Engineering topics

Vonbun, F. O.

Publications and source records attributed to Vonbun, F. O..

At least 19 records

NASA NTRS1994

Highly transparent and rugged sensor for velocity determinations of cosmic dust particles

In order to understand the evolution of interplanetary dust, numerous dust particles have been collected and analyzed. An analysis of the composition often provides information on the particle's origin. So does its origin. Composition and orbit data complement each other and should be determined together. If the last orbit of a particle can be determined, its orbital history can often be calculated backward in time and associated with its parent body. To determine the last orbit, the velocity needs to be measured before the particle is collected. The precision required in determining the velocity components relative to the spacecraft should be 1 percent or better. A sensor for naturally charged cosmic dust particles is discussed. Two models of the sensor were tested, one with a free-falling steel ball and the other with particles accelerated to high speed. Analytic expressions of the sensor signals are presented and compared with the test results. The errors in speed and angle were estimated to be about 0.3 percent and 0.2 degrees respectively.

Auer, Siegfried↗

NASA NTRS1981

Earth's gravity field mapping requirements and concept

A future sensor is considered for mapping the Earth's gravity field to meet future scientific and practical requirements for earth and oceanic dynamics. These are approximately + or - 0.1 to 10 mgal over a block size of about 50 km and over land and an ocean geoid to 1 to 2 cm over a distance of about 50 km. To achieve these values requires a gravity gradiometer with a sensitivity of approximately 10 to the -4 power EU in a circular polar orbiting spacecraft with an orbital altitude ranging 160 km to 180 km.

Vonbun, F. O.↗

NASA NTRS1980

Performance analysis of the Spaceborne Laser Ranging System

The performance of the Spaceborne Laser Ranging System in the determination of distances between ground-based targets is discussed. The system consists of an orbiting pulsed laser distance measurement system that sequentially measures the distance to retroreflector arrays on the ground. Intersite distances are then determined from an analysis of the vertical distance data and the spacecraft orbital dynamics. Results of computer simulations indicate that for a six-day observing period with 50 percent cloud cover, uncertainties of 1 to 3 cm are expected for intertarget separations of 50 to 1200 km, with vertical uncertainties from 1 to 12 cm. Furthermore, it is found that by redetermining relative target positions, precision can be increased to less than 0.3 cm to 1 cm in the baseline and to 0.4 to 4 cm in vertical distance. It is concluded that with these precisions, strain and strain rate can be determined for crustal dynamics and earthquake studies, and geodetic surveys can be performed.

Kahn, W. D.↗

NASA NTRS1979

Performance Analysis of the Spaceborne Laser Ranging System

The 'spaceborne laser ranging system' is a proposed short pulse laser on board an orbiting spacecraft. It measures the distances between the spacecraft and many laser retroreflectors (targets) deployed on the earth's surface. The precision of these range measurements was assumed to be about plus or minus 2 cm. These measurements were then used together with the orbital dynamics of the spacecraft to derive the intersite vector between the laser ground targets. The errors associated with this vector were on the order of 1 to 2 cm. The baseline distances determined range from 25 km to 1200 km. By repeating the measurements of the intersite vector, strain and strain rate errors were estimated. The realizable precision for intersite distance determination was estimated to be on the order of 0.5 cm at 300 km and about 1.5 cm at 1200 km. The corresponding inaccuracies for the intersite distances were larger, than is 1 cm and 3.5 cm respectively. The corresponding precision in the vertical direction was 1 cm and 3 cm.

Kahn, W. D.↗

NASA NTRS1979

Results of GEOS 3/ATS 6 satellite-to-satellite tracking orbit determination experiment

The purpose of the Geos 3/ATS 6 satellite-to-satellite tracking experiment was to develop, test, and evaluate methods of deriving orbit estimates from satellite-to-satellite tracking data. The results of the form of conventional orbit overlap tests, and a comparison of a Geos 3 orbit estimate obtained from satellite-to-satellite (SST) tracking data with an orbit estimate derived form C-band data. The method recommeded for estimating orbits from SST data is a Bayesian least squares procedure utilizing independent ranging to the relay satellite.

