Search NASA⌕ Search

Engineering topics

Wang, D.

Publications and source records attributed to Wang, D..

At least 55 records · Page 3

Simultaneous metal-insulator and antiferromagnetic transitions in orthorhombic perovskite iridate Sr 0.94 Ir 0.78 O 2.68 single crystals

The orthorhombic perovskite SrIrO 3 is a semimetal, an intriguing exception in iridates where the strong spin-orbit interaction coupled with electron correlations tends to impose an insulating state. Here, we report results of our investigation of bulk single-crystal Sr 0.94 Ir 0.78 O 2.68 or Ir-deficient, orthorhombic perovskite SrIrO 3 . It retains the same crystal structure as stoichiometric SrIrO 3 but exhibits a sharp, simultaneous antiferromagnetic (AFM) and metal-insulator (MI) transition occurring in the basal-plane resistivity at 185 K. Above it, the basal-plane resistivity features an extended regime of almost linear temperature dependence up to 800 K but the strong electronic anisotropy renders an insulating behavior in the out-of-plane resistivity. The Hall resistivity undergoes an abrupt sign change and grows below 40 K, which along with the Sommerfeld constant of 20 mJ/mol K 2 suggests a multiband effect. All results including our first-principles calculations underscore a delicacy of the paramagnetic, metallic state in SrIrO 3 that is in close proximity to an AFM insulating state. The contrasting ground states in isostructural Sr 0.94 Ir 0.78 O 2.68 and SrIrO 3 illustrate a critical role of lattice distortions and Ir deficiency in rebalancing the ground state in the iridates. Finally, the concurrent AFM and MI transitions reveal a direct correlation between the magnetic transition and formation of an activation gap in the iridate, which is conspicuously absent in Sr 2 IrO 4 .

75 CONDENSED MATTER PHYSICS, SUPERCONDUCTIVITY AND↗

EFFECT OF STRAIN FIELD ON THRESHOLD DISPLACEMENT ENERGY OF TUNGSTEN STUDIED BY MOLECULAR DYNAMICS SIMULATION

The influence of hydrostatic strain on point defect formation energy and threshold displacement energy (Ed) in body-centered cubic (BCC) tungsten was studied with molecular dynamics simulations. Two different tungsten potentials (Fikar and Juslin) were used. The minimum Ed direction calculated with the Fikar-potential was <100>, but with the Juslin-potential it was <111>. The most stable self-interstitial (SIA) configuration was a <111>-crowdion for both potentials. The stable SIA configuration did not change with applied strain. Varying the strain from compression to tension increased the vacancy formation energy but decreased the SIA formation energy. The SIA formation energy changed more significantly than for a vacancy such that Ed decreased with applied strain from compression to tension.

Wang, D.↗

Nanoscale morphology of Ni{sub 50}Ti{sub 45}Cu{sub 5} nanoglass

Nanoglasses are noncrystalline solids with a granular nano-/microstructure. In contrast to their nanocrystalline analogs, typically constituted of grains and grain boundaries, nanoglasses consist of glassy regions with a structure corresponding to melt-quenched glasses and amorphous interfaces characterized by a reduced density. Their unique properties can be controlled by modifying size and chemical composition of the granular and interfacial regions. Ni{sub 50}Ti{sub 45}Cu{sub 5} amorphous films were obtained by magnetron sputtering and analyzed to determine their nanoscale morphology and the formation mechanisms. The nanoglasses were noted to have a hierarchical nano-columnar structure with the smallest Ni-rich (Ni:Ti ratio of ca. 5:3) amorphous columns with diameters of about 8 nm and Ti-rich glassy interfacial regions with a substantially lower density. The results were obtained utilizing X-ray diffraction and different microscopic methods, e.g., atomic force microscopy and transmission electron microscopy. A detailed analysis indicates the complexity of the formation mechanisms of topologically and chemically distinguishable structural units with curvature driven surface diffusion, surface mobility, self-shadowing and internal stresses as the most important parameters. Common and simple synthesis method and the possibility for easy modification of the morphology and, consequently, the physical properties offer an opportunity for intensive studies of this new class of materials, opening the way towards possible applications. - Highlights: • Ni{sub 50}Ti{sub 45}Cu{sub 5} thin film nanoglasses were synthesized by magnetron sputtering. • Ti amorphous interfacial phase with reduced density is observed. • Stabilization of interfaces by specific local thermodynamic conditions.

