Search NASA⌕ Search

Engineering topics

Wagner, Albert F.

Publications and source records attributed to Wagner, Albert F..

Pressure Effects on the Relaxation of an Excited Ethane Molecule in High-Pressure Bath Gases

Here, we use molecular dynamics to calculate the rotational and vibrational energy relaxation of C 2 H 6 in Ar, Kr, and Xe bath gases over a pressure range of 10 to 400 atm and at temperatures of 300 K and 800 K. The C 2 H 6 is instantaneously excited by 80 kcal/mol randomly distributed into both vibrational and rotational modes. The computed relaxation rates show little sensitivity to the identity of the noble gas in the bath. Vibrational relaxation rates show a non-linear pressure dependence at 300 K. At 800 K the reduced range of bath gas densities covered by the range of pressures do not yet show any non-linearity in the pressure dependence. Rotational relaxation is characterized with two relaxation rates. The slower rate is comparable to the vibrational relaxation rate. The faster rate has a linear pressure dependence at 300 K but an irregular, nonlinear pressure dependence at 800 K. To understand this, a model was developed based on approximating the periodic box used in the molecular dynamics simulations by an equal-volume collection of cubes where each cube is sized to allow only single occupancy by the noble gas or the molecule. Combinatorial statistics then leads to a pressure and temperature dependent analytic distribution of the bath gas species the molecule encounters in a collision. This distribution, the dissociation energy of molecule/bath gas complexes and bath gas clusters, and the computed energy release per collision combine to show that only at 300 K is the energy release sufficient to dissociate likely complexes and clusters. This suggests that persistent and pressure-dependent clusters and complexes at 800 K may be responsible for the non-linear pressure dependence of rotational relaxation.

37 INORGANIC, ORGANIC, PHYSICAL, AND ANALYTICAL CH↗

Mode-specific pressure effects on the relaxation of an excited nitromethane molecule in an argon bath

The vibrational and rotational mode-specific relaxations of CH 3 NO 2 with 50 kcal/mol of initial internal energy in an argon bath is computed at 300 K at pressures of 10-400 atm. This work uses archived information from our previously published [J. Chem. Phys. 142, 014303 (2015)] molecular dynamics simulations and employs our previous published [J. Chem. Phys. 151, 034303 (2019)] method for projecting time-dependent Cartesian velocities onto normal mode eigenvectors. The computed relaxations cover three types of energies: vibrational, rotational, and Coriolis. In general, rotational and Coriolis relaxations in all modes are initially fast followed by an orders of magnitude slower relaxation. For all modes, that slower relaxation rate is approximately comparable to the vibrational relaxation rate. For all three types of energies, there are small-scale mode-to-mode variations. Of particular prominence is the exceptionally fast relaxation shared in common by the external rotation about the C-N axis, the internal hindered rotation of the CH 3 group relative to the NO 2 group, and the symmetric stretch of the CH 3 group.

37 INORGANIC, ORGANIC, PHYSICAL, AND ANALYTICAL CH↗

Normal mode analysis on the relaxation of an excited nitromethane molecule in argon bath

In our previous work [Rivera-Rivera et al., J. Chem. Phys. 142, 014303 (2015)], classical molecular dynamics simulations followed the relaxation, in a 300 K Ar bath at a pressure of 10-400 atm, of nitromethane (CH 3 NO 2 ) instantaneously excited by statistically distributing 50 kcal/mol among all its internal degrees of freedom. Both rotational and vibrational energies decayed with nonexponential curves. In this present work, we explore mode-specific mechanisms at work in the decay process. With the separation of rotation and vibration developed by Rhee and Kim [J. Chem. Phys. 107, 1394 (1997)], one can show that the vibrational kinetic energy decomposes only into vibrational normal modes, while the rotational and Coriolis energies decompose into both vibrational and rotational normal modes. The saved CH 3 NO 2 positions and momenta were converted into mode-specific energies whose decay was monitored over 1000 ps. Lastly, the results identify vibrational and rotational modes that promote/resist energy lost and drive nonexponential behavior.

