Uren, Michael J. | Search NASA

DOE OSTI2022

Edge termination in vertical GaN diodes: Electric field distribution probed by second harmonic generation

We characterized the electric field distribution of GaN-on-GaN p–n diodes with partially compensated ion-implanted edge termination (ET) using an electric field induced second harmonic generation technique (EFISHG). The distributed electric field from the anode to the outer edge of the ET demonstrates the effectiveness of the ET structure. However, EFISHG also shows that its effectiveness is strongly dependent on the acceptor charge distribution in the ET's partially compensated layer (PC). A generally lower amount of acceptor charge can be inferred from the measured electric field distribution resulting from excessive ion implantation energy or dose during ET fabrication and causing lower than optimal breakdown voltage. Localized field crowding can be observed when the remaining acceptors uncompensated by the implant in the PC layer are nonuniformly distributed around the periphery of the devices. Important information can be obtained from these direct electric field measurements and used for optimizing the device design and fabrication process.

Cao, Yuke↗

DOE OSTI2021

Electrical and Thermal Performance of Ga₂O₃–Al₂O₃–Diamond Super-Junction Schottky Barrier Diodes

The design space of Ga 2 O 3 -based devices is severely constrained due to its low thermal conductivity and absence of viable p-type dopants. In this work, we discuss the limits of operation of a novel Ga 2 O 3 –Al 2 O 3 –diamond-based super-junction device concept, which can alleviate the constraints associated with Ga 2 O 3 -based devices. The improvements achieved using the proposed device concept are demonstrated through electrical and thermal simulations of Ga 2 O 3 –Al 2 O 3 –diamond-based super-junction Schottky barrier diodes (SJ-SBDs) and non-punch-through or conventional Schottky barrier diodes (NP-SBDs). The SJ-SBD enables operation below the R ON -breakdown voltage limit of Ga 2 O 3 NP-SBD, enabling >4 kV blocking voltage at R ON of 1–3 mΩ cm 2 . Here, the maximum switching frequency of SJ-SBD may be only a few kHz, as it is limited by the activation energy of acceptors (0.39 eV) in the diamond. Crucially, compared with NP-SBD, the use of diamond also results in ~60% reduction in temperature rise during static power dissipation. Polycrystalline diamond (PCD) properties depend on detailed microstructure and benefits compared to ideal Ga 2 O 3</sub NP-SBD arise for diamond critical fields ≥6 MV/cm and thermal conductivities as low as 50–150 W/(m • K).

36 MATERIALS SCIENCE↗