Validated modeling of atmospheric-pressure anodic arc
Explore the source record for details and available documents.
Engineering topics
Publications and source records attributed to Vekselman, V.
Explore the source record for details and available documents.
We discuss a novel diagnostic allowing direct measurements of the local electric field in the edge region in NSTX/NSTX-U. This laser based diagnostic's principle consists of depleting the naturally populated $n=3$ level to a Rydberg state --sensitive to electric fields-- that will result in a suppression of part of the $D_{\alpha}$ emission. We refer to this approach as Laser-Induced Rydberg Spectroscopy (LIRyS). It is shown that the local electric field can be measured through the Stark induced resonances observed as dips in the $D_\alpha$ emission. Using forward-modeling of simulated absorption spectra, we show precisions reaching \SI{\pm 2}{\kilo\volt\per\meter} in regions with a local electric field of \SI{15}{\kilo\volt\per\meter}.
Delineating the dominant processes responsible for nanomaterial synthesis in a plasmaenvironment requires measurements of the precursor species contributing to the growth ofnanostructures. We performed comprehensive measurements of spatial and temporal profiles ofcarbon dimers in sub-atmospheric-pressure carbon arc by laser-induced fluorescence.Measured spatial profiles of carbon dimers coincide with the growth region of carbon nanotubes (Fang et al2016 Carbon 107 273-80) and vary depending on the arc operation mode, which is determinedby the discharge current and the ablation rate of the graphite anode. The carbon dimer density profileexhibits large spatial and time variations due to motion of the arc core. A comparison of theexperimental data with the 2D simulation results of self-consistent arc modeling shows a goodagreement. The model predicts well the main processes determining spatial profiles of carbondimers.
Time- and space-resolved fast framing photography was employed to study the discharge initiated by runaway electrons in air and He gas at atmospheric pressure. Whereas in the both cases, the discharge occurs in a nanosecond time scale and its front propagates with a similar velocity along the cathode-anode gap, the later stages of the discharge differ significantly. In air, the main discharge channels develop and remain in the locations with the strongest field enhancement. In He gas, the first, diode 'gap bridging' stage, is similar to that obtained in air; however, the development of the discharge that follows is dictated by an explosive electron emission from micro-protrusions on the edge of the cathode. These results allow us to draw conclusions regarding the different conductivity of the plasma produced in He and air discharges.
A comparison between the results of x-ray absorption spectroscopy of runaway electrons (RAEs) generated during nanosecond timescale high-voltage (HV) gas discharge and the simulated attenuation of the x-ray flux produced by the runaway electron spectrum calculated using particle-in-cell numerical modeling of such a type of discharge is presented. The particle-in-cell simulation considered the field and explosive emissions (EEs) of the electrons from the cathode. It is shown that the field emission is the dominant emission mechanism for the short-duration (<2.5 ns) high-voltage pulses, while for the long-duration (>5 ns) high-voltage pulses, the explosive emission is likely to play a significant role.
The results of a numerical simulation of the generation of runaway electrons in pressurized nitrogen and helium gases are presented. It was shown that runaway electrons generation occurs in two stages. In the first stage, runaway electrons are composed of the electrons emitted by the cathode and produced in gas ionization in the vicinity of the cathode. This stage is terminated with the formation of the virtual cathode, which becomes the primary source of runaway electrons in the second stage. Also, it was shown that runaway electrons current is limited by both the shielding of the field emission by the space charge of the emitted electrons and the formation of a virtual cathode. In addition, the influence of the initial conditions, such as voltage rise time and amplitude, gas pressure, and the type of gas, on the processes that accompany runaway electrons generation is presented.
The phenomenon of ultra-fast electrical gas breakdown was investigated. Nanosecond high-voltage pulses with durations of 1 and 5 ns and amplitudes of 100 and 200 kV, respectively, were used to study the parameters of the discharge in a pressured (1-7) x 10{sup 5} Pa air-filled gap. The development of the discharge and the plasma propagation velocity was examined using optical fast frame imaging. The generation of runaway electrons in the breakdown process was confirmed by electron imaging and time-resolved x-ray diagnostics. Runaway electron beam energy distribution was obtained for a 1 ns duration high-voltage pulse. The origin and the role of runaway electrons in the discharge initiation are also discussed.
The operation of a ferroelectric plasma source-assisted hollow anode (HA) electron source in a vacuum diode powered by an {approx}200 kV and {approx}400 ns pulsed generator was studied using time- and space-resolved laser induced fluorescence diagnostics. It was found that the plasma ion ''temperature'' in the vicinity of the HA output grid increases up to {approx}15 eV during the accelerating pulse, which is consistent with a model of the potential screening of the grid by the randomly moving ions [Phys. Plasmas 13, 073506 (2006)]. Also it was shown that the increase in the HA plasma potential up to several kilovolts because of the appearance of a noncompensated ion charge in the HA bulk plasma due to electrons fast extraction, leads to explosive emission centers being generated at the HA grid and to nonuniformity in the cross-sectional electron beam current density. Finally, the plasma prefilled mode of diode operation was studied using a simple one-dimensional model of the plasma erosion and the HA plasma electron heating by energetic ions was considered.
Parameters of the plasma produced by a ferroelectric plasma source (FPS) assisted high-current ({approx}1 kA), hollow anode (HA), low-pressure (10{sup -4} Torr) Ar gas discharge were studied using a time- and space-resolved laser induced fluorescence (LIF) diagnostic technique. It was shown that the plasma filling of the HA cavity occurs due to the expansion of the plasma flows generated by the FPSs with a gradual time-dependent increase in the plasma density along the length of the HA cavity. These data were verified by the results of one-dimensional modeling of the plasma expansion in vacuum and time-dependent collisional-radiative modeling. Also, LIF diagnostics, which was tested on the saturation effect both experimentally and numerically, showed that the plasma ion temperature gradually increases during the discharge reaching {approx}9 eV at its end. Various phenomena (plasma kinetic instabilities, charge-exchange processes during the plasma ion interaction with the HA walls, and the model of neutral atoms ionization inside the Debay's sphere), which could be responsible for such ion temperature, were considered.
There is a continuous interest in research of electron sources which can be used for generation of uniform electron beams produced at E{<=}10{sup 5} V/cm and duration {<=}10{sup -5} s. In this review, several types of plasma electron sources will be considered, namely, passive (metal ceramic, velvet and carbon fiber with and without CsI coating, and multicapillary and multislot cathodes) and active (ferroelectric and hollow anodes) plasma sources. The operation of passive sources is governed by the formation of flashover plasma whose parameters depend on the amplitude and rise time of the accelerating electric field. In the case of ferroelectric and hollow-anode plasma sources the plasma parameters are controlled by the driving pulse and discharge current, respectively. Using different time- and space-resolved electrical, optical, spectroscopical, Thomson scattering and x-ray diagnostics, the parameters of the plasma and generated electron beam were characterized.