Search NASA⌕ Search

Engineering topics

Tumbleson, M.E.

Publications and source records attributed to Tumbleson, M.E..

Data for Coprocessing Corn Germ Meal for Oil Recovery and Ethanol Production, a Process Model for Lipid-Producing Energy Crops

Efforts to engineer high-productivity crops to accumulate oils in their vegetative tissue present the possibility of expanding biodiesel production. However, processing the new crops for lipid recovery and ethanol production from cell wall saccharides is challenging and expensive. In a previous study using corn germ meal as a model substrate, we reported that liquid hot water (LHW) pretreatment enriched the lipid concentration by 2.2 to 4.2 fold. This study investigated combining oil recovery with ethanol production by extracting oil following LHW and simultaneous saccharification and co-fermentation (SSCF) of the biomass. Corn germ meal was again used to model the oil-bearing energy crops. Pretreated germ meal hydrolysate or solids (160 °C and 180 °C for 10 minutes) were fermented, and lipids were extracted from both the spent fermentation whole broth and fermentation solids, which were recovered by centrifugation and convective drying. Lipid contents in spent fermentation solids increased 3.7 to 5.7 fold compared to the beginning germ meal. The highest lipid yield achieved after fermentation was 36.0 mg lipid g−1 raw biomass; the maximum relative amount of triacylglycerol (TAG) was 50.9% of extracted oil. Although the fermentation step increased the lipid concentration of the recovered solids, it did not improve the lipid yields of pretreated biomass and detrimentally affected oil compositions by increasing the relative concentrations of free fatty acids.

Conversion↗

Data from Ethanol Production from Corn Fiber Separated after Liquefaction in the Dry Grind Process

Conversion of corn fiber to ethanol in the dry grind process can increase ethanol yields, improve coproduct quality and contribute to process sustainability. This work investigates the use of two physio-chemical pretreatments on corn fiber and effect of cellulase enzyme dosage to improve ethanol yields. Fiber separated after liquefaction of corn was pretreated using (1) hot water pretreatment (160°C for 5, 10 or 20 min); and (2) wet disk milling and converted to ethanol. The conversion efficiencies of hot water pretreated fiber were higher than untreated fiber, with highest increase in conversion (10.4%) achieved for 5-minute residence time at 160 °C. Disk milling was not effective in increasing conversion compared to other treatments. Hydrolysis and fermentation of untreated fiber with excess cellulase enzymes resulted in 33.3% higher conversion compared to untreated fiber. Note: in “Table1_Treatments.csv”, NA = Not applicable.

Conversion↗

Data from Increasing Ethanol Yield through Fiber Conversion in Corn Dry Grind Process

Conversion of corn fiber to ethanol in the dry grind process could increase ethanol yields, reduce downstream processing costs and improve overall process profitability. This work investigates the in-situ conversion of corn fiber into ethanol (cellulase addition during simultaneous saccharification and fermentation) during dry grind process. Addition of 30 FPU/g fiber cellulase resulted in 4.6% increase in ethanol yield compared to the conventional process. Use of excess cellulase (120 FPU/g fiber) resulted in incomplete fermentation and lower ethanol yield compared to the conventional process. Multiple factors including high concentrations of ethanol and phenolic compounds were responsible for yeast stress and incomplete fermentation in excess cellulase experiments.

Conversion↗