Engineering topics

Velkoff, H. R.

Publications and source records attributed to Velkoff, H. R..

4 records

NASA NTRS1987

Free-wake analysis of a rotor in hover

A numerical method based on the axisymmetric, incompressible Navier-Stokes equations is combined with a lifting surface code to predict the vortex wake of hovering rotors. The lifting surface code, AMI Hover, is used to obtain the circulation distribution on the blade. This circulation distribution is fed into the Navier-Stokes code to compute the vortex wake under this specified circulation distribution. An iteration approach is used between these two codes to converge the circulation distribution and the shape of the vortex wake. A relaxation scheme is developed to resolve the instability encountered among the tip vortices. A reconcentration scheme is used to solve the diffusion problem due to the strong artificial viscosity. The results from the present method are compared with experimental data obtained by smoke-flow visualization and hot-wire measurements for several rotor blade configurations. The comparisons show that the present method is able to predict the complex wake system shed by a hovering rotor.

Chen, C. S.↗

NASA NTRS1982

Effect of tip vanes on the performance and flow field of a rotor in hover

Tests run with a single bladed model rotor with a vane located at the tip of the blade indicated significantly increased performance under certain test conditions. Data reveal that a figure of merit increase of over one third occurred in hover. Flow visualization using smoke revealed that a pair of vortices sprung from the blade tip and the vane tip. The vane tip vortex tended to roll up and over the primary vortex. The vortices in the wake became much less well defined with the tip vane configurations.

Velkoff, H. R.↗

NASA NTRS1981

Hover tests of a model H-force rotor

The potential of using tip vanes at the ends of helicopter rotor blades to obtain a controllable H-force is considered. The addition of vanes placed perpendicular to the blade tips can be used to obtain an inplane force. By varying the angle of the vanes, a radial force can be created which can be controllable in azimuth position. Such a force could be used to provide translational motion of the rotor and aircraft without the requirement for rotor tilting. In addition, an H-force generated at high flight speed could be used as a propulsive force in a matter similar to a propeller. The force generated by the vanes could also affect the aircraft's stability characteristics. The H-force could also modify rotor performance in hovering since they could be thought to act as a virtual shroud. Tests were run with a model rotor which has a 6 foot diameter with a 3 inch chord blade. Test data are presented on the effects of various tip-vane configurations on the hovering figure of merit. The extreme sensitivity of the performance to vane arrangement is shown.

Velkoff, H. R.↗

NASA NTRS1975

Study of fluid flow by charged particles

Analytical and experimental effort explores possibility of using charged particles as diagnostic tool in study of fluid flows. Test program involved right circular cylinder and airfoil located in large wind tunnel; ions were injected into flow and resulting currents at surfaces were monitored.

Deluca, M.↗