Engineering topics

Venkateswarlu, P.

Publications and source records attributed to Venkateswarlu, P..

11 records

NASA NTRS1997

Third Order Optical Nonlinearity of Colloidal Metal Nanoclusters Formed by MeV Ion Implantation

We report the results of characterization of nonlinear refractive index of the composite material produced by MeV Ag ion implantation of LiNbO(sub 3) crystal (z-cut). The material after implantation exhibited a linear optical absorption spectrum with the surface plasmon peak near 430 nm attributed to the colloidal silver nanoclusters. Heat treatment of the material at 500 deg C caused a shift of the absorption peak to 550 nm. The nonlinear refractive index of the sample after heat treatment was measured in the region of the absorption peak with the Z-scan technique using a tunable picosecond laser source (4.5 ps pulse width).The experimental data were compared against the reference sample made of MeV Cu implanted silica with the absorption peak in the same region. The nonlinear index of the Ag implanted LiNbO(sub 3) sample produced at five times less fluence is on average two times greater than that of the reference.

Sarkisov, S. S.↗

NASA NTRS1994

Continuous-Wave Laser Beam Fanning in Organic Solutions: A Novel Phenomenon

If a low-power cw Ar(+) laser beam (approx. 50 mW) is sent horizontally and focused on the entrance side of a cuvette containing an absorptive solution, the beam fans into the lower half of the cuvette instead of propagating through and forming self-phase-modulation fringes. We call this phenomenon self-beam fanning, which has been observed in several organic solutions. We present here several experimental results and a descriptive model of the phenomenon.

Abdeldayem, Hossin↗

NASA NTRS1994

Development of infrared sensors using energy transfer/energy upconversion processes: Study of laser excited fluorescence in rare Earth ion doped crystals

A summary is presented of the spectroscopic study of three systems: LaF3:Ho(3+), LaF3:Er(3+) and CaF2:Nd(3+). When the D levels of Ho(3+) in LaF3 were resonantly excited with a laser beam of 640 nm, upconverted emissions were detected from J (416 nm), F (485 nm), and E (546 nm) levels. Energy upconverted emissions were also observed from F and E levels of Ho(3+) when the material was excited with an 800 nm near infrared laser. When the D levels of Er(3+) in LaF3 were resonantly excited with a laser beam of 637 nm, upconverted emissions were detected from the E (540 nm) and P (320, 400, and 468 nm) levels. Energy upconverted emissions were also observed from F, E, and D levels of Er(3+) when the material was resonantly excited with an 804 nm near infrared laser. When the D levels of Nd(3+) in CaF2 were resonantly excited with a laser beam of 577 nm, upconverted emissions were detected from the L (360 and 382 nm), K (418 nm), and I (432 nm) levels. Very weak upconverted emissions were detected when this system was irradiated with a near infrared laser. The numbers in parentheses are the wavelengths of the emissions.

Nash-Stevenson, S. K.↗

NASA NTRS1993

Nonlinear optical parameters of 7-prime,7-prime-dicyano-7-prime-apo-beta-carotene in hexane by self-action techniques

Quantitative measurements of the nonlinear refractive index coefficient n(2) and the third-order nonlinear susceptibility chi(3) for a solution of 7-prime,7-prime-dicyano-7-prime-apo-beta-carotene (DCAC) in hexane have been measured at different concentrations. The measurements have been performed by both the self-trapping and self-phase modulation techniques using a CW Ar(+) laser. The results show that DCAC has a relatively large nonlinearity, attributed to a thermal mechanism, with n(2) of the order of 10 exp 9 times that of CS2.

Abdeldayem, Hossin A.↗

NASA NTRS1992

Compact in-line laser radial shear interferometer

A compact in-line radial shearing interferometer using laser as a light source is presented. The interferometer is made out of a cube-type beam splitter so that the two opposite surfaces are generated with different curvatures while the normal to the entrance and exit surfaces are in the same line. The interferometer is simple to make and easy to align. Aberration analysis of the interferometer is also presented. Some applications of the interferometer for testing lenses and infrared optical systems and for accessing the quality of an emerging wave front from the exit slit of a monochromator are suggested.

Shukla, R. P.↗

NASA NTRS1990

Determination of refractive index of a simple negative, positive, or zero power lens using wedged plated interferometer

A nondestructive technique for measuring the refractive index of a negative lens using a wedged plate interferometer is described. The method can be also used for measuring the refractive index of convex or zero power lenses. Schematic diagrams are presented for the use of a wedged plate interferometer for measuring the refractive index of a concave lens and of a convex lens.