Argentiero, P.↗

NASA NTRS1978

Orbit determination accuracies using satellite-to-satellite tracking

The results are reported of the ATS-6/GEOS-3 and the ATS-6 Nimbus-6 satellite-to-satellite orbit determination experiments. NASA intends to use the tracking data relay satellite system for operational orbit determination of NASA satellites. Hence, in the near future, satellite-to-satellite tracking data will be routinely processed to obtain orbits. The satellite-to-satellite tracking system used in the ATS-6/Nimbus-6 and ATS-6/GEOS-3 experiments performed with a resolution of 1 to 2 m in range and less than 1 mm/s in range rate for a 10-s averaging. A Bayesian least squares estimation technique utilizing independent ranging to the synchronous relay satellite was determined to be the most effective procedure for estimating orbits from satellite-to-satellite tracking data. The use of this technique yields estimates of user satellite orbits which are comparable in accuracy to what is usually obtained from ground based systems.

Vonbun, F. O.↗

NASA NTRS1978

Orbit determination accuracies using satellite-to-satellite tracking

The results of the ATS-6/GEOS-3 and the ATS-6/NIMBUS-6 satellite-to-satellite tracking orbit determination experiments are reported. The tracking systems used in these experiments differ from the Tracking and Data Relay Satellite System (TDRSS), primarily in the use of one rather than two synchronous relay satellites. However, the simulations mentioned indicate that the insights gained from the experiments with regard to proper data reduction techniques and expected results are applicable to the TDRSS.

Vonbun, F. O.↗

NASA NTRS1978

Computed and observed ocean topography - A comparison

The Goddard Space Flight Center's latest Gravity Earth Model, GEM-8, was used to construct a static sea surface. Such a surface corresponds to the surface of an ocean without the time-varying effects of atmospheric pressure, surface wind friction, tides, and currents. It conforms to a surface dictated by the earth's gravitational and rotational forces. The sea surface model is the result of analyzing more than 500,000 satellite observations together with about 1600 5 deg x 5 deg and about 38,000 1 deg x 1 deg surface gravity anomalies. Preliminary comparisons between the computed and measured sea surface topography indicate that they agree quite well and differ by less than 1 m in many places including the Atlantic test area. Sea-surface features such as undulations caused by trenches and ridges are clearly and accurately detectable. The use of altimeter data for orbit computation reduces the uncertainty of the spacecraft height and thus the errors of the sea-surface topography.

Vonbun, F. O.↗

NASA NTRS1978

Orbit determination accuracies using satellite-to-satellite tracking

Results of the ATS-6/GEOS-3 and the ATS-6/NIMBUS-6 satellite-to-satellite tracking orbit determination experiments to be applied to the NASA geostationary Tracking and Data Relay Satellite System (TDRSS) starting in 1980, are presented. A satellite radio or laser tracking system performed measurements of such parameters as range, range ratio, angles and direction cosines to a spacecraft relative to a given tracking station. Resolutions of 1 meter in range and .03 cm/sec in range rate for a 1 second averaging were achieved showing that with proper data reduction procedures the tracking data relay satellite system should provide orbit determination capability comparable to what is normally obtainable from ground based systems.

Vonbun, F. O.↗

NASA NTRS1977

Orbit determination accuracies using satellite-to-satellite tracking

The uncertainty in relay satellite sate is a significant error source which cannot be ignored in the reduction of satellite-to-satellite tracking data. Based on simulations and real data reductions, it is numerically impractical to use simultaneous unconstrained solutions to determine both relay and user satellite epoch states. A Bayesian or least squares estimation technique with an a priori procedure is presented which permits the adjustment of relay satellite epoch state in the reduction of satellite-to-satellite tracking data without the numerical difficulties introduced by an ill-conditioned normal matrix.

Vonbun, F. O.↗

NASA NTRS1977

Spaceborne earth applications ranging system /SPEAR/

A technique is discussed for the accurate (i.e., to within fractions of centimeters per year) detection of earth surface motions utilizing the latest space technology. It is shown that, over a six-day period and assuming a 50% cloud cover (i.e., as experienced over the past few years of laser operation), by using spaceborne precision ranging systems, intersite distances on the order of 5 to 15 km (dependent mostly on the beam width of the laser) can be determined in the vertical and horizontal components, with errors in the 0.5- to 1.5-cm range. These errors are almost independent of ground survey errors up to 0.25 m and orbit errors up to 200 m. A spaceborne laser ranging system is assumed to range to two or more ground-emplaced retroreflectors. This can be done either in a simultaneous or nonsimultaneous mode. Hardware is under development for the latter technique.

