Search NASA⌕ Search

Engineering topics

Villa‐Aleman, Eliel

Publications and source records attributed to Villa‐Aleman, Eliel.

The electronic Raman scattering spectrum of PuO 2

Here the Raman spectrum of PuO 2 was measured up to 13,000 cm –1 with three different laser excitation wavelengths spanning the resonance (405 nm), near-resonance (457 nm), and preresonance (514 nm) energy range. Approximately 26 never-before-seen bands were observed between 3500 and 13,000 cm –1 . Given the very high energy of the Raman shifts of these bands and the relative insensitivity of their spectral position to the interrogating laser wavelength, they are believed to arise from an electronic origin. These bands are present in both freshly calcined and radiolytically aged PuO 2 , although a broad luminescence is observed in the aged material, which obscures many of the high frequency features. In situ laser annealing of the material attenuated this luminescence and allowed for clear observation of these never-before-seen spectral features. Discovery of these high-energy bands presents a new way of identifying PuO 2 for nuclear nonproliferation and forensics purposes.

38 RADIATION CHEMISTRY, RADIOCHEMISTRY, AND NUCLEA↗

Raman signatures of detonation soot

Soot generated from the detonation of nine explosives was investigated with Raman microspectroscopy and high-resolution transmission electron microscopy (HRTEM). The first order bands, located at approximately 1,580 (G), 1,350 (D1), 1,620 cm –1 (D2), 1,500 (D3), and 1,200 (D4), are used to provide information on the carbon allotropes and defects. The intensity ratios and the full-width at half-maximum provide an indication of the disorder in the material. The Raman spectra of soot acquired from the detonation of nine explosives showed differences which can be used to identify the precursor explosive. Overall, most differences in the spectra were correlated with the presence of amorphous carbon in the soot. In additional to identification of distinct bands in the spectra via deconvolution, principal component analysis was also used to differentiate the different types of soot. HRTEM performed on soot samples with different explosive precursors identified several distinct allotropes of carbon such as nanodiamonds, carbon onions, graphite fibers, and amorphous carbon.

45 MILITARY TECHNOLOGY, WEAPONRY, AND NATIONAL DEF↗

Laser-induced annealing of aged PuO 2

Plutonium dioxide (PuO 2 ) is an important compound used in nuclear fuel, irradiation targets, and heat sources. As such, improved understanding of its structural and spectroscopic properties has numerous applications. Alpha particle-induced damage of a PuO 2 crystal lattice modifies several properties of its Raman spectrum, including band intensities, positions, and widths. The decay also induces growth of new bands and creates electron-trapped defects with luminescent properties. Herein, we show for the first time that laser-induced heating can reverse damage to an aged and damaged PuO 2 lattice. Using automated instrumentation to heat a single 6–10 μm spot to temperatures above 1,300°C, we show that laser-induced annealing of aged PuO 2 results in restoration of T2g band intensity with a concomitant decrease in defect band intensity, a result that indicates laser annealing can be used to reverse age-damage in PuO 2 . This laser annealing approach permitted in situ observation of temperature-dependent Raman spectral changes, thereby providing insight into the thermodynamics of structural alterations in a radiolytically damaged PuO 2 .

11 NUCLEAR FUEL CYCLE AND FUEL MATERIALS↗

Hyper-Raman spectroscopy of CeO 2

Cerium dioxide (CeO 2 ) belongs to the fluorite structure group (Oh 5 point group) resulting in one Raman active T 2g mode and two IR active T 1u TO and LO modes. The T 2g Raman band in CeO 2 has been used to probe the symmetric Ce-O vibrational mode of different sized nanoparticulates. Far infrared studies of the Ce-O interactions are difficult to conduct due to low optical transmission, efficiency of the detector and water absorption bands interfering with the measurements. The selection rules of hyper-Raman spectroscopy (HRS) allow the study of IR bands in the far infrared spectral region, such as the motion of the Ce atoms. For the first time, HRS was used to investigate the T 1u TO and LO IR modes in CeO 2 . The position and full-width half-maximum (FWHM) of the TO and LO bands in the HRS spectrum were used to investigate the spectral response in relation to particle size (i.e., phonon confinement). The investigation of CeO2 with HRS provides a research platform for future work in the study of ThO 2 , UO 2 and PuO 2 IR modes.

74 ATOMIC AND MOLECULAR PHYSICS↗