Engineering topics

Valarezo, Walter O.

Publications and source records attributed to Valarezo, Walter O..

6 records

NASA NTRS1993

Multielement airfoil performance due to Reynolds and Mach number variations

Experimental studies have been conducted to assess Reynolds and Mach number effects on a supercritical multielement airfoil. The airfoil is representative of the stall-critical station of an advanced transport wing design. The experimental work was conducted as part of a cooperative program between the Douglas Aircraft Company and the NASA Langley Research Center to improve current knowledge of high-lift flows and to develop a validation data base with practical geometries/conditions for emerging computational methods. This article describes results obtained for both landing and takeoff multielement airfoils (four- and three-element configurations) for a variety of Mach/Reynolds number combinations up to flight conditions. Effects on maximum lift are considered for the landing configurations, and effects on both lift and drag are reported for the takeoff geometry. The present test results revealed considerable maximum lift effects on the three-element landing configuration for Reynolds number variations, and significant Mach number effects on the four-element airfoil.

Valarezo, Walter O.↗

NASA NTRS1993

Surface hot-film method for the measurement of transition, separation and reattachment points

A real-time method of determining positions of laminar-to-turbulent transition region, separation and reattachment points and stagnation points using an array of simultaneously operated surface-mounted hot-film sensors has been developed and applied to a wind-tunnel test of a multielement airfoil model. Determination of various types of transitions and flow directions in various regimes of flows seen on multielement airfoils are possible without precise sensor calibration or laborious post-test data analysis. The results agree with established method and theoretical methods, but determination of turbulent reattachment points are not yet satisfactory.

Nakayama, Akihiko↗

NASA NTRS1992

Separation control on high Reynolds number multi-element airfoils

Small surface-mounted vortex generators were investigated as means for the control of a boundary-layer separation on a 2D single-flap three-element high-lift system at near-flight Reynolds numbers and in landing configurations. Wind-tunnel results obtained for small vane-type vortex generators mounted on a multielement airfoil showed that vortex generators as small as 0.18 percent of total chord can effectively reduce or eliminate boundary-layer separation on the flap at approach conditions. It was found that both the outerrotating and the corotating streamwise vortices were effective in reducing flow separation.

Lin, John C.↗

NASA NTRS1992

Reynolds and Mach number effects on multielement airfoils

Experimental studies were conducted to assess Reynolds and Mach number effects on a supercritical multielement airfoil. The airfoil is representative of the stall-critical station of an advanced transport wing design. The experimental work was conducted as part of a cooperative program between the Douglas Aircraft Company and the NASA LaRC to improve current knowledge of high-lift flows and to develop a validation database with practical geometries/conditions for emerging computational methods. This paper describes results obtained for both landing and takeoff multielement airfoils (four and three-element configurations) for a variety of Mach/Reynolds number combinations up to flight conditions. Effects on maximum lift are considered for the landing configurations and effects on both lift and drag are reported for the takeoff geometry. The present test results revealed considerable maximum lift effects on the three-element landing configuration for Reynolds number variations and significant Mach number effects on the four-element airfoil.

Valarezo, Walter O.↗

NASA NTRS1991

The adverse aerodynamic impact of very small leading-edge ice (roughness) buildups on wings and tails

Systematic experimental studies were performed to establish the aerodynamic impact of very small leading-edge simulated ice (roughness) formations on lifting surfaces. The geometries studied include single element configurations (airfoil and 3-D tail) as well as multi-element high-lift airfoil geometries. Emphasis in these studies was placed on obtaining results at high Reynolds numbers to insure the applicability of the findings to full-scale situations. It was found that the well-known Brumby correlation for the adverse lift impact of discrete roughness elements at the leading edge is not appropriate for cases representative of initial ice build up (i.e., distributed roughness). It was also found that allowing initial ice formations of a size required for removal by presently proposed deicing systems could lead to maximum lift losses of approximately 40 percent for single-element airfoils. Losses in angle-of-attack margin to stall are equally substantial - as high as 6 degrees. Percentage losses for multi-element airfoils are not as severe as for single-element configurations, but degradations of the angle-of-attack-to-stall margin are the same for both.

Lynch, Frank T.↗

NASA NTRS1991

Multi-element airfoil optimization for maximum lift at high Reynolds numbers

An experimental study has been performed to assess the maximum lift capability of a supercritical multielement airfoil representative of an advanced transport aircraft wing. The airfoil model was designed with a leading-edge slat and single or two-segment trailing-edge flaps. Optimization work was performed at various slat/flap deflections as well as gap/overhang positions. Landing configurations and the attainment of maximum lift coefficients of 4.5 with single-element flaps and 5.0 with two-segment flaps was emphasized. Test results showed a relatively linear variation of the optimum gap/overhang positioning of the slat versus slat deflection, considerable differences in optimum rigging between single and double segment flaps, and large Reynolds number effects on multielement airfoil optimization.

Valarezo, Walter O.↗