Engineering topics

Vanlandingham, H. F.

Publications and source records attributed to Vanlandingham, H. F..

11 records

NASA NTRS1983

Study of an automatic trajectory following control system

It is shown that the estimator part of the Modified Partitioned Adaptive Controller, (MPAC) developed for nonlinear aircraft dynamics of a small jet transport can adapt to sensor failures. In addition, an investigation is made into the potential usefulness of the configuration detection technique used in the MPAC and the failure detection filter is developed that determines how a noise plant output is associated with a line or plane characteristic of a failure. It is shown by computer simulation that the estimator part and the configuration detection part of the MPAC can readily adapt to actuator and sensor failures and that the failure detection filter technique cannot detect actuator or sensor failures accurately for this type of system because of the plant modeling errors. In addition, it is shown that the decision technique, developed for the failure detection filter, can accurately determine that the plant output is related to the characteristic line or plane in the presence of sensor noise.

Vanlandingham, H. F.↗

NASA NTRS1980

Applications of adaptive state estimation theory

Two main areas of application of adaptive state estimation theory are presented. Following a review of the basic estimation approach, its application to both the control of nonlinear plants and to the problem of tracking maneuvering targets is presented. Results are brought together from these two areas of investigation to provide insight into the wide range of possible applications of the general estimation method.

Moose, R. L.↗

NASA NTRS1979

Aircraft adaptive learning control

The optimal control theory of stochastic linear systems is discussed in terms of the advantages of distributed-control systems, and the control of randomly-sampled systems. An optimal solution to longitudinal control is derived and applied to the F-8 DFBW aircraft. A randomly-sampled linear process model with additive process and noise is developed.

Lee, P. S. T.↗

NASA NTRS1979

A procedure for optimal control of flexible surface vibrations

The vibration controller design for a thin flexible surface with a given boundary is formulated as an unconstrained optimization problem. It is shown that this formulation is equivalent to a system of uncoupled optimization problems each of which is a linear regulator design problem for a second-order modal system. The regulator solutions give the gains on the modal amplitude and velocity associated with each modal system. For the constrained control case corresponding to a finite number of actuators, an approximation to the optimal distributed control is given. For the case of a limited number of physical sensors, a dual approach yields a system of second-order observers or filters. Simulations indicate that the constrained controller has a satisfactory performance as long as the number of actuators is more than half the number of controlled modes.

Caglayan, A. K.↗

NASA NTRS1978

Digital set point control of nonlinear stochastic systems

A technique for digital control of nonlinear stochastic plants is presented. The development achieves a practical digital algorithm with which the closed-loop system behaves in a classical Type I manner even with gross nonlinearities in the plant structure and low signal-to-noise power ratios. The design procedure is explained in detail and illustrated by an example whose simulated responses testify to the practicality of the approach.

Moose, R. L.↗

NASA NTRS1978

Simulation of distributed microprocessor-based flight control systems

The aim of the present paper is to demonstrate, within the framework of a digital flight control system, the method of simulating the information exchange between a microcomputer and a supervisory computer, and between microcomputers working on separate control tasks. A gradient technique is described that considers the trade-off between the objectives of the control system and the information exchange requirements.

Lee, P. S.↗

NASA NTRS1977

Digital flight control systems

The design of stable feedback control laws for sampled-data systems with variable rate sampling was investigated. These types of sampled-data systems arise naturally in digital flight control systems which use digital actuators where it is desirable to decrease the number of control computer output commands in order to save wear and tear of the associated equipment. The design of aircraft control systems which are optimally tolerant of sensor and actuator failures was also studied. Detection of the failed sensor or actuator must be resolved and if the estimate of the state is used in the control law, then it is also desirable to have an estimator which will give the optimal state estimate even under the failed conditions.

Caglayan, A. K.↗

NASA NTRS1977

Control of nonlinear stochastic systems using adaptive estimation

A general procedure for the design of a digital controller for nonlinear stochastic systems is presented; the emphasis is on development of partitioned-adaptive control techniques which provide rapid tracking of the system state vector to follow rapid trajectory variations. Tests involving the control of a low-order nonlinear oscillator suggest that the procedure yields an effective method for achieving closed-loop performance, despite the difficulty of the control problem

Vanlandingham, H. F.↗

NASA NTRS1977

Set-point control of nonlinear systems

A method of nonlinear stochastic control is applied to the problem of providing set-point control. The procedure is illustrated for a nonlinear second-order plant. The controller design uses a variation of the 'multiple-model adaptive control' approach. Specific problems related to the design are investigated, including learning time and set-point accuracy dependence on the number of approximating models, chord versus tangent approximations, and the a priori Markov switching parameter values. Simulations are provided for different situations under various levels of measurement noise.

Vanlandingham, H. F.↗

NASA NTRS1976

Control of spinning flexible spacecraft by modal synthesis

A procedure is presented for the active control of a spinning flexible spacecraft. Such a system exhibits gyroscopic effects. The design of the controller is based on modal decomposition of the gyroscopic system. This modal decoupling procedure leads to a control mechanism implemented in modular form, which represents a distinct computational advantage over the control of the coupled system. Design procedures are demonstrated for two types of control algorithms, linear and nonlinear. The first represents classical linear feedback approach, and the second represents an application of on-off control, both types made feasible by the modal decomposition scheme.

Meirovitch, L.↗

NASA NTRS1975

Parameter adaptive estimation of random processes

This paper is concerned with the parameter adaptive least squares estimation of random processes. The main result is a general representation theorem for the conditional expectation of a random variable on a product probability space. Using this theorem along with the general likelihood ratio expression, the least squares estimate of the process is found in terms of the parameter conditioned estimates. The stochastic differential for the a posteriori probability and the stochastic differential equation for the a posteriori density are found by using simple stochastic calculus on the representations obtained. The results are specialized to the case when the parameter has a discrete distribution. The results can be used to construct an implementable recursive estimator for certain types of nonlinear filtering problems. This is illustrated by some simple examples.

Caglayan, A. K.↗