Search NASA⌕ Search

Engineering topics

Walker, D.

Publications and source records attributed to Walker, D..

At least 55 records · Page 3

Melt density and the average composition of basalt

Densities of residual liquids produced by low pressure fractionation of olivine-rich melts pass through a minimum when pyroxene and plagioclase joint the crystallization sequence. The observation that erupted basalt compositions cluster around the degree of fractionation from picritic liquids corresponding to the density minimum in the liquid line of descent may thus suggest that the earth's crust imposes a density fiber on the liquids that pass through it, favoring the eruption of the light liquids at the density minimum over the eruption of denser more fractionated and less fractionated liquids.

Stolper, E.↗

Controlled cooling and crystallization of a eucrite - Microprobe studies

The paper presents microprobe data on controlled cooling experiments on the eucrite meteorite Stannern, with emphasis on pyroxene zoning and chemistry, development of immiscible liquids in the mesostasis, and compositional boundary layer development adjacent to crystals. Controlled cooling rate experiments on melted samples of the meteorite yield a variety of petrographic textures that can be related to the cooling rate. Textures of clasts in Stannern suggest natural cooling rates of .1 to 100 C/hr for various clasts in the meteorite. Residual liquids are found to unmix at temperatures below about 990 C at moderate cooling rates. Results indicate that Stannern's pyroxenes have evidently undergone subsolidus internal cation exchange, thereby removing Fe-Mg variation in pyroxenes, lowering Al contents, and promoting exosolution.

Powell, M. A.↗

Computer Program for Assessing the Economic Feasibility of Solar Energy for Single Family Residences and Light Commercial Applications

Computer program, SHCOST, was used to perform economic analyses of operational test sites. The program allows consideration of the economic parameters which are important to the solar system user. A life cycle cost and cash flow comparison is made between a solar heating system and a conventional system. The program assists in sizing the solar heating system. A sensitivity study and plot capability allow the user to select the most cost effective system configuration.

Forney, J. A.↗

Basaltic volcanism - The importance of planet size

The volumetrically abundant basalts on the earth, its moon, and the eucrite parent planet all have chemical compositions that are controlled to a large extent by dry, low-pressure, crystal-liquid equilibria. Since this generalization is valid for these three planetary bodies, we infer that it may also apply to the other unsampled terrestrial planets. Other characteristics of basaltic volcanism show variations which appear to be related to planet size: the eruption temperatures, degrees of fractionation, and chemical variety of basalts and the endurance of basaltic volcanism all increase with planet size. Although the processes responsible for chemical differences between basalt suites are known, no simple systematization of the chemical differences between basalts from planet to planet has emerged.

Walker, D.↗

A numerical treatment of melt/solid segregation - Size of the eucrite parent body and stability of the terrestrial low-velocity zone

Crystal sinking to form cumulates and melt percolation toward segregation in magma pools can be treated with modifications of Stokes' and Darcy's laws, respectively. The velocity of crystals and melt depends, among other things, on the force of gravity (g) driving the separations and the cooling time of the environment. The increase of g promotes more efficient differentiation, whereas the increase of cooling rate limits the extent to which crystals and liquid can separate. The rate at which separation occurs is strongly dependent on the proportion of liquid that is present. The observation of cumulates and segregated melts among the eucrite meteorites is used as a basis for calculating the g (and planet size) required to perform these differentiations. The eucrite parent body was probably at least 10-100 km in radius. The earth's low velocity zone (LVZ) is shown to be unstable with respect to draining itself of excess melt if the melt forms an interconnecting network. A geologically persistent LVZ with a homogeneous distribution of melt can be maintained with melt fractions only on the order of 0.1% or less.

Walker, D.↗

Dynamic crystallization of a eucrite basalt

The textural features produced in Stannern, a non-porpyritic representative of the eucrite basaltic achondrite class of meteorite, at differing cooling rates and various degrees of initial superheating were studied. Textures produced from mildly superheated melts were found to be fasciculate rather than porphyritic as the result of the cosaturated bulk chemistry of Stannern. The qualitative type of texture apparently depends mainly on the degree of initial superheating, whereas cooling rate exerts a strong influence on the coarseness of texture. Increasing the degree of superheating produces textures from intergranular/subophitic to fasciculate/porphyritic. With initial superheating to 1200 deg C the transition to quasi-porphyritic is controlled by cooling rate, but the development of phenocrysts is merely an overprint on the fasciculate background texture of the groundmass. The suppression of fasciculate texture is completed by a decrease of the degree of initial superheating below the plagioclast entry and suppression of quasi-porphyritic texture is completed by decrease of the degree of initial superheating below pyroxene entry; these qualitative changes do not seem to be produced by changes of cooling rate. A grain size/cooling rate dependence has been used to deduce the cooling rate of fasciculate-textured Stannern clasts (10.1 to 100 deg C/hr).

Walker, D.↗

Plagioclase flotation and lunar crust formation

Anorthitic plagioclase floats in liquids parental to the lunar highlands crust. The plagioclase enrichment that is characteristic of lunar highlands rocks can be the result of plagioclase flotation. Such rocks would form a gravitationally stable upper crust on their parental magma.

Walker, D.↗

Lunar igneous rocks and the nature of the lunar interior

Lunar igneous rocks, properly interpreted, can give useful information about mineral assemblages and mineral chemistry as a function of depth in the lunar interior. Though intensely brecciated, terra rocks reveal, in their chemistry, evidence for a magmatic history. Partial melting of feldspathic lunar crustal material occurred in the interval 4.6 to 3.9 Gy. Melting of ilmenite-bearing cumulates at depths near 100 km produced parent magmas for Apollo 11 and 17 titaniferous mare basalts in the interval 3.8 to 3.6 Gy. Melting of ilmenite-free olivine pyroxenites (also cumulates?) at depths greater than 200 km produced low-titanium mare basalts in the interval 3.4 to 3.1 Gy. No younger igneous rocks have yet been recognized among the lunar samples and present-day melting seems to be limited to depths greater than 1000 km.

