Search NASA⌕ Search

Engineering topics

Ustroev, G I

Publications and source records attributed to Ustroev, G I.

Formation of hot spots in the plasma of a Z-pinch produced from low-density deuterated polyethylene

Results are presented from experimental studies of the plasma formation dynamics in a Z-pinch produced from a cylindrical microporous agar-agar load. The experiments were performed on the S-300 facility at a current of 2 MA and current rise time of 100 ns. To enhance the energy concentration, a deuterated polyethylene neck with a mass density of 50-75 {mu}g/cm{sup 3} and diameter of 1-2 mm was made in the central part of the load. The spatiotemporal characteristics of the Z-pinch were studied using an optical streak camera and fast frame photography in the optical and soft X-ray spectral ranges. X-ray emission was detected using semiconductor and vacuum diodes, and neutron emission was studied by means of the time-of-flight method. It is found that, in the course of continuous plasma production, hot spots with a diameter of 100 {mu}m form in the pinch plasma. The hot spots emit short soft X-ray pulses with a duration of 2-4 ns, as well as neutron pulses with an average neutron energy of about 2.45 MeV. The maximum neutron yield was found to be 4.5 x 10{sup 9} neutrons per shot. The scenario of hot spot formation is adequately described by two-dimensional MHD simulations.

70 PLASMA PHYSICS AND FUSION TECHNOLOGY↗

X-pinch-based neutron source

Results are presented from experimental studies of the parameters of an X-pinch-based neutron source made of 70- to 80-{mu}m-diameter deuterated polyethylene fibers. At currents of up to 1.7 MA and a current rise time of {approx}150 ns, hot plasma spots were observed in the fiber crossing region. The formation of hot spots was accompanied by the generation of short soft X-ray pulses with a duration of 2-4 ns, as well as by neutron emission. The neutron energy was measured using the time-of-flight technique in four directions, at 0{sup o}, 90{sup o}, 180{sup o}, and 270{sup o} with respect to the load axis. The mean energy of the neutrons emitted along the axis towards the anode and cathode was found to be 2.0 {+-} 0.2 and 2.6 {+-} 0.1 MeV, respectively, and that of neutrons emitted in two opposite directions along the radius, 2.5 {+-} 0.1 and 2.4 {+-} 0.1 MeV. The maximum neutron yield at a current amplitude of 1.6 MA was of 10{sup 10} neutrons per shot.

70 PLASMA PHYSICS AND FUSION TECHNOLOGY↗

Studies of plasma dynamics in megampere X-pinches

Results are presented from experimental studies of the dynamics and parameters of the plasma generated by megampere (up to 2.3 MA) currents flowing through X-pinches formed from crossed wires made of various materials. The experiments were performed with different numbers of wires and different wire diameters. The X-ray yield in neon-like molybdenum lines (in the 2.5- to 3-keV photon energy range) from a <20 {mu}m hot spot was larger than 10 J, and the soft X-ray power emitted from this spot reached 120 GW. The hot-spot lifetime estimated by comparing the measured and calculated emission intensities and line profiles of helium-like Fe and Cr ions was {approx}10 ps. Hard X-ray emission in the photon energy range {>=}800 keV was also detected.

70 PLASMA PHYSICS AND FUSION TECHNOLOGY↗

Deuteron Acceleration and Fusion Neutron Production in Z-pinch plasmas

Fusion neutron measurements were carried out on the S-300 generator (Kurchatov Institute, Moscow). We tried deuterated fibers, various types of wire arrays imploding onto a deuterated fiber, and deuterium gas puffs as Z-pinch loads. On the current level of 2 MA, the peak neutron yield of 10{sup 10} was achieved with a deuterium gas-puff. The neutron and deuteron energy spectra were quite similar in various types of Z-pinch configurations. The broad width of radial neutron spectra implied a high radial component of deuteron velocity. On the basis of neutron measurements, we concluded that neutron production mechanism is connected with the study of plasma voltage. It means that the acceleration of fast deuterons is not a secondary process but it reflects the global dynamics of Z-pinch plasmas. For this reason it is useful to add deuterium as a 'tracer' in Z-pinch loads more often. For instance, it seems attractive to prepare wire-arrays from deuterated metal wires such as Pd.

70 PLASMA PHYSICS AND FUSION TECHNOLOGY↗