Engineering topics

Vestal, Breanna K.

Publications and source records attributed to Vestal, Breanna K..

6 records

DOE OSTI2024

The chlorination and separation of aluminum using low-temperature sulfur chloride reagents

There is currently no strategy for the permanent waste disposal or recycling for used nuclear fuelsfrom research reactors. For this reason, low-temperature reactions have been developed for thechlorination of the Al alloys and subsequent separation from used nuclear fuels to reducethe volume of high-level waste in storage. Three sulfur chloride reagents – S 2 Cl 2 , SOCl 2 , and SO 2 Cl 2 —were tested, and two were found to quantitatively chlorinate Al metal and Al alloys undermild conditions. Further, these low-temperature reactions proceed between 298 and 411 K, and up to 5 gof metal is chlorinated in 1–3 h. Preliminary results indicate that the reactivity and exothermicity ofthe reaction between the Al and sulfur chloride reagents is highly dependent on the surface area-to-volume ratio of the metal and the volume of solvent. Elemental S is produced as a by-productduring the chlorination with S 2 Cl 2 but can be quantitatively rechlorinated under mild conditions toregenerate the initial chlorination reagent. Therefore, in this case, chlorine is the only elementconsumed in the reaction, thus minimizing the waste generated during the chlorination process.The AlCl 3 may then be separated from other materials present in Al 6061 or Al 8001 because of itshigh solubility in the sulfur chloride reagents. This process may also be extended to chlorinate Alfrom research reactor fuels.

aluminum↗

DOE OSTI2024

Iodine Capture Studies of Silver Mordenite and Novel Alternative Metal Sorbents

Radioiodine is one of the radionuclides of concern when considering reprocessing of used nuclear fuel (UNF). It is expected to be released primarily in the dissolver off-gas (DOG) stream. Sorbents that target I 2 removal from a UNF processing off gas must perform efficiently under elevated temperatures in the presence of water vapor and nitrogen oxide gasses (NOx). Many studies have been conducted that examine the adsorption of iodine species in the presence of NOx gases through reduced silver-exchanged mordenite (Ag 0 Z), a zeolite mineral. This study characterizes the effects of iodine, water vapor, and nitrogen dioxide on the adsorption of I 2 by Ag 0 Z at lower temperatures suitable for comparison with novel Cu- and Bi- bearing sorbents which offer a non-RCRA alternative. When exposed to ‘harsh’ conditions such as I 2 , H 2 O, and NO 2 vapors carried by air, Cu 2 S-polyacrylonitrile (PAN) is more efficient than Ag 0 Z and all other novel sorbents, providing with 11% I capture efficiency. However, under ‘ideal’ conditions in which I 2 is carried by dry air), Ag 0 Z is more efficient than Cu 2 S-PAN and other novel sorbents, providing 74% I capture efficiency. To investigate this result and the overall performance of all sorbents tested, several characterization techniques were employed, including thermal gravimetric analysis, scanning electron microscopy – electron dispersion X-Ray spectroscopy, powder X-ray diffraction, and X-ray photoelectron spectroscopy. These techniques are discussed within this report. This document also includes a design and test plan update from Idaho National Laboratory as the next step in testing the high performing sorbents from thin-bed tests carried out by Oak Ridge National Laboratory.

11 NUCLEAR FUEL CYCLE AND FUEL MATERIALS↗

DOE OSTI2023

On-line Measurement of Hydrogen Gas using Raman Spectroscopy for Process Gas Systems

Advanced reprocessing schemes such as the Zircex process are important for continued development of the nuclear fuel cycle. The hydrochlorination reaction of the Zircex process flow sheet for metallic fuels has a known off-gas stream of H 2 (g) and HCl. The flow sheet can be simplified through HCl recycling, which requires detection and quantification of any residual H 2 (g) for safety and purity. In this work, commercially available Raman spectroscopy was applied for low-level, on-line detection of H 2 (g) in process gas streams, and parameters were adjusted to optimize the H 2 (g) Raman signal. Increasing the number of scans and exposure time in the spectrometer increased the signal-to-noise ratio of the H 2 (g) Raman signal, while the gas flow rate was optimized at 2.3 L/min. The limit of detection for H 2 (g) was estimated to be 2,100 ppm H 2 (g) in an N 2 (g) background. This scoping study for the application of Raman spectroscopy for on-line measurements of H 2 (g) shows that H 2 (g) can be detected at low levels (approximately 5% of the lower explosive limit (LEL)) in flowing gas streams.

