Engineering topics

Wang, Jinxue

Publications and source records attributed to Wang, Jinxue.

4 records

NASA NTRS2010

Advances in HgCdTe APDs and LADAR Receivers

Raytheon is developing NIR sensor chip assemblies (SCAs) for scanning and staring 3D LADAR systems. High sensitivity is obtained by integrating high performance detectors with gain i.e. APDs with very low noise Readout Integrated Circuits. Unique aspects of these designs include: independent acquisition (non-gated) of pulse returns, multiple pulse returns with both time and intensity reported to enable full 3D reconstruction of the image. Recent breakthrough in device design has resulted in HgCdTe APDs operating at 300K with essentially no excess noise to gains in excess of 100, low NEP <1nW and GHz bandwidths and have demonstrated linear mode photon counting. SCAs utilizing these high performance APDs have been integrated and demonstrated excellent spatial and range resolution enabling detailed 3D imagery both at short range and long ranges. In this presentation we will review progress in high resolution scanning, staring and ultra-high sensitivity photon counting LADAR sensors.

Bailey, Steven↗

NASA NTRS2005

Compact, Engineered, 2-Micron Coherent Doppler Wind Lidar Prototype: A New NASA Instrument Incubator Program Project

A new project, selected in 2005 by NASA s Science Mission Directorate (SMD) under the Instrument Incubator Program (IIP), will be described. The 3-year effort is intended to design, fabricate, and demonstrate a packaged, rugged, compact, space-qualifiable coherent Doppler wind lidar (DWL) transceiver capable of future validation in an aircraft and/or Unmanned Aerial Vehicle (UAV). The packaged DWL will utilize the numerous advances in pulsed, solid-state, 2-micron laser technology at NASA s Langley Research Center (LaRC) in such areas as crystal composition, architecture, efficiency, cooling techniques, pulse energy, and beam quality. The extensive experience of Raytheon Space and Airborne Systems (RSAS) in coherent lidar systems, in spacebased sensors, and in packaging rugged lidar systems will be applied to this project. The packaged transceiver will be as close to an envisioned space-based DWL system as the resources and technology readiness allow. We will attempt to facilitate a future upgrade to a coherent lidar system capable of simultaneous wind and CO2 concentration profile measurements. Since aerosol and dust concentration is also available from the lidar signal, the potential for a triple measurement lidar system is attractive for both Earth and Mars remote sensing. A key follow on step after the IIP will be to add a telescope, scanner, and software for aircraft validation. This IIP should also put us in a position to begin a parallel formulation study in the 2006-2007 timeframe for a space-based DWL demonstration mission early next decade.

Kavaya, Michael J.↗

NASA NTRS1995

MODTRAN3: An update and recent validations against airborne high resolution interferometer measurements

MODTRAN, the Moderate Resolution Atmospheric Radiance and Transmittance Model, encompasses all the capabilities of LOWTRAN 7, the widely used 20 cm(exp -1) resolution radiance code, but incorporates a much more sensitive molecular band model with 2 cm(exp -1) resolution. MODTRAN contains many important elements that other band model based radiative transfer codes do not incorporate. It shares with FASCODE: spherical geometry, single and multiple scattering default atmospheric profile descriptors (gases, aerosols, clouds, fogs, and rain), and molecular continua (H2O, CO2, O3, O2, N2). In addition, it can calculate the solar/lunar direct and scattered radiation. MODTRAN3 was released to the general public in November 1994. It has several important features that the previous version, MODTRAN2, does not have. Chloro-fluorocarbon (CFC) and related heavy molecules (whose spectroscopic properties first appear on the HITRAN92 data base as temperature-dependent cross sections) have been incorporated into pseudo-band models, with provision for using both default and user supplied profiles. The addition of SO2 and O2 in the UV, along with upgraded ozone Chappuis bands in the visible is also part of MODTRAN3. An improved multiple scattering algorithm, the DIScrete Ordinate Radiative Transfer (DISORT) has also been incorporated into MODTRAN3. MODTRAN is very fast: simple timing runs of MODTRAN3 vs. FASCOD3 show an improvement of more than a factor of 100 for a typical 500 cm(exp -1) spectral interval and comparable vertical layering. Speed is an important consideration in heating/cooling rates calculations, where a large number of radiative transfer calculations are needed. The MODTRAN3 used in this study is based on HITRAN92, but as mentioned, above, it will be upgraded to HITRAN94 upon its release at the end of 1994. MODTRAN has been adopted by: some researchers in the AVIRIS program as one radiative transfer code to derive surface reflectance from AVIRIS measurements. The accuracy of the code is very important because any errors in the radiative transfer calculation will directly translate into errors in the derived surface reflectance. In this paper, the new solar irradiance calculated by Kurucz, which is adopted in MODTRAN3, will be presented. Recent validations of MODTRAN3 with airborne high resolution interferometer measurements over ocean will be discussed. Good agreeement between model calculations and measurements was achieved.

Anderson, Gail P.↗

NASA NTRS1993

Remote sounding of tropospheric minor constituents

The etalon interferometer, or Fabry-Perot interferometer (FPI), with its high throughput and high spectral resolution was widely used in the remote-sensing measurements of the earth's atmospheric composition, winds, and temperatures. The most recent satellite instruments include the Fabry-Perot interferometer flown on the Dynamics Explorer-2 (DE-2) and the High Resolution Doppler Imager (HRDI) to be flown on the Upper Atmosphere Research Satellite (UARS). These instruments measure the Doppler line profiles of the emission and absorption of certain atmospheric species (such as atomic oxygen) in the visible spectral region. The successful space flight of DE-FPI and the test and delivery of UARS-HRDI demonstrated the extremely high spectral resolution and ruggedness of the etalon system for the remote sensing of earth and planetary atmospheres. Recently, an innovative FPI focal plane detection technique called the Circle-to-Line Interferometer Optical (CLIO) system was invented at the Space Physics Research Laboratory (SPRL). The CLIO simplifies the FPI focal plane detection process by converting the circular rings or fringes into a linear pattern similar to that produced by a conventional spectrometer, while retaining the throughput advantage of the etalon interferometer. CLIO makes the use of linear array detectors more practical and efficient with FPI, the combination of FPI and CLIO represents a very promising new technique for the remote sensing of the lower atmospheres of Earth, Mars, Venus, Neptune, and other planets. The Multiorder Etalon Spectrometer (MOES), as a combination of the rugged etalon and the CLIO, compares very favorably to other spaceborne optical instruments in terms of performance versus complexity. The feasibility of an advanced etalon spectrometer for the remote sensing of tropospheric trace species, particularly carbon monoxide (CO), nitrous oxide (N2O), and methane (CH4) was discussed. The etalon atmospheric spectroscopy techniques are described, instrument design and related technical issues are discussed. The primary objective is to establish the concept of atmospheric spectroscopy with the CLIO and etalon system and its applications for the measurements of tropospheric trace species analyze system requirements and performance, determine the feasibility of components and subsystem implementation with available technology, and develop inversion algorithm for retrieval simulation and data analysis.

Drayson, S. Roland↗