Shukla, R. P.↗

NASA NTRS1990

Optogalvanic spectrum of argon in the visible wavelength region 4150-6700 A

Optogalvanic spectrum of argon has been investigated in the visible wavelength region 4150-6700 A by axially irradiating a hollow cathodic discharge with an excimer pumped dye laser. About 180 transitions have been recorded and a majority of them have been identified using the Jl-coupling scheme. The optogalvanic spectrum in the regions 4300-5300 and 6010-6700 A is being reported in detail for the first time. The optogalvanic signal intensities are found to agree with atomic transition probabilities. A technique has been discussed to record a maximum number of transitions in optogalvanic effect.

Reddy, B. R.↗

NASA NTRS1989

Penning type of ionizing energy transfer collisions in a Hg-Ar discharge detected by the optogalvanic effect

The temporal evolution of the optogalvanic signals has been investigated in detail in a Hg-argon discharge by irradiating it with an excimer pumped dye laser. The signals at 4510.7, 4596 and 4628.4 A exhibited anomalous behavior. Analysis of the data revealed that the excited Ar and Hg atoms respectively in the 1P1 and 3P1 states participated in energy transfer collisions, causing atomic mercury to excite to an ionized energy state, while simultaneously the argon atom relaxes to its ground state.

Reddy, B. R.↗

NASA NTRS1989

Phase conjugation by degenerate four wave mixing in disodium fluorescein solution in methanol

Organic dyes are known to show the resonant type of nonlinear optical properties, including phase conjugation. In the present work, disodium fluorescein in methanol is used as an organic nonlinear medium for degenerate four wave mixing at 532 nm to see the intensity dependence of the phase conjugate signal at different concentrations of the solution. It is observed that the maximum reflectivity of the signal occurs in a concentration range of 5 x 10(exp -3)/cu cm to 1.2 x 10(exp -2) g/cu cm. It is also observed that the intensity of the signal drops suddenly to less than half of its maximum outside the concentration range mentioned above. An investigation of the phase conjugate signal intensity by changing the delay time between probe signal and the forward pump is also examined. Briefly discussed is the possibility of population grating in dye liquids as a source of enhancing the third order susceptibility besides the other techniques mentioned in reference. The experiment is done by beam splitting the second harmonic (532 nm) of Nd:YAG laser, Q-switched at 20 pulses/sec (pulse width is approximately 8 and 200 mJ per pulse).

Abdeldayem, Hossin↗

NASA NTRS1989

Surface roughness of flat and curved optical surfaces

Surface roughness measurement has several applications. Even a few A roughness will cause scattered light in optical systems. Smooth surfaces are required in a wide variety of instruments. For example, the outputs of the high power lasers are limited by the surface roughness of mirrors and windows. Similarly, the information storage capacity of magnetic media is limited by the roughness of the surface. Roughness reduces the resolving power of optics and distorts images. The performance of certain thin film components in electronic industries is affected by the roughness on the film surface. X-ray astronomical telescopes require smooth curved surfaces. To improve the surface quality, super sensitive detection methods are required. Wide ranging measurement techniques are developed based on interferometry, electron microscopy, C-rays, ellipsometry, light scattering, and using mechanical stylus, etc. Though there are several techniques available for measurement and evaluation of the surfaces, no single technique is fully adequate. Also, the technique used should be nondestructive and highly sensitive. So, an optical heterodyne profilometer was fabricated. Its current sensitivity is much better than 10A rms. It is a noncontact and nondestructive technique. The instrument can be operated even by unskilled personnel for routine measurements.

George, M. C.↗

NASA NTRS1987

Optical bistability in self-pumped phase-conjugate ring resonators

Bistable oscillations have been observed in BaTiO3 pumped by a single-mode 30-mW (488-nm) argon-ion laser, which is used simultaneously as a ring passive phase conjugator (RPPC) and as a unidirectional ring resonator (UDRR). Strong oscillations in the UDRR increase the threshold coupling strength required for oscillation in the RPPC. The oscillations in the RPPC reduce the fanning in the crystal necessary for the startup of oscillation in the UDRR. Auxiliary resonators pumped by the RPPC are also bistable with the UDRR. Similar bistable oscillations have been observed when the crystal is used simultaneously as a RPPC and as a linear passive phase conjugator.

Jagannath, H.↗