Search NASA⌕ Search

Engineering topics

Ueda, T.

Publications and source records attributed to Ueda, T..

Characterization of BNL and HPK AC-LGAD sensors with a 120 GeV proton beam

We present measurements of AC-LGADs performed at the Fermilab's test beam facility using 120 GeV protons. Here we studied the performance of various strip and pad AC-LGAD sensors that were produced by BNL and HPK. The measurements are performed with our upgraded test beam setup that utilizes a high precision telescope tracker, and a simultaneous readout of up to 7 channels per sensor, which allows detailed studies of signal sharing characteristics. These measurements allow us to assess the differences in designs between different manufacturers, and optimize them based on experimental performance. We then study several reconstruction algorithms to optimize position and time resolutions that utilize the signal sharing properties of each sensor. We present a world's first demonstration of silicon sensors in a test beam that simultaneously achieve better than 6–10 μm position and 30 ps time resolution. This represents a substantial improvement to the spatial resolution than would be obtained with binary readout of sensors with similar pitch.

47 OTHER INSTRUMENTATION↗

Flash Kα radiography of laser-driven solid sphere compression for fast ignition

Time-resolved compression of a laser-driven solid deuterated plastic sphere with a cone was measured with flash Kα x-ray radiography. A spherically converging shockwave launched by nanosecond GEKKO XII beams was used for compression while a flash of 4.51 keV Ti Kα x-ray backlighter was produced by a high-intensity, picosecond laser LFEX (Laser for Fast ignition EXperiment) near peak compression for radiography. Areal densities of the compressed core were inferred from two-dimensional backlit x-ray images recorded with a narrow-band spherical crystal imager. The maximum areal density in the experiment was estimated to be 87 ± 26 mg/cm{sup 2}. The temporal evolution of the experimental and simulated areal densities with a 2-D radiation-hydrodynamics code is in good agreement.

71 CLASSICAL AND QUANTUM MECHANICS, GENERAL PHYSIC↗

Gate frequency sweep: An effective method to evaluate the dynamic performance of AlGaN/GaN power heterojunction field effect transistors

With this paper we propose a test method for evaluating the dynamic performance of GaN-based transistors, namely, gate-frequency sweep measurements: the effectiveness of the method is verified by characterizing the dynamic performance of Gate Injection Transistors. We demonstrate that this method can provide an effective description of the impact of traps on the transient performance of Heterojunction Field Effect Transistors, and information on the properties (activation energy and cross section) of the related defects. Moreover, we discuss the relation between the results obtained by gate-frequency sweep measurements and those collected by conventional drain current transients and double pulse characterization.

75 CONDENSED MATTER PHYSICS, SUPERCONDUCTIVITY AND↗

Doublet-point method for supersonic unsteady lifting surfaces

A method to predict unsteady aerodynamic forces on lifting surfaces in supersonic flow is presented. The wing is divided into small segments in which the lift force is expressed by a single-point doublet of the acceleration potential. This is the same concept as the doublet-point method developed by the authors for subsonic flows. In order to avoid sensitiveness to the Mach number, the upwash due to the point doublet is calculated by averaging over small areas. The integration is done analyticaly so that it requires no numerical quadrature. Pressure distributions are directly obtained as the unknowns of the algebraic equation. The results are compared with those obtained by other methods for various wing geometries, including the AGARD wing-tail configuration.

Ueda, T.↗

Transient decay times and mean values of unsteady oscillations in transonic flow

Kerlick and Nixon (1981) point out that if the time-marching solution is stopped before the transient is complete and the steady state is reached, then the incorrect conclusion may be reached that a change in the mean lift has occurred in response to the oscillating motion of the airfoil when in fact no such change has occurred. For a narrow Mach number range, however, the time for the transient to decay and for a steady state to be reached is extraordinarily long. What is more, for a very narrow range of Mach numbers, a nonzero mean value of lift can occur for an airfoil of symmetrical profile oscillations about a zero angle of attack. The reason why this nonzero average lift occurs only over a narrow range of Mach numbers has so far not been obtained.

Dowell, E. H.↗

Expansion series of integral functions occurring in unsteady aerodynamics

Attention is given to two real integral functions which occur in the kernel of singular integral equations for subsonic unsteady lifting surfaces. The arguments k, r, and X of the functions correspond to the reduced frequency, spanwise distance, and modified coordinate in the flow direction, respectively. The value of the parameter nu in the functions depends on geometrical conditions. The considered investigation has the objective to present a series for general values of the nonnegative integer nu in order to compute efficiently the integral functions. The approach makes it possible to avoid any approximation or numerical quadrature.

Ueda, T.↗

A new solution method for lifting surfaces in subsonic flow

A simple method for calculating the unsteady aerodynamic loadings on harmonically oscillating thin wings in subsonic flow has been developed. The method is based on a concept of concentrated lift forces. The wing is divided into the element surfaces on which lift distributions are represented by single concentrated lift forces. Since the procedure does not include any quadratures, it can be applied easily to calculate the unsteady aerodynamic loadings on complex planform wings even when they have partial span control surfaces. Numerical calculations are carried out for various wing geometries and compared with other analyses and experiments.

Ueda, T.↗