Engineering topics
Publications and source records attributed to Viskanta, R..
Explore the source record for details and available documents.
The influence of augmenting and opposing thermal and solutal buoyancy forces on natural convection of binary gases due to horizontal temperature and concentration gradients is examined through comparison of smoke flow visualization and measured temperature and concentration distributions with numerical predictions. The observed flow at the cold wall was unsteady for opposing body forces. The same basic flow structure was observed, but the unsteady flow intensifies as the opposing solutal buoyancy force increases as compared to the thermal buoyancy force. Comparison of predicted and measured temperatures and concentrations is fair overall, but the steady-state analytical model fails to predict the unsteady flow and heat and mass transport for opposing body forces.
Two-dimensional solidification influenced by anisotropic heat conduction has been considered. The interfacial energy balance was derived to account for the heat transfer in one direction (x or y) depending on the temperature gradient in both the x and y directions. A parametric study was made to determine the effects of the Stefan number, aspect ratio, initial superheat, and thermal conductivity ratios on the solidification rate. Because of the imposed boundary conditions, the interface became skewed and sometimes was not a straight line between the interface position at the upper and lower adiabatic walls (spatially nonlinear along the height). This skewness depends on the thermal conductivity ratio k(yy)/k(yx). The nonlinearity of the interface is influenced by the solidification rate, aspect ratio, and k(yy/k(yx).
Radiative transfer in a polluted urban atmosphere is studied using a dynamic model. The diurnal nature of radiative transfer for summer conditions is simulated for an urban area 40 km in extent and the effects of various parameters arising in the problem are investigated. The results of numerical computations show that air pollution has the potential of playing a major role in the radiative regime of the urban area. Absorption of solar energy by aerosols in realistic models of urban atmosphere are of the same order of magnitude as that due to water vapor. The predicted effect of the air pollution aerosol in the city is to warm the earth-atmosphere system, and the net effect of gaseous pollutant is to warm the surface and cool the planetary boundary layer, particularly near the top.
The short-term effects of urbanization and air pollution on the transport processes in the urban planetary boundary layer (PBL) are studied. The investigation makes use of an unsteady two-dimensional transport model which has been developed by Viskanta et al., (1976). The model predicts pollutant concentrations and temperature in the PBL. The potential effects of urbanization and air pollution on the thermal structure in the urban PBL are considered, taking into account the results of numerical simulations modeling the St. Louis, Missouri metropolitan area.
Examination of the directional effects of the simplified models by comparing the experimental data with the predictions based on simple and more detailed models for the radiation characteristics of surfaces. Analytical results indicate that the constant property diffuse and specular models do not yield the upper and lower bounds on local radiant heat flux. In general, the constant property specular analysis yields higher values of irradiation than the constant property diffuse analysis. A diffuse surface in the enclosure appears to destroy the effect of specularity of the other surfaces. Semigray and gray analyses predict the irradiation reasonably well provided that the directional properties and the specularity of the surfaces are taken into account. The uniform and nonuniform radiosity diffuse models are in satisfactory agreement with each other.
Rigorous definitions are presented of local as well as overall specular components of thermal reflectance. Approximations are then made to reduce the definitions to a workable form from which the overall specular component of reflectance can be calculated. Some illustrative results are also given which examine the influence of various parameters.
Critical examination of the validity of the commonly used simplified models for predicting local and overall radiant heat interchange among real surfaces. The spectral local irradiation was measured at wavelengths of 3.08 and 4.51 microns in a configuration consisting of three plane parallel surfaces of finite extent. The test surfaces were gold with mechanical roughness and temperature varying from 0.02 to 7.1 microns and 77 to 760 K, respectively. Comparisons between experimental data and predictions for six different models ranging from the simple diffuse to the most detailed diffuse-plus-specular-directional-property model with specular component calculated according to Beckmann are presented. It is shown that the calculation of the overall irradiation using appropriate constant-property models agrees well with the experimental data to within combined experimental and analytical uncertainty. In general, it is concluded that for accurate prediction of local irradiation the directional characteristics of the surfaces must be considered.
Tests on heat pipes determine operational limits, external boundary conditions, noncondensable gas effects, startup behavior, and geometric configurations. Experiment consists of design, construction, and testing of an apparatus for measuring wick properties, conventional heat pipes and coplanar heat pipes.
Comparison of experimental data with predictions based on simple and more detailed models for radiation properties of surfaces
Literature survey of heat pipe technology from 1964 to mid-1970
Monochromatic radiation angular distribution surface reflectance measurement using photographic reflectometer
Polarization effect on radiant heat transfer between simply arranged smooth plate surfaces
Radiant heat transfer predictions between isothermal plates based on diffuse plus specular directional property model
Transient energy transfer during expansion of plane layer of radiating gas bounded by strong shock, assuming LTE and perfect inviscid nonconducting gas
Radiant heat transfer predictions between isothermal plates based on diffuse plus specular directional property model
Radiative transfer theory used to determine radiative flux in absorbing, emitting and scattering dielectric layer on opaque substrate