Engineering topics

Walker, Don

Publications and source records attributed to Walker, Don.

4 records

DOE OSTI2022

Countdown to perovskite space launch: Guidelines to performing relevant radiation-hardness experiments

Perovskite photovoltaics (PVs) are under intensive development for promise in terrestrial energy production. Soon, the community will find out how much of that promise may become reality. Perovskites also open new opportunities for lower cost space power. However, radiation tolerance of space environments requires appropriate analysis of relevant devices irradiated under representative radiation conditions. We present guidelines designed to rigorously test the radiation tolerance of perovskite PVs. We review radiation conditions in common orbits, calculate nonionizing and ionizing energy losses (NIEL and IEL) for perovskites, and prioritize proton radiation for effective nuclear interactions. Low-energy protons (0.05-0.15 MeV) create a representative uniform damage profile, whereas higher energy protons (commonly used in ground-based evaluation) require significantly higher fluence to accumulate the equivalent displacement damage dose due to lower scattering probability. Furthermore, high-energy protons may "heal" devices through increased electronic ionization. These procedural guidelines differ from those used to test conventional semiconductors.

14 SOLAR ENERGY↗

DOE OSTI2021

Irradiation Experiments on High Efficiency Nanowire Solar Cells Including Tilted Incidence Angle

Nanowire based solar cells have promising potential to become the next generation of space solar cells. In this study we corroborate their high radiation tolerance by irradiating high efficiency GaAs (efficiency > 15 %) nanowire solar cells with 1 MeV electrons at a fluence of 10 16 e - /cm 2 . Additionally, we theoretically show that the damage in nanowire solar cells is expected to be slightly dependent on the incidence angle and the geometry of the nanowire array. However, experimentally, two sets of GaAs nanowire solar cells have been irradiated with 1 MeV electrons at normal incidence and with a 25° tilted angle exhibiting a similar degradation.

high specific power↗

DOE OSTI2020

Development of Lattice-Mismatched GaInAsP for Radiation Hardness

We develop lattice-mismatched GaInAsP as an alternative alloy to pure As-based alloys currently used in III-V multijunction solar cells. Increasing the alloy phosphorous and indium content while maintaining an optimal bandgap may allow high efficiency multijunction devices with increased radiation hardness. Here, 1.0-eV GaInAsP is developed and implemented into single and multijunction solar cell devices. The lattice-mismatched GaInAsP must be grown strain free, and the subcell thickness must be maintained below the thickness where surface-driven phase separation occurs. As observed in transmission electron microscopy and cathodoluminescence imaging, phase separation strengthens in the GaInAsP layer and leads to interfacial defect formation when the cell thickness is too great. We show single junction 1.0-eV Ga 0.5 In 0.5 As 0.7 P 0.3 with excellent carrier collection and a bandgap-voltage offset of 0.40 V. This material quality approaches that of 1.0-eV Ga 0.7 In 0.3 As used in inverted metamorphic multijunction devices, but has increased phosphorus content and consequently is expected to have a higher radiation resistance. We incorporate the 1.0-eV GaInAsP subcell into a 3-junction inverted metamorphic solar cell to test the performance of the subcell in a multijunction. No additional loss is observed upon integration into a multijunction cell: both the carrier collection and voltage of the GaInAsP subcell are unchanged from single junction devices. While further materials development and radiation testing is still required, these preliminary results indicate that lattice-mismatched GaInAsP can be effectively used in multijunction solar cells to replace radiation-soft materials.

14 SOLAR ENERGY↗

NASA NTRS2018

Li-ion 18650 Thermal Runaway Particulate Analysis

Three types of atmospheres were tested for their effects on the particulates generated in a lithium ion (Li-ion) battery thermal runaway. Normal laboratory air (Ambient), a mixture of 23.5% O2/76.5% N2 meant to simulate the atmosphere on the International Space Station (ISS), and Vacuum environments were tested. Samsung 26F 18650 cells were driven to thermal runaway using heater tape, and the resultant particulates were collected analyzed using SEM/EDX, FTIR, GCMS, as well as conductivity and magnetic probes. All three conditions generated dense black particulate films composed of very fine carbon and metal particles. These films, however, were not very conductive, though individual particulates would be, and the particles demonstrated weak paramagnetism. FTIR and GCMS identified a substantial amount of volatile components in the particulate films, both organic partial combustion products, but also electrolyte salt products.

Nemanick, E. Joseph↗