Search NASA⌕ Search

Engineering topics

Tumer, O. T.

Publications and source records attributed to Tumer, O. T..

Compton telescope observations of gamma rays from SN 1987A

Results are reported of observations of a significant excess of gamma rays at energies of 1.0-2.5 MeV from the direction of SN 1987A, 418 days after detonation. Two features at 1.21 and 1.88 MeV are attributed to the 1.238 MeV and the combined 1.771, 2.015, and 2.035 MeV line emissions from the decay of Co-56 in the expanding ejecta with respective fluxes of (4.6 +/-1.4 +/-1.2) x 10 exp -4 and (3.5 +/-0.9 +/-0.9) x 10 exp -4 gamma/sq cm s, where the first error is statistical and the second systematic. The obtained energy resolution of 11 percent did not permit a definite separation of the 1.771-MeV line from the two other lines at 2.015 and 2.035 MeV that form the group at 1.88 MeV. The line fluxes were obtained after correcting for the north-south effect and the continuum.

Ait-Ouamer, Farid↗

The gamma ray north-south effect

Theoretical calculations are presented that explain the balloon observations by O'Neill et al. (1987) of a strong north-south anisotropy of atmospheric gamma rays over the Southern Hemisphere, and to predict the north-south ratios. It is shown that the gamma rays that originate at the longest distances from the telescopes give the largest north-south ratios. Comparisons are made of the experimental north-south ratios measured on balloons launched from Alice Springs, Australia, and from Palestine, Texas, U.S., and predictions are made for ratios at other geomagnetic latitudes and longitudes. It is pointed out that observers who measure backgrounds for celestial sources may be misled unless they correct for the north-south effect.

White, R. S.↗

The UCR gamma ray telescope data acquisition system

A description is given of an electronics system based on the DEC Falcon SBC-11/23+, which has been designed and built to support a balloon-borne double Compton gamma-ray telescope. The system provides support for commands, data acquisition, data routing and compression, and photomultiplier tube gain control. The software consists of a number of interrupt-driven routines of differing priorities to handle each system task. This includes two circular buffers for onboard processing and bit encoding before transmission of the information to the ground computer. Acquisition of gamma-ray events at rates above the 200-Hz telemetry constraint is easily achieved.

O'Neill, T. J.↗

Monte Carlo simulation of a new gamma ray telescope

A new Monte Carlo code has been written to simulate the response of the new University of California double scatter gamma ray telescope. This package of modular software routines, written in VAX FORTRAN 77 simulates the detection of 0.1 to 35 MeV gamma rays. The new telescope is flown from high altitude balloons to measure medium energy gamma radiation from astronomical sources. This paper presents (1) the basic physics methods in the code, and (2) the predicted response functions of the telescope. Gamma ray processes include Compton scattering, pair production and photoelectric absorption in plastic scintillator, NaI(Tl) and aluminum. Electron transport processes include ionization energy loss, multiple scattering, production of bremsstrahlung photons and positron annihilation.

Simone, J.↗

Gamma rays of 0.3-30 MeV from PSR0833 - 45

Pulsed gamma rays from the Vela pulsar PSR0833 - 45 are reported for the first time over the medium energy range 0.3-30 MeV. They were observed with a double scatter gamma-ray telescope flown on a balloon over Australia on Nov. 10, 1981, 31 days after a large glitch in the pulsar period. The first and second pulses were detected from single scatters in the top scintillators at energies over 0.3 MeV with statistical significances of 1.6 sigma each, and by double scatters from all detector cell pairs at energies of 1-30 MeV with significance of 4.8 sigma and 3.8 sigma. The phase separation of the two pulses is 0.43 + or - 0.02 at the same absolute phases previously found by SAS2 and COS B for energies over 35 MeV.

Tumer, O. T.↗

Gamma ray detection with long NaI/Tl/ scintillator bars

Test measurements with a prototype NaI(Tl) scintillator for energy, position, and timing measurements in gamma ray astronomy are reported. The scintillator bar is 100 x 5 x 5 cu cm in size, and allows detection of the arrival times and pulse heights of signals from two photomultiplier tubes, one at each end of the bar. Data is gathered on the energy loss, linear position, and time-of-flight of gamma ray interactions within the bar over an energy range of 0.5-20 MeV. A mean attenuation coefficient of 0.015/cm has been determined, as have a FWHM resolution of 5 cm, 9.4%, and 10 nsec at an energy of 0.662 MeV. At 1.25 MeV the timing resolution was 6 nsec, and at 6.13 MeV the spatial resolution was 2.2 cm. The instrument is a prototype of a Compton scatter telescope being constructed for two balloon flights, one each in the Northern and Southern Hemispheres, in 1984.

Zych, A. D.↗

Gamma rays from the Crab Pulsar 0531+21

Results are reported for observations of PSR 0531 + 21 performed with a gamma ray double Compton scatter telescope launched on a balloon. The operation of the telescope and the handling of the data are described. Phase diagrams for the pulsar and energy distributions for gamma rays from the primary and secondary pulses are shown and discussed. The results indicate that these observations are the first of gamma ray lines from neutrons captured on protons or iron in pulsars. Arguments supporting this interpretation are given.

Long, J. L.↗

High sensitivity high resolution double scatter 1-30 MeV gamma ray telescope

The design and performance of the double-scatter 1-30-MeV gamma-ray telescope developed at the University of California for balloon-borne observations are reported and illustrated with drawings, diagrams, and graphs. The telescope comprises an upper array of 16 6.03 x 6.03 x 100-cm plastic scintillator bars viewed by photomultiplier tubes (PMTs) at both ends, a lower array (at 100-cm distance) of 16 4.83 x 4.83 x 100-cm NaI(Tl) bars viewed at both ends by PMTs, and four 122 x 122 x 0.64-cm plastic sheets viewed by four PMTs each as charged-particle anticoincidence shielding. The operating principle of the telescope, the tests conducted on the NaI(Tl) bars, the on-board data-processing electronics, and the overall performance are characterized. Performance parameters include area 1 sq m, field of view pi sr, 4-sigma sensitivity above 1 MeV 0.00004 gamma/sq cm sec over 25 h, angular resolution about 3.5 deg FWHM, and energy resolution 10 percent at 1 MeV and 6 percent at 6 MeV.

Zych, A. D.↗