Engineering topics
Publications and source records attributed to Walowit, J..
Report describes engineering study of proposed use of damping seals as major load-carrying members of high-pressure-oxygen turbopump of Space Shuttle main engine. Incorporated into bearing packages at preburner-pump and turbine-end locations on pump rotor. Concept motivated by need to increase operating lives of ball bearings supporting rotor by relieving them of damaging transient lateral loads.
Analyses and predicted performance of a 50-mm diameter, spiral-groove face seal to seal liquid oxygen at 5.17 MPa pressure, and operating at surface speeds of 183 m/s are described. The pressure-balanced spiral-groove concept is introduced that circulates spiral-groove flow independent of leakage flow. Independent flow paths preclude overheating from vaporization and consequent flow blockage. The analysis accounts for fluid turbulence and inertia, thermoelastic distortions, and dynamic response. An operating-range map was developed as a function of speed and pressure. The fluid-film analysis is summarized in the Appendix.
The design and construction of a reciprocating test vehicle to be used in evaluating hydrodynamic oil pumping rings are discussed. In addition, experimental test data are presented for three pumping ring designs that were constructed from Tin-Based Babbitt (SAE 11), Bearing Bronze (SAE 660), and Mechanical Carbon Graphite (Union Carbide Grade CNF-J). Data of pumped flow rate versus delivered pressure, as well as friction loss, are reported for the following conditions: frequencies of 10, 35 and 45 Hz; strokes of 25.4 mm (1.00 in.), 38.1 mm (1.50 in.) and 50.8 mm (2.00 in.) oil inlet temperature of 49 degrees (120 degrees); and pumping ring close-in pressures of 10.3 MPa (1500 lb/square inch. A 20W40 automotive oil was used for all tests. The maximum delivered pressure was 11 MPa (1600 lb/square inch. An analysis of hydrodynamic oil pumping rings was performed and the results of the analysis were compared to measured test data.