Search NASA⌕ Search

Engineering topics

Vrancik, J. E.

Publications and source records attributed to Vrancik, J. E..

17 records
All sourcesNASA NTRSDOE OSTI
NASA NTRS1975

Design of automatic startup and shutdown logic for a Brayton-cycle 2- to 15-kilowatt engine

The NASA Lewis Research Center is conducting a closed-Brayton-cycle power conversion system technology program in which a complete power system (engine) has been designed and demonstrated. This report discusses the design of automatic startup and shutdown logic circuits as a modification to the control system presently used in this demonstration engine. This modification was primarily intended to make starting the engine as simple and safe as possible and to allow the engine to be run unattended. In the modified configuration the engine is started by turning the control console power on and pushing the start button after preheating the gas loop. No other operator action is required to effect a complete startup. Shutdown, if one is required, is also effected by a simple stop button. The automatic startup and shutdown of the engine have been successfully and purposefully demonstrated more than 50 times at the Lewis Research Center during 10,000 hours of unattended operation. The net effect of this modification is an engine that can be safely started and stopped by relatively untrained personnel. The approach lends itself directly to remote unattended operation.

Vrancik, J. E.↗
NASA NTRS1973

Inexpensive programmable computer clock

Clock's computer interface accepts pulses from computer (computer commands) and translates them into control signals for clock, and vice versa. Clock is preset by computer to a fixed number of time pulses, and then started. After fixed number of time pulses has occured, clock reads pulse (via interface) to computer and stops.

Vrancik, J. E.↗
NASA NTRS1973

Performance of electrical subsystem of 2- to 15-kilowatt Brayton power conversion system

The electrical subsystem of the 2-to 15-kilowatt Brayton power conversion system was evaluated under various operating and off-design temperature conditions in a vacuum environment. Overall operation was satisfactory. Speed controller operation is a major cause of distortion in the system ac voltage and current waveforms. This distortion has a small, but potentially significant effect on the performance of individual subsystem components.

Secunde, R. R.↗
NASA NTRS1973

Improvements in and test results for the 2 to 15 kilowatt Brayton cycle electrical subsystem

The electrical subsystem of the 2- to 15-kW Brayton power conversion system consists of the auxiliary electrical equipment required for an integrated, self-contained system. For the last 2 years the electrical subsystem has been undergoing extensive tests. The first year of testing resulted in determining the performance characteristics of the electrical subsystem. During the second year several significant changes and improvements were investigated. An inverter designed for motor starting the alternator performed successfully. Some of the changes that have been made are a new alternator speed pickup, which is independent of the alternator output voltage; new, more efficient power supplies for the control system; and a volts-per-hertz reference for the alternator voltage regulator. Test data were taken on the temperature distribution of the electrical subsystem at startup conditions over a cold-plate temperature range of 25 to -50 C.

Vrancik, J. E.↗
NASA NTRS1972

Inexpensive programmable clock for a 12-bit computer

An inexpensive programmable clock was built for a digital PDP-12 computer. The instruction list includes skip on flag; clear the flag, clear the clock, and stop the clock; and preset the counter with the contents of the accumulator and start the clock. The clock counts at a rate determined by an external oscillator and causes an interrupt and sets a flag when a 12-bit overflow occurs. An overflow can occur after 1 to 4096 counts. The clock can be built for a total parts cost of less than $100 including power supply and I/O connector. Slight modification can be made to permit its use on larger machines (16 bit, 24 bit, etc.) and logic level shifting can be made to make it compatible with any computer.

Vrancik, J. E.↗
NASA NTRS1971

Cold startup and low temperature performance of the Brayton cycle electrical subsystem

Cold performance tests and startup tests were conducted on the Brayton-cycle inverter, motor-driven pump, dc supply, speed control with parasitic load resistor and the Brayton control system. These tests were performed with the components in a vacuum and mounted on coldplates. A temperature range of ?25 to -50 C was used for the tests. No failures occurred, and component performance gave no indication that there would be any problem with the safe operation of the Brayton power generating system.

Vrancik, J. E.↗
NASA NTRS1971

Prediction of windage power loss in alternators

Simplified equations and constants, based on laminar and turbulent flow theory between parallel plates, estimate windage loss in rotating electrical machinery. Comparison of calculated results and experimental data for smooth cylindrical rotor and slotted alternator yields 7 percent maximum variation between calculated and experimental data.

Vrancik, J. E.↗
NASA NTRS1971

AC power meter

AC power meters using electronic multiplier for overcoming limitations concerning frequency ranges, response times, power factor and distortion

Vrancik, J. E.↗
NASA NTRS1970

High-frequency wattage-to-voltage converter

Solid state device, which measures electric power over a wide frequency range, multiplies two electrical input signals to produce an output voltage that is proportional to their product. Quarter-square type of electronic analog multiplier is used.

Vrancik, J. E.↗