Hays, J. F.↗

Cooling histories of Apollo 15 quartz-normative basalts

Controlled cooling rate studies of vitrophyre 15597 are used to calculate the physical properties of a quartz-normative magma as well as cooling histories of Apollo 15 quartz-normative basalts (QNB). Pyroxene phenocrysts of a QNB magma do not settle appreciably during the cooling of the flow unit; this behavior is consistent with the small degree of chemical differentiation that occurred between members of the suite. Two types of cooling histories for QNB are discerned. The vitrophyres experienced initial slow cooling followed by rapid cooling, and the coarse-grained microgabbros underwent slow nearly linear cooling histories. Textural evidence suggests that lunar vitrophyres crystallized near the top of the flow. It is suggested that the pattern of cooling may have been caused by the chilling of liquids that inherited early crystals in the interior of the flow.

Grove, T. L.↗

Slowly cooled microgabbros 15555 and 15065

An experimental study involving equilibration of Apollo 15 samples 15555 and 15065 in high-purity iron capsules is described. Comparison of mineral zoning trends with the experimental sequence suggests that the early crystallizing phases in the rock maintained surface equilibrium with the liquid. Olivine and pyroxene chemistry indicates that 15555 cooled slightly more rapidly than 15065, which cooled at approximately 0.2-0.3 C/day. It is suggested that 15065 and 15555 represent liquid compositions, and that these liquids appear to have been fractionated during ascent through the crust (15065), or to have been derived from an olivine-pyroxene source (15555) with Fe/(Fe + Mg) approximately equal to 0.73 at a depth between 150-200 km.

Walker, D.↗

Crystallization history of lunar picritic basalt sample 12002 - Phase-equilibria and cooling-rate studies

Experimental crystallization of a lunar picrite composition (sample 12002) at controlled linear cooling rates produces systematic changes in the temperature at which crystalline phases appear, in the texture, and in crystal morphology as a function of cooling rate. Phases crystallize in the order olivine, chromium spinel, pyroxene, plagioclase, and ilmenite during equilibrium crystallization, but ilmenite and plagioclase reverse their order of appearance and silica crystallizes in the groundmass during controlled cooling experiments. The partition of iron and magnesium between olivine and liquid is independent of cooling rate, temperature, and pressure. Comparison of the olivine nucleation densities in the lunar sample and in the experiments indicates that the sample began cooling at about 1 deg C/hr. Pyroxene size, chemistry, and growth instability spacings, as well as groundmass coarseness, all suggest that the cooling rate subsequently decreased by as much as a factor of 10 or more. The porphyritic texture of this sample, then, is produced at a decreasing, rather than a discontinuously increasing, cooling rate.

Walker, D.↗

Heterogeneity in titaniferous lunar basalts

Small but real chemical differences exist between subsamples of fine-grained quench-textured titaniferous lunar basalts. The existence of different textural domains with different chemistries is thought to account for most of this variation. In addition to the textural domains, lunar sample 74275 has a population of olivine 'megacrysts' as well as dunite fragments. These materials are thought to be extraneous and to compromise the primary nature of 74275. Recognition of the small chemical variations present may aid in understanding some discrepancies in the experimental-petrology literature. However, these small variations have a distressing petrogenetic significance since they severely limit resolution in recognizing the number and depth of origin of primary magmas.

Walker, D.↗

Fe and Mg in plagioclase

Distribution coefficients for Fe and Mg between plagioclase and basaltic liquids were measured for lunar, terrestrial and synthetic systems. The data obtained imply that lunar anorthosites crystallized from relatively iron-rich liquids, that Fe/Mg zoning in plagioclase is an indicator of crystallization processes in basaltic magmas, and that Fe/Mg heterogeneity in plagioclase is a clue to the recognition of impact melts.

Longhi, J.↗

Differentiation of an Apollo 12 picrite magma

The Apollo 12 olivine basalt suite shows a strong positive correlation of grain size with normative olivine content. This correlation is interpreted to mean that the suite of samples represents the basal portion of a cooling unit which differentiated by simple olivine settling. The grain size of plagioclase observed in the coarsest samples indicates the cooling unit may have been as much as 30 m thick. The amount of olivine concentration observed in the suite is quantitatively internally consistent with simple olivine settling in a magma body of this size which has the composition of the chill margin.

Walker, D.↗

Origin of titaniferous lunar basalts

Delineation of low pressure phase equilibria in the composition space relevant to titaniferous lunar basalts demonstrates a significant degree of control by those equilibria on the compositions of the basalts. The existence of two distinct chemical groups of basalts (high and low K) which cannot be related one to the other by fractional crystallization at any pressure, suggests that melting is responsible for the two groups. Consideration of the pressure shift required to produce the differences between groups constrains magma segregation to have occurred in the outer 150 km of the moon. It is difficult to relate low-Ti and high-Ti basalts to the same source region. The preferred source region of high-Ti basalts, based on phase equilibrium considerations, is a late ilmenite-rich cumulate produced from the residual liquid of the primordial differentiation of the outer portions of the moon. This ilmenite-rich layer is sandwiched between the lunar feldspathic crust and a complementary mafic cumulate.

Walker, D.↗