Search NASA⌕ Search

Engineering topics

Wang, Junlan

Publications and source records attributed to Wang, Junlan.

All solid thick oxide cathodes based on low temperature sintering for high energy solid batteries

Solid-state batteries (SSBs) could significantly improve the safety and energy density over conventional liquid cells. One key enabling technology is the use of solid electrolytes. NASICON-type Li 1.3 Al 0.3 Ti 1.7 (PO 4 ) 3 (LATP) is a very attractive solid-state electrolyte for the cathode side due to its high oxidation potential and high ionic conductivity. The usage, however, is limited by its large interfacial resistance against most of the cathode materials as well as the thermodynamic instability during high temperature sintering needed to achieve high mass density. Here we construct thin, percolative, and mixed conductive interphases through in situ low-melting-point liquid sintering. These mixed conductive interphases drastically improve the kinetics, leading to high-loading solid LATP/LiCoO 2 cathodes achieving capacity loading of up to ~6 mA h cm –2 . The technique is also applicable to Ni-rich cathode materials, achieving up to ~10 mAh cm –2 , which can lead to more than 400 W h kg –1 cells in SSBs. Furthermore, our composite cathodes show a ten-times and three-times area capacity improvement over the state-of-the-art cathodes using oxide and sulfide SSEs, respectively.

25 ENERGY STORAGE↗

Influence of grain size on transition temperature of thermochromic VO{sub 2}

Vanadium(IV) oxide (VO{sub 2}) is a unique material that undergoes a reversible phase transformation around 68 °C. The material could potentially be used as an energy-efficient coating for windows since its reflectance in the infrared (IR) increases significantly more than in the visible region. Currently, VO{sub 2} is limited by a transition temperature (τ{sub c}) that is too high, luminous transmittance that is too low or both. In this study, a transition temperature of 45 °C is achieved for a reactively sputtered, undoped film by restricting grain size to approximately 30 nm. It is concluded that a higher density of grain boundaries (smaller grain size) provides a greater number of nucleating defects which in turn reduces τ{sub c}. Similarly, a higher density of grain boundaries may reduce the hysteresis width (difference between transition temperatures in heating and cooling). Also in this study, a new set of optical performance metrics is proposed in which the solar spectrum is divided into the ultraviolet (UV), visible and near infrared (NIR) regions. This approach is more closely aligned with the goals of limiting UV, allowing luminous and modulating NIR transmission. Using these metrics, the optical properties of the low-τ{sub c} sample were: 2% UV transmittance, 47% luminous transmittance, and 23% NIR modulation (decrease from 43 to 33%). This study demonstrates that the grain size of VO{sub 2} should be viewed as an important parameter for controlling the transition temperature of the material.

75 CONDENSED MATTER PHYSICS, SUPERCONDUCTIVITY AND↗