Search NASA⌕ Search

Engineering topics

Von Doenhoff, Albert E

Publications and source records attributed to Von Doenhoff, Albert E.

At least 19 records
All sourcesNASA NTRSDOE OSTI
NASA NTRS1958

A Low-Speed Experimental Investigation of the Effect of a Sandpaper Type of Roughness on Boundary-Layer Transition

An investigation was made in the Langley low-turbulence pressure tunnel to determine the effect of size and location of a sandpaper type of roughness on the Reynolds number for transition. Transition was observed by means of a hot-wire anemometer located at various chordwise stations for each position of the roughness. These observations indicated that when the roughness is sufficiently submerged in the boundary layer to provide a substantially linear variation of boundary-layer velocity with distance from the surface up to the top of the roughness, turbulent "spots" begin to appear immediately behind the roughness when the Reynolds number based on the velocity at the top of the roughness height exceeds a value of approximately 600. At Reynolds numbers even slightly below the critical value (value for transition), the sandpaper type of roughness introduced no measurable disturbances into the laminar layer downstream of the roughness. The extent of the roughness area does not appear to have an important effect on the critical value of the roughness Reynolds number.

Von Doenhoff, Albert E↗
NASA NTRS1945

Summary of Airfoil Data

The historical development of NACA airfoils is briefly reviewed. New data are presented that permit the rapid calculation of the approximate pressure distributions for the older NACA four-digit and five-digit airfoils by the same methods used for the NACA 6-series airfoils. The general methods used to derive the basic thickness forms for NACA 6 and 7-series airfoils together with their corresponding pressure distributions are presented. Detail data necessary for the application of the airfoils to wing design are presented in supplementary figures placed at the end of the paper. The report includes an analysis of the lift, drag, pitching-moment, and critical-speed characteristics of the airfoils, together with a discussion of the effects of surface conditions. Available data on high-lift devices are presented. Problems associated with lateral-control devices, leading-edge air intakes, and interference are briefly discussed, together with aerodynamic problems of application. (author)

Abbott, Ira H↗
NASA NTRS1943

Determination of general relations for the behavior of turbulent boundary layers

An analysis has been made of a considerable amount of data for turbulent boundary layers along wings and bodies of various shapes in order to determine the fundamental variables that control the development of turbulent boundary layers. It was found that the type of velocity distribution in the boundary layer could be expressed in terms of a single parameter. This parameter was chosen as the ratio of the displacement thickness to the momentum thickness of the boundary layer. The variables that control the development of the turbulent boundary layer apparently are: (1) the ratio of the nondimensional pressure gradient, expressed in terms of the local dynamic pressure outside the boundary layer and boundary-layer thickness, to the local skin-friction coefficient and (2) the shape of the boundary layer. An empirical equation has been developed in terms of these variables that, when used with the momentum equation and the skin-friction relation, makes it possible to trace the development of the turbulent boundary layer to the separation point.

Von Doenhoff, Albert E↗
NASA NTRS1938

A method of rapidly estimating the position of the laminar separation point

A method is described of rapidly estimating the position of the laminar separation point from the given pressure distribution along a body; the method is applicable to a fairly wide variety of cases. The laminar separation point is found by the von Karman-Millikan method for a series of velocity distributions along a flat plate, which consist of a region of uniform velocity followed by a region of uniform decreased velocity. It is shown that such a velocity distribution can frequently replace the actual velocity distribution along a body insofar as the effects on laminar separation are concerned. An example of the application of the method is given by using it to calculate the position of the laminar separation point on the NACA 0012 airfoil section at zero lift. The agreement between the position of the separation point calculated according to the present method and that found from more elaborate computations is very good.

Von Doenhoff, Albert E↗
NASA NTRS1938

A preliminary investigation of boundary-layer transition along a flat plate with adverse pressure gradient

Boundary-layer surveys were made throughout the transition region along a smooth flat plate placed in an airstream of practically zero turbulence and with an adverse pressure gradient. The boundary-layer Reynolds number at the laminar separation point was varied from 1,800 to 2,600. The test data, when considered in the light of certain theoretical deductions, indicated that transition probably began with separation of the laminar boundary layer. The extent of the transition region, defined as the distance from a calculated laminar separation point to the position of the first fully developed turbulent boundary-layer profile, could be expressed as a constant Reynolds number run of approximately 70,000. Some speculations are presented concerning the application of the foregoing concepts, after certain assumptions have been made, to the problem of the connection between transition on the upper surface of an airfoil at high angles of attack and the maximum lift.

Von Doenhoff, Albert E↗
NASA NTRS1935

An Application of the Von Karman-millikan Laminar Boundary-layer Theory and Comparison with Experiment

The von Karman-Millikan theory of laminar boundary layers presented in NACA Technical Report No. 504 is applied to the laminar boundary layer about an elliptic cylinder on which boundary-layer and pressure-distribution measurements were made. An outline of the procedure of the von Karman-Millikan method is given. Good agreement is obtained between the calculated and experimental results, indicating that the method may be applied generally to the laminar boundary layer about any body provided that an experimentally determined pressure distribution is available. It appears that for all Reynolds Number above 24,000 the separation point for the elliptic cylinder should occur at a constant distance behind the point of minimum pressure, provided that the boundary layer does not become turbulent.

Von Doenhoff, Albert E↗