neutral dynamics should be included. The results of this validation show that turbulence models are able to perform simulations of existing devices and achieve reasonable agreement with experimental measurements. Where disagreement is found, the validation helps to identify how the models can be improved. By publicly releasing the experimental dataset and validation analysis, this work should help to guide and accelerate the development of predictive turbulence simulations of the edge and SOL.

70 PLASMA PHYSICS AND FUSION TECHNOLOGY↗

DOE OSTI2021

Theory-based scaling laws of near and far scrape-off layer widths in single-null L-mode discharges

Abstract Theory-based scaling laws of the near and far scrape-off layer (SOL) widths are analytically derived for L-mode diverted tokamak discharges by using a two-fluid model. The near SOL pressure and density decay lengths are obtained by leveraging a balance among the power source, perpendicular turbulent transport across the separatrix, and parallel losses at the vessel wall, while the far SOL pressure and density decay lengths are derived by using a model of intermittent transport mediated by filaments. The analytical estimates of the pressure decay length in the near SOL is then compared to the results of three-dimensional, flux-driven, global, two-fluid turbulence simulations of L-mode diverted tokamak plasmas, and validated against experimental measurements taken from an experimental multi-machine database of divertor heat flux profiles, showing in both cases a very good agreement. Analogously, the theoretical scaling law for the pressure decay length in the far SOL is compared to simulation results and to experimental measurements in TCV L-mode discharges, pointing out the need of a large multi-machine database for the far SOL decay lengths.

Physics↗