Search NASA⌕ Search

Engineering topics

Vogler, Tracy John

Publications and source records attributed to Vogler, Tracy John.

At least 19 records

Pressure-shear experiments on granular materials.

Pressure-shear experiments were performed on granular tungsten carbide and sand using a newly-refurbished slotted barrel gun. The sample is a thin layer of the granular material sandwiched between driver and anvil plates that remain elastic. Because of the obliquity, impact generates both a longitudinal wave, which compresses the sample, and a shear wave that probes the strength of the sample. Laser velocity interferometry is employed to measure the velocity history of the free surface of the anvil. Since the driver and anvil remain elastic, analysis of the results is, in principal, straightforward. Experiments were performed at pressures up to nearly 2 GPa using titanium plates and at higher pressure using zirconium plates. Those done with the titanium plates produced values of shear stress of 0.1-0.2 GPa, with the value increasing with pressure. On the other hand, those experiments conducted with zirconia anvils display results that may be related to slipping at an interface and shear stresses mostly at 0.1 GPa or less. Recovered samples display much greater particle fracture than is observed in planar loading, suggesting that shearing is a very effective mechanism for comminution of the grains.

36 MATERIALS SCIENCE↗

High-pressure shock behavior of WC and Ta2O5 powders.

Planar shock experiments were conducted on granular tungsten carbide (WC) and tantalum oxide (Ta{sub 2}O{sub 5}) using the Z machine and a 2-stage gas gun. Additional shock experiments were also conducted on a nearly fully dense form of Ta{sub 2}O{sub 5}. The experiments on WC yield some of the highest pressure results for granular materials obtained to date. Because of the high distention of Ta{sub 2}O{sub 5}, the pressures obtained were significantly lower, but the very high temperatures generated led to large contributions of thermal energy to the material response. These experiments demonstrate that the Z machine can be used to obtain accurate shock data on granular materials. The data on Ta{sub 2}O{sub 5} were utilized in making improvements to the P-{lambda} model for high pressures; the model is found to capture the results not only of the Z and gas gun experiments but also those from laser experiments on low density aerogels. The results are also used to illustrate an approach for generating an equation of state using only the limited data coming from nanoindentation. Although the EOS generated in this manner is rather simplistic, for this material it gives reasonably good results.

36 MATERIALS SCIENCE↗

Measuring strength at ultrahigh strain rates.

The strain rate sensitivity of materials is measured through a combination of quasistatic, Hopkinson bar, and pressure-shear experiments. The pressure-shear technique has largely been limited to strain rates of order 1E6 1/s. Recent advances in laser and magnetically driven ramp loading have made it possible to achieve significantly higher rates, 1E5-1E8 1/s, under uniaxial strain compression. Strength in these experiments can be calculated by comparing the loading response to the hydrostatic (pressure-density) response of the material for the same density and temperature [Fowles, 1961]. This must be done accounting for the heating due to plastic work in the experiments. Experimental uniaxial strain data for aluminum for strain rates up to 1E8 1/s are examined and compared with existing data. The results are consistent with conventional views of the strain rate sensitivity of aluminum. However, when one considers the higher mean stress (pressure) present in the uniaxial strain experiments and, to a lesser extent, the pressure-shear experiments, one finds the material remains rate insensitive to about 1E7 1/s, two orders of magnitude higher than previously thought. Important caveats about determining strength in this manner will be discussed, and recommendations for future work will be made.

36 MATERIALS SCIENCE↗