Search NASA⌕ Search

Engineering topics

Vonglahn, U.

Publications and source records attributed to Vonglahn, U..

23 records · Page 2
All sourcesNASA NTRSDOE OSTI
NASA NTRS1975

Geometry effects on STOL engine-over-the-wing acoustics with 5.1 slot nozzles

The correspondence of far field acoustic trends with changes in the characteristics of the flow field at the wing trailing edge caused by alterations in the nozzle-wing geometry were determined for several STOL-OTW configurations. Nozzle roof angles of 10 to 40 deg were tested with and without cutback of the nozzle sidewalls. Three wing chord sizes were used: baseline (33 cm with flaps retracted), 2/3-baseline, and 3/2-baseline. Flap deflection angles of 20 and 60 deg were used. The nozzle locations were at 21 and 46-percent of chord. With increasing wing size the jet noise shielding benefits increased. With increasing nozzle roof angle, the jet velocity at the trailing edge was decreased, causing a decrease in trailing-edge and fluctuating lift noise. Cutback of the nozzle sides improved flow attachment and reduced far-field noise. The best flow attachment and least trailing-edge noise generally were obtained with a 40 deg external deflector configuration and a cutback nozzle with a 40 deg roof angle.

Vonglahn, U.↗
NASA NTRS1974

Geometry considerations for jet noise shielding with CTOL engine-over-the-wing concept

Jet noise shielding benefits for CTOL engine-over-the-wing installations were obtained with various model-scale circular nozzles and wing chord geometries. Chord-to-nozzle diameter ratios were varied from 3 to 20, while ratios of nozzle height above the wing to the diameter were varied from near zero to 3. Spectral noise data were obtained with jet velocities from 640 to 1110 ft/sec. Characteristics of low frequency noise sources are discussed. Jet-noise shielding is correlated in terms of acoustic and geometric parameters. Implications of extending the model-scale data to full-scale are discussed.

Vonglahn, U.↗
NASA NTRS1974

Aerodynamic and acoustic performance of ejectors for engine-under-the-wing concepts

Subsonic thrust augmentation, exhaust plume velocity contours and acoustic characteristics of a small-scale, 6-tube mixer nozzle with ejector were obtained with and without a wing. Thrust augmentation up to 30 percent was achieved. Aerodynamic results showed that at a given location, greater downstream velocities are obtained with an ejector than with the baseline nozzle. Ejectors reduce high frequency noise; however, low frequency noise amplification also occurs. Acoustic reflections off the wing increase the noise level to a ground observer. With an ejector, the acoustic benefits of forward velocity may be significantly reduced compared with the baseline nozzle.

Vonglahn, U.↗
NASA NTRS1974

Influence of mixer nozzle velocity decay characteristics on CTOL-OTW jet noise shielding

Jet noise shielding benefits for CTOL engine-over-the-wing configurations were obtained with model scale multitube and lobed mixer nozzles and various shielding surface geometries. Spectral data were obtained with jet velocities from 585 to 1110 ft/sec. Correlation equations for predicting jet noise shielding benefits with single conical nozzle installations were modified to correlate the mixer nozzle data. The modification included consideration of the number of nozzle elements and the peak axial velocity decay in the flow field adjacent to the shielding surface. The effect of forward velocity on jet noise attenuation by a shielding surface is discussed.

Vonglahn, U.↗