Engineering topics

Turnbull, J. F.

Publications and source records attributed to Turnbull, J. F..

4 records

NASA NTRS1983

Acceleration environment of payloads while being handled by the Shuttle Remote Manipulator System

Described in this paper is the method used in the Draper Remote Manipulator System (RMS) Simulation to compute linear accelerations at the point on the SPAS01 payload where its accelerometers are mounted. Simulated accelerometer output for representative on-orbit activities is presented. The objectives of post-flight analysis of SPAS01 data are discussed. Finally, the point is made that designers of acceleration-dependent payloads may have an interest in the capability of simulating the acceleration environment of payloads while under the control of the overall Payload Deployment and retrieval System (PDRS) that includes the Orbiter and its attitude control system as well as the Remote Manipulator Arm.

Turnbull, J. F.↗

NASA NTRS1974

Digital attitude control of the Skylab and Apollo/Soyuz orbital assemblies

The present work examines some extensions of the digital autopilot (DAP) capability as programmed in the Apollo Command and Service Module (CSM) onboard computer. Design activity undertaken for a thrust vector control DAP to control a proposed main engine deorbit burn of CSM while still docked to the Orbital Workshop is discussed. The design, implementation, and testing of a reaction control system DAP for the docked Skylab configuration are described along with its adaptation to control of the Apollo/Soyuz docked configuration.

Penchuk, A.↗

NASA NTRS1972

CSM docked DAP/orbital assembly bending interaction-axial case

A digital autopilot which can provide attitude control for the entire Skylab orbital assembly using the service module reaction control jets is described. An important consideration is the potential interaction of the control system with the bending modes of the orbital assembly. Two aspects of this potential interaction were considered. The first was the possibility that bending induced rotations feeding back through the attitude sensor into the control system could produce an instability or self-sustained oscillation. The second was whether the jet activity commanded by the control system could produce excessive loads at any of the critical load points of the orbital assembly. Both aspects were studied by using analytic techniques and by running simulations on the all-digital simulator.

Turnbull, J. F.↗

NASA NTRS1972

Digital autopilot for the SKYLAB orbital assembly.

In Project SKYLAB, the Command and Service Module which ferries astronaut crews to and from the Orbital Workshop is required to have the capability of providing attitude control for the entire Orbital Assembly during docked phases of the mission. A digital autopilot has been designed which meets this requirement. It is a direct descendant of the digital autopilot designed for and used extensively in project Apollo. There is a major difference however. For Apollo, it was reasonable to design an autopilot that treated the roll, pitch, and yaw axes independently. Because of the geometry of the Orbital Assembly, however, it is of considerable advantage to design the jet selection logic for SKYLAB such that the roll and pitch axes are treated as coupled, and also that the roll and yaw axes are treated as coupled. This paper discusses how inter-axis dependence has been incorporated in the Command and Service Module's digital autopilot while working within the limitations of the onboard computer.

Turnbull, J. F.↗