Search NASA⌕ Search

Engineering topics

Veser, Götz

Publications and source records attributed to Veser, Götz.

5 records
All sourcesNASA NTRSDOE OSTI
DOE OSTI2023

Impact of Flow Configurations on Response Time and Data Quality in Real-Time, In-Line Fourier Transform Infrared (FTIR) Monitoring of Viscous Flows

The real-time, in-line monitoring of continuous flow concentrations is widely conducted via infrared (IR) spectrometry by using a flow cell connected to a reactive flow stream. For protective purposes, the IR sensor tip is typically offset from the flow. This offset can cause the formation of a stagnant boundary layer above the sensor, especially when dealing with high-viscosity fluids. As a result, the IR signal response time is often controlled by the slow diffusional exchange of fluid in the boundary layer, as confirmed via 2D computational fluid dynamics (CFD) simulations. We evaluated several flow configuration modifications in a typical IR flow cell in order to identify the changes to the flow dynamics that enable improved response times with minimal changes to the cell configuration: the use of (i) vertical flow, where the standard horizontal flow over the sensor is redirected to contact vertically with the sensor, (ii) a static mixer to create radial flow momentum above the IR sensor, and (iii) horizontal or vertical nozzles to direct the flow toward the IR sensor. The vertical flow configuration did not show any significant improvement over the standard horizontal flow configuration. However, the static mixer, horizontal nozzle, and vertical nozzle configurations all resulted in markedly improved response times and signal quality, albeit at the expense of a higher pressure drop across the flow cell. These results point toward straightforward, user-accessible modifications of in-line IR flow cells that result in significant improvements in signal stability and acquisition times.

42 ENGINEERING↗
DOE OSTI2021

Microwave-assisted conversion of methane over H-(Fe)-ZSM-5: Evidence for formation of hot metal sites

We report microwave-assisted catalysis offers great promise as an “intensified” technology for chemical processing. The present study investigates microwave-assisted direct conversion of methane with focus on the design and evaluation of microwave-sensitive H-(Fe)ZSM-5 catalysts for the existence of hotspot formation. Isomorphous substituted H-(Fe)ZSM-5 catalysts are tuned to identify key design parameters that control their microwave sensitivity. Increasing the amount of Al and Fe substitution in the zeolite lattice is found to result in higher microwave sensitivity due to improved dielectric properties and hence facilitated microwave heating of the catalyst bed. Comparison between the performance of these catalysts in a conventional thermally-heated (CH) fixed-bed and a microwave (MW) reactor allows identification of the effect of microwave irradiation on the catalyst activity. Methane conversion is drastically enhanced at MW conditions (from 3% at CH conditions to 40% at MW conditions), indicating accelerated methane activation over the metal site and hence suggesting a hot metal site despite much lower catalyst bulk temperature measured in the microwave reactor. The existence of metal hotspot formation is further supported by the reaction product distribution and spent catalyst analysis. At MW conditions, C 2 (ethane and ethylene) and coke (mainly carbon nanotubes and nanofibers) selectivity are much higher at the cost of aromatics make compared to CH conditions. This can be explained by reduced aromatization activity at the Brønsted acid sites of the zeolite due to its lower relative temperature of the zeolite. The much-enhanced metal aggregation observed in the spent catalyst from the MW reactor along with the distribution of coke species further confirms the existence of selective heating (i.e. hotspot formation) occurring at the active metal site in the catalyst at MW conditions.

37 INORGANIC, ORGANIC, PHYSICAL, AND ANALYTICAL CH↗