Thermoelectrics: From longitudinal to transverse
Thermoelectric power generation is a promising technology to realize a sustainable society because it directly converts thermal energy into electricity in a solid. Conventional thermoelectric generation is driven by the Seebeck effect, discovered by T.J. Seebeck in 1821, in which a charge current J c is generated in the direction parallel to a temperature gradient ∇T, the longitudinal geometry. Here, the ratio between the generated longitudinal electromotive force and applied ∇T is defined as the Seebeck coefficient. As shown in Figure 1A, a thermoelectric module based on the Seebeck effect typically consists of many pairs (128 for a 12V unit) of p-type and n-type conductors alternately arranged and connected in series. Since the Seebeck coefficient of a p-type (n-type) conductor is positive (negative), the thermopower in each element adds to the total output in the Seebeck module. This configuration is needed to achieve a practical voltage because each element only supplies millivolts but limits the use of thermoelectric generators. The efficiency of thermoelectric generators is characterized by the thermoelectric figure of merit, zT. Despite a 3-fold improvement in zT resulting from materials research over the last two decades, little progress has been made in their practical use; this is ascribed to the technological challenges in contact technology. The contacts on the hot side are subject to thermal degradation. All contacts (512 for a 12V unit) add electrical and thermal contact resistances that reduce the device efficiency to a fraction of that promised by the materials.