37 INORGANIC, ORGANIC, PHYSICAL, AND ANALYTICAL CH↗

Pressure effects on the vibrational and rotational relaxation of vibrationally excited OH (ν, J ) in an argon bath

Quasi-classical molecular dynamics simulations were used to study the energy relaxation of an initially non-rotating, vibrationally excited ( v = 4) hydroxyl radical (OH) in an Ar bath at 300 K and at high pressures from 50 atm to 400 atm. A Morse oscillator potential represented the OH, and two sets of interaction potentials were used based on whether the Ar-H potential was a Buckingham (Exp6) or a Lennard-Jones (LJ) potential. The vibrational and rotational energies were monitored for 25 000-90 000 ps for Exp6 trajectories and 5000 ps for LJ trajectories. Comparisons to measured vibrational relaxation rates show that Exp6 rates are superior. Simulated initial vibrational relaxation rates are linearly proportional to pressure, implying no effect of high-pressure breakdown in the isolated binary collision approximation. The vibrational decay curves upward from single-exponential decay. A model based on transition rates that exponentially depend on the anharmonic energy gap between vibrational levels fits the vibrational decay well at all pressures, suggesting that anharmonicity is a major cause of the curvature. Due to the competition of vibration-to-rotation energy transfer and bath gas relaxation, the rotational energy overshoots and then relaxes to its thermal value. Approximate models with adjustable rates for this competition successfully reproduced the rotational results. These models show that a large fraction of the vibrational energy loss is initially converted to rotational energy but that fraction decreases rapidly as the vibrational energy content of OH decreases. Finally, while simulated rates change dramatically between Exp6 and LJ potentials, the mechanisms remain the same.

37 INORGANIC, ORGANIC, PHYSICAL, AND ANALYTICAL CH↗

SIESTA-SIPs: Massively parallel spectrum-slicing eigensolver for an ab initio molecular dynamics package

Integration of Shift-and-Invert Parallel spectral transformation (SIPs) eigensolver (as implemented in the SLEPc library) into an ab initio molecular dynamics package, SIESTA, is described. The effectiveness of the code is demonstrated on applications to polyethylene chains, boron nitride sheets, and bulk water clusters. For problems with the same number of orbitals, the performance of the SLEPc eigensolver depends on the sparsity of the matrices involved, favoring reduced dimensional systems such as polyethylene or boron nitride sheets in comparison to bulk systems like water clusters. For all problems investigated, performance of SIESTA-SIPs exceeds the performance of SIESTA with default solver (ScaLAPACK) at the larger number of cores and the larger number of orbitals. A method that improves the load-balance with each iteration in the self-consistency cycle by exploiting the emerging knowledge of the eigenvalue spectrum is demonstrated

ab initio↗

Anharmonic Rovibrational Partition Functions for Fluxional Species at High Temperatures via Monte Carlo Phase Space Integrals

Monte Carlo phase space integration (MCPSI) is used to compute full dimensional and fully anharmonic, but classical, rovibrational partition functions for 22 small- and medium-sized molecules and radicals. Several of the species considered here feature multiple minima and low-frequency nonlocal motions, and efficiently sampling these systems is facilitated using curvilinear (stretch, bend, and torsion) coordinates. The curvilinear coordinate MCPSI method is demonstrated to be applicable to the treatment of fluxional species with complex rovibrational structures and as many as 21 fully coupled rovibrational degrees of freedom. Trends in the computed anharmonicity corrections are discussed. For many systems, rovibrational anharmonicities at elevated temperatures are shown to vary consistently with the number of degrees of freedom and with temperature once rovibrational coupling and torsional anharmonicity are accounted for. In conclusion, larger corrections are found for systems with complex vibrational structures, such as systems with multiple large-amplitude modes and/or multiple minima.