Vonbun, F. O.↗

NASA NTRS1977

Probing the earth's gravity field by means of satellite-to-satellite tracking

Two satellite-to-satellite tracking (sst) tests are described in detail: (1) the ATS-6/Geos-3 and (2) the ATS-6/Apollo-Soyuz experiment. The main purpose of these two experiments was to track via ATS-6 the Geos-3, as well as the Apollo-Soyuz and to use these tracking data to determine both of the orbits at the same time, each of the orbits alone, and to test the two sst links to study local gravity anomalies. A second purpose was to test communications, command and data transmission from the ground via ATS-6 to these spacecraft and back again to the ground.

Vonbun, F. O.↗

NASA NTRS1977

The N.A.S.A. earth and ocean dynamics programme

Practical applications of NASA space systems, science, and technology to the study of oceans and solid earth are discussed. Goals involving earth dynamics include earthquake hazard assessment and alleviation, and global surveying and mapping, while goals involving ocean dynamics include the determination of ocean currents and circulation, and the monitoring of ocean surface conditions. Satellites used to obtain data are described, and projects such as the study of open ocean tides and earth motion determination are reviewed, with consideration given to the techniques (e.g., laser ranging, satellite-to-satellite track) used in these studies. Several physical phenomena, the extent to which they presently can be measured, and possible future requirements for more accurate measurements are examined.

Vonbun, F. O.↗

NASA NTRS1977

Lageos orbital acquisition and initial assessment

Orbital elements for the satellite Lageos, launched on 4 May, 1976, were generated through use of Baker-Nunn camera data. Camera observations of the apogee kick motor provided the node and perigee, the inclination and the eccentricity, while the mean anomaly and the mean motion were determined from observations of the satellite. During the month following the launch, the Smithsonian Astrophysical Observatory and NASA laser tracking networks acquired about 110 satellite passes. The laser tracking system has been applied to a variety of orbital configurations, including elevation angles below 20 deg. Single-pass range residuals versus time were plotted for 741 laser observations of the satellite; the standard deviation of the total system noise was found to be 7 cm.

Pearlman, M. R.↗

NASA NTRS1976

Skylab earth resources experiment package /EREP/ - Sea surface topography experiment

The S-193 Skylab radar altimeter was operated in a round-the-world pass on Jan. 31, 1974. The main purpose of this experiment was to test and 'measure' the variation of the sea surface topography using the Goddard Space Flight Center (GSFC) geoid model as a reference. This model is based upon 430,000 satellite and 25,000 ground gravity observations. Variations of the sea surface on the order of -40 to +60 m were observed along this pass. The 'computed' and 'measured' sea surfaces have an rms agreement on the order of 7 m. This is quite satisfactory, considering that this was the first time the sea surface has been observed directly over a distance of nearly 35,000 km and compared to a computed model. The Skylab orbit for this global pass was computed using the Goddard Earth Model (GEM 6) and S-band radar tracking data, resulting in an orbital height uncertainty of better than 5 m over one orbital period.

Vonbun, F. O.↗

NASA NTRS1976

Gravity anomaly detection: Apollo/Soyuz

The Goddard Apollo-Soyuz Geodynamics Experiment is described. It was performed to demonstrate the feasibility of tracking and recovering high frequency components of the earth's gravity field by utilizing a synchronous orbiting tracking station such as ATS-6. Gravity anomalies of 5 MGLS or larger having wavelengths of 300 to 1000 kilometers on the earth's surface are important for geologic studies of the upper layers of the earth's crust. Short wavelength Earth's gravity anomalies were detected from space. Two prime areas of data collection were selected for the experiment: (1) the center of the African continent and (2) the Indian Ocean Depression centered at 5% north latitude and 75% east longitude. Preliminary results show that the detectability objective of the experiment was met in both areas as well as at several additional anomalous areas around the globe. Gravity anomalies of the Karakoram and Himalayan mountain ranges, ocean trenches, as well as the Diamantina Depth, can be seen. Maps outlining the anomalies discovered are shown.

Vonbun, F. O.↗

NASA NTRS1976

Earth and ocean dynamics program

The objectives and requirements of the Earth and Ocean Dynamics Programs are outlined along with major goals and experiments. Spaceborne as well as ground systems needed to accomplish program goals are listed and discussed along with program accomplishments.

Vonbun, F. O.↗

NASA NTRS1976

Goddard laser systems and their accuracies

The latest Goddard laser systems, and their use in the Earth Dynamic Program are described. The tracking accuracies obtained using actual field data are discussed.

Vonbun, F. O.↗