11 NUCLEAR FUEL CYCLE AND FUEL MATERIALS↗

DOE OSTI2023

Commercially available Hydrogen Detection Systems for Corrosive, Oxygen-free Gas Streams: A Technical Summary

The growing use of hydrogen gas across energy, transportation, and chemical applications necessitates better hydrogen sensors and detectors. Few sensors exist for quantifying hydrogen gas in a corrosive, oxygen-free gas stream due to the challenging nature of the sampling environment and current technological status. Handheld, economic options include palladium-based, metal oxide, catalytic bead, and electrochemical sensors. More permanent and costly options include electrochemical sensors, thermal gas analyzers, mass spectrometers, gas chromatographs, and Raman spectrometers. In this technical report, a short review of current technology, along with the associated commercially available products, is provided. Raman spectroscopy is recommended as an ideal technology for on-line detection of hydrogen at low concentrations in a corrosive, oxygen-free gas stream.

08 HYDROGEN↗

DOE OSTI2023

A novel protocol to recycle zirconium from zirconium alloy cladding from used nuclear fuel rods

A potential new zirconium recycling protocol has been demonstrated using unirradiated Zircaloy-based claddings and depleted uranium oxide for the chemical removal of zirconium alloy cladding in used nuclear fuel (UNF) rods from light water reactors. This protocol is based on the application of three new scientific findings. First, a new lower temperature chlorination reaction of zirconium with sulfur monochloride is described. Second, the high solubility of zirconium chloride in thionyl chloride is used to separate it from uranium oxide fuel and fission and activation contaminants. Finally, in the third step, the zirconium chloride is purified by simple recrystallization from thionyl chloride. Utilizing sulfur chloride solvents for a lower temperature liquid-based chemical digestion and purification of zirconium alloy claddings reduces technical complications experienced by current high temperature gas phase chlorination strategies, such as contamination of product streams. This novel protocol has been demonstrated on a 3–50 g scale of unirradiated zirconium alloy, with no significant change in the time required for complete chlorination (3–4 h). This zirconium chlorination protocol has also been performed in the presence of depleted uranium oxide pellets. The depleted fuel pellets do not affect zirconium chlorination, and the chlorination protocol does not chemically or physically alter the fuel pellets. Finally, a preliminary description of an industrial protocol to recycle nuclear grade zirconium from UNF rods is presented.

12 MANAGEMENT OF RADIOACTIVE AND NON-RADIOACTIVE W↗

DOE OSTI2021

Advanced Low-Temperature Chlorination of Zirconium

Recovery of Zr from nuclear fuel is of high interest because the Zr cladding material comprises up to 50% of the high-level radioactive waste (HLW) that requires disposition. An ideal Zr-recovery process would not only recover the bulk Zr from the fuel or cladding but would also provide decontamination from the components that give rise to the HLW designation. A simplified decontamination pathway providing recovered Zr in compliance with low-level radioactive waste acceptance criteria could significantly reduce the burden of HLW requiring geologic disposition. A newly developed advanced low-temperature chlorination process presents an opportunity to recover a ZrCl4 product that is effectively decontaminated from the elements of concern. This advanced low-temperature chlorination process uses a mixture of the sulfur-containing chlorination compounds sulfur monochloride (S 2 Cl 2 ) and thionyl chloride (SOCl 2 ).

11 NUCLEAR FUEL CYCLE AND FUEL MATERIALS↗