37 INORGANIC, ORGANIC, PHYSICAL, AND ANALYTICAL CH↗

Benchmark Calculations of Energetic Properties of Groups 4 and 6 Transition Metal Oxide Nanoclusters Including Comparison to Density Functional Theory

The heats of formation and the normalized clustering energies (NCEs) for the group 4 and group 6 transition metal oxide (TMO) trimers and tetramers have been calculated by the Feller-Peterson-Dixon (FPD) method. The heats of formation predicted by the FPD method do not differ much from those previously derived from the NCEs at the CCSD(T)/aT level except for the CrO3 nanoclusters. New and improved heats of formation for Cr3O9 and Cr4O12 were obtained using PW91 orbitals instead of Hartree-Fock (HF) orbitals. Diffuse functions are necessary to predict accurate heats of formation. The fluoride affinities (FAs) are calculated with the CCSD(T) method. The relative energies (REs) of different isomers, NCEs, electron affinities (EAs), and FAs of (MO2)n ( M = Ti, Zr, Hf, n = 1 – 4 ) and (MO3)n ( M = Cr, Mo, W, n = 1 – 3) clusters have been benchmarked with 55 exchange-correlation DFT functionals including both pure and hybrid types. The absolute errors of the DFT results are mostly less than ±10 kcal/mol for the NCEs and the EAs, and less than ±15 kcal/mol for the FAs. Hybrid functionals usually perform better than the pure functionals for the REs and NCEs. The performance of the two types of functionals in predicting EAs and FAs is comparable. The B1B95 and PBE1PBE functionals provide reliable energetic properties for most isomers. Long range corrected pure functionals usually give poor FAs. The standard deviation of the absolute error is always close to the mean errors and the probability distributions of the DFT errors are often not Gaussian (normal). The breadth of the distribution of errors and the maximum probability are dependent on the energy property and the isomer.

Environmental Molecular Sciences Laboratory↗

Shift-and-invert parallel spectral transformation eigensolver: Massively parallel performance for density-functional based tight-binding

The Shift-and-invert parallel spectral transformations (SIPs), a computational approach to solve sparse eigenvalue problems, is developed for massively parallel architectures with exceptional parallel scalability and robustness. The capabilities of SIPs are demonstrated by diagonalization of density-functional based tight-binding (DFTB) Hamiltonian and overlap matrices for single-wall metallic carbon nanotubes, diamond nanowires, and bulk diamond crystals. The largest (smallest) example studied is a 128,000 (2000) atom nanotube for which ~330,000 (~5600) eigenvalues and eigenfunctions are obtained in ~190 (~5) seconds when parallelized over 266,144 (16,384) Blue Gene/Q cores. Weak scaling and strong scaling of SIPs are analyzed and the performance of SIPs is compared with other novel methods. Different matrix ordering methods are investigated to reduce the cost of the factorization step, which dominates the time-to-solution at the strong scaling limit. As a result, a parallel implementation of assembling the density matrix from the distributed eigenvectors is demonstrated.

36 MATERIALS SCIENCE↗

Pressure effects on the relaxation of an excited nitromethane molecule in an argon bath

Classical molecular dynamics simulations were performed to study the relaxation of nitromethane in an Ar bath (of 1000 atoms) at 300 K and pressures 10, 50, 75, 100, 125, 150, 300, and 400 atm. The molecule was instantaneously excited by statistically distributing 50 kcal/mol among the internal degrees of freedom. At each pressure, 1000 trajectories were integrated for 1000 ps, except for 10 atm, for which the integration time was 5000 ps. The computed ensemble-averaged rotational energy decay is ∼100 times faster than the vibrational energy decay. Both rotational and vibrational decay curves can be satisfactorily fit with the Lendvay-Schatz function, which involves two parameters: one for the initial rate and one for the curvature of the decay curve. The decay curves for all pressures exhibit positive curvature implying the rate slows as the molecule loses energy. The initial rotational relaxation rate is directly proportional to density over the interval of simulated densities, but the initial vibrational relaxation rate decreases with increasing density relative to the extrapolation of the limiting low-pressure proportionality to density. The initial vibrational relaxation rate and curvature are fit as functions of density. For the initial vibrational relaxation rate, the functional form of the fit arises from a combinatorial model for the frequency of nitromethane “simultaneously” colliding with multiple Ar atoms. Roll-off of the initial rate from its low-density extrapolation occurs because the cross section for collision events with L Ar atoms increases with L more slowly than L times the cross section for collision events with one Ar atom. The resulting density-dependent functions of the initial rate and curvature represent, reasonably well, all the vibrational decay curves except at the lowest density for which the functions overestimate the rate of decay. The decay over all gas phase densities is predicted by extrapolating the fits to condensed-phase densities.

37 INORGANIC, ORGANIC, PHYSICAL, AND ANALYTICAL CH↗