36 MATERIALS SCIENCE↗

Interaction of an ultrarelativistic electron bunch train with a W-band accelerating structure: High power and high gradient

Electron beam interaction with high frequency structures (beyond microwave regime) has a great impact on future high energy frontier machines. We report on the generation of multimegawatt pulsed rf power at 91 GHz in a planar metallic accelerating structure driven by an ultrarelativistic electron bunch train. This slow-wave wakefield device can also be used for high gradient acceleration of electrons with a stable rf phase and amplitude which are controlled by manipulation of the bunch train. To achieve precise control of the rf pulse properties, a two-beam wakefield interferometry method was developed in which the rf pulse, due to the interference of the wakefields from the two bunches, was measured as a function of bunch separation. As a result, measurements of the energy change of a trailing electron bunch as a function of the bunch separation confirmed the interferometry method.

Wang, D.↗

Two-dimensional percolation threshold in confined Si nanoparticle networks

Non-percolating and percolating silicon quantum dot (QD) networks were investigated by plane-view energy filtered transmission electron microscopy (EF-TEM). The Si QD networks were prepared by plasma enhanced chemical vapor deposition on free standing 5 nm Si{sub 3}N{sub 4} membranes, followed by high temperature annealing. The percolation threshold from non-percolating to percolating networks is found to be in between a SiO{sub x} stoichiometry of SiO{sub 0.5} up to SiO{sub 0.7}. Using the EF-TEM images, key structural parameters of the Si QD ensemble were extracted and compared, i.e., their size distribution, nearest neighbor distance, and circularity. Increasing the silicon excess within the SiO{sub x} layer results in an ensemble of closer spaced, less size-controlled, and less circular Si QDs that give rise to coupling effects. Furthermore, the influence of the structural parameters on the optical and electrical Si QD ensemble properties is discussed.

36 MATERIALS SCIENCE↗

Measurement of the target-normal single-spin asymmetry in quasielastic scattering from the reaction He 3 ↑ ( e , e ' )

We report the first measurement of the target single-spin asymmetry, Ay, in quasi-elastic scattering from the inclusive reaction 3 He↑ (e,e') on a 3 He gas target polarized normal to the lepton scattering plane. Assuming time-reversal invariance, this asymmetry is strictly zero for one-photon exchange. A non-zero A y can arise from the interference between the one- and two-photon exchange processes which is sensitive to the details of the sub-structure of the nucleon. An experiment recently completed at Jefferson Lab yielded asymmetries with high statistical precision at Q 2 = 0.13, 0.46 and 0.97 GeV 2 . These measurements demonstrate, for the first time, that the 3He asymmetry is clearly non-zero and negative with a statistical significance of (8-10)σ. Using measured proton-to- 3 He cross-section ratios and the effective polarization approximation, neutron asymmetries of -(1-3)% were obtained. The neutron asymmetry at high Q 2 is related to moments of the Generalized Parton Distributions (GPDs). Our measured neutron asymmetry at Q 2 =0.97 GeV 2 agrees well with a prediction based on two-photon exchange using a GPD model and in addition provides a new independent constraint on these distributions.

72 PHYSICS OF ELEMENTARY PARTICLES AND FIELDS↗

Effect of minor carbon additions on the high-temperature creep behavior of a single-crystal nickel-based superalloy

Different amounts of carbon were added to a single-crystal nickel-based superalloy. The microstructural evolution of these alloys before and after high-temperature creep tests was investigated by employing scanning electron microscopy and transmission electron microscopy. Upon increasing the carbon contents, the volume fraction and diameter of the carbides increased gradually: however, the creep lives of the alloys increased slightly at first and subsequently decreased. The formation of second-phase particles, such as the nano-sized M{sub 23}C{sub 6}, blocky and needle-shaped μ phase, was observed in the creep samples, which was closely related to the high-temperature creep behaviors. - Highlights: • Creep behaviors of alloys with different amounts of carbon were investigated. • The creep rupture lives increased and later decreased with more carbon. • Second-phase particles were responsible for the different creep behaviors.

36 MATERIALS SCIENCE↗

Measurement of parity-violating asymmetry in electron-deuteron inelastic scattering

The parity-violating asymmetries between a longitudinally polarized electron beam and an unpolarized deuterium target have been measured recently. The measurement covered two kinematic points in the deep-inelastic scattering region and five in the nucleon resonance region. We provide here details of the experimental setup, data analysis, and results on all asymmetry measurements including parity-violating electron asymmetries and those of inclusive pion production and beam-normal asymmetries. The parity-violating deep-inelastic asymmetries were used to extract the electron-quark weak effective couplings, and the resonance asymmetries provided the first evidence for quark-hadron duality in electroweak observables. These electron asymmetries and their interpretation were published earlier, but are presented here in more detail.

Wang, D.↗

Adaptive cluster expansion approach for predicting the structure evolution of graphene oxide

An adaptive cluster expansion (CE) method is used to explore surface adsorption and growth processes. Unlike the traditional CE method, suitable effective cluster interaction (ECI) parameters are determined, and then the selected fixed number of ECIs is continually optimized to predict the stable configurations with gradual increase of adatom coverage. Comparing with traditional CE method, the efficiency of the adaptive CE method could be greatly enhanced. As an application, the adsorption and growth of oxygen atoms on one side of pristine graphene was carefully investigated using this method in combination with first-principles calculations. The calculated results successfully uncover the structural evolution of graphene oxide for the different numbers of oxygen adatoms on graphene. The aggregation behavior of the stable configurations for different oxygen adatom coverages is revealed for increasing coverages of oxygen atoms. As a targeted method, adaptive CE can also be applied to understand the evolution of other surface adsorption and growth processes.

37 INORGANIC, ORGANIC, PHYSICAL, AND ANALYTICAL CH↗

Draft Genome Sequence of Enterobacter cloacae Strain S611

We report draft genomes of Enterobacter cloacae strain S611, an endophytic bacterium isolated from surface-sterilized germinating wheat seeds. We present the assembly and annotation of its genome, which may provide insights into the metabolic pathways involved in adaptation.

59 BASIC BIOLOGICAL SCIENCES↗

Measurement of Double-Polarization Asymmetries in the Quasielastic He → 3 ( e → , e ' d ) Process

We present a precise measurement of double-polarization asymmetries in the 3 He(e,e'd) reaction. This particular process is a uniquely sensitive probe of hadron dynamics in 3He and the structure of the underlying electromagnetic currents. The measurements have been performed in and around quasi-elastic kinematics at Q 2 =0.25(GeV/c) 2 for missing momenta up to 270MeV/c. The asymmetries are in fair agreement with the state-of-the-art calculations in terms of their functional dependencies on pm and omega, but are systematically offset. Beyond the region of the quasi-elastic peak, the discrepancies become even more pronounced. Thus, our measurements have been able to reveal deficiencies in the most sophisticated calculations of the three-body nuclear system, and indicate that further refinement in the treatment of their two- and/or three-body dynamics is required.

73 NUCLEAR PHYSICS AND RADIATION PHYSICS↗

Fluorinated Electrolytes for Li-S Battery: Suppressing the Self-Discharge with an Electrolyte Containing Fluoroether Solvent

The fluorinated electrolyte containing a fluoroether 1,1,2,2-tetrafluoroethyl-2,2,3,3-tetrafluoropropyl ether (TTE) was investigated as a new electrolyte for lithium-sulfur (Li-S) batteries. The low solubility of lithium polysulfides (LiPS) in the fluorinated electrolyte reduced the parasitic reactions with Li anode and mitigated the self-discharge by limiting their diffusion from the cathode to the anode. The use of fluorinated ether as a co-solvent and LiNO3 as an additive in the electrolyte shows synergetic effect in suppressing the self-discharge of Li-S battery due to the formation of the solid electrolyte interphase (SEI) on both sulfur cathode and the lithium anode. The Li-S cell with the fluorinated electrolyte showed prolonged shelf life at fully charged state.

Fluorinated electrolyte↗

Underground Coal Thermal Treatment: Task 6 Topical Report, Utah Clean Coal Program

The long-term objective of this task is to develop a transformational energy production technology by in- situ thermal treatment of a coal seam for the production of substitute natural gas and/or liquid transportation fuels while leaving much of the coal’s carbon in the ground. This process converts coal to a high-efficiency, low-greenhouse gas (GHG) emitting fuel. It holds the potential of providing environmentally acceptable access to previously unusable coal resources. This task focused on three areas: Experimental. The Underground Coal Thermal Treatment (UCTT) team focused on experiments at two scales, bench-top and slightly larger, to develop data to understand the feasibility of a UCTT process as well as to develop validation/uncertainty quantification (V/UQ) data for the simulation team. Simulation. The investigators completed development of High Performance Computing (HPC) simulations of UCTT. This built on our simulation developments over the course of the task and included the application of Computational Fluid Dynamics (CFD)- based tools to perform HPC simulations of a realistically sized domain representative of an actual coal field located in Utah. CO 2 storage. In order to help determine the amount of CO 2 that can be sequestered in a coal formation that has undergone UCTT, adsorption isotherms were performed on coals treated to 325, 450, and 600°C with slow heating rates. Raw material was sourced from the Sufco (Utah), Carlinville (Illinois), and North Antelope (Wyoming) mines. The study indicated that adsorptive capacity for the coals increased with treatment temperature and that coals treated to 325°C showed less or similar capacity to the untreated coals.

Smith, P.J.↗