Gas sensor incorporating a porous framework
The disclosure provides sensor for gas sensing including CO.sub.2 gas sensors comprising a porous framework sensing area for binding an analyte gas.
Engineering topics
Publications and source records attributed to Wang, Kang L.
The disclosure provides sensor for gas sensing including CO.sub.2 gas sensors comprising a porous framework sensing area for binding an analyte gas.
We present the analysis of linewidth roughness (LWR) in nanowire-mask-based graphene nanoribbons (GNRs) and evaluate its impact on the device performance. The data show that the LWR amplitude decreases with the GNR width, possibly due to the etching undercut near the edge of a nanowire-mask. We further discuss the large variation in GNR devices in the presence of LWR by analyzing the measured transport properties and on/off ratios.
In this paper, we report the epitaxial growth of Bi{sub 2}Se{sub 3} thin films on Si (111) substrate, using molecular beam epitaxy (MBE). We show that the as-grown samples have good crystalline quality, and their surfaces exhibit terracelike quintuple layers. Angel-resolved photoemission experiments demonstrate single-Dirac-conelike surface states. These results combined with the temperature- and thickness-dependent magneto-transport measurements, suggest the presence of a shallow impurity band. Below a critical temperature of {approx}100K, the surface states of a 7 nm thick film contribute up to 50% of the total conduction.
In this paper, we will show that efficiency of multi-crystalline silicon (mc-Si) solar cells may be improved by acid texturization. In order to enhance overall efficiency of mc-Si for solar-cell applications, the surface treatment of texturization with wet etching using appropriate solutions can improve incident light into the cell. Alkali etchant cannot produce uniformly textured surface to generate enough open circuit voltage (V{sub OC}) and high efficiency of the mc-Si due to the unavoidable grain randomly oriented with higher steps formed during etching process. Optimized acid etching conditions can be obtained by decreasing the reflectance (R) for mc-Si substrate below levels generated by alkali etching. Short-circuit current (I{sub SC}) measurements on acid textured cells reveal that current gain can be significantly enhanced by reducing reflection. The optimal acid etching ratio HF:HNO{sub 3}:H{sub 2}O = 15:1:2.5 with etching time of 60 s and lowering 42.7% of the R value can improve 112.4% of the conversion efficiency ({eta}) of the developed solar cell. In order to obtain more detailed information of different defect region, high-resolution light beam induced current (LBIC) is applied to measure the internal quantum efficiency (IQE) and the lifetime of minority carriers. Thus, the acid texturing approach is instrumental to achieve high efficiency in mass production using relatively low-cost mc-Si as starting material with proper optimization of the fabrication steps. (author)
A low temperature Al{sub 2}O{sub 3}/4 monolayer amorphous Si gate stack process was demonstrated on p-type Ge wafers using atomic layer deposition and molecular beam epitaxy. Multifrequency capacitance-voltage (C-V) and current-voltage (I-V) characteristics showed excellent electrical properties of the Pt/Al{sub 2}O{sub 3}/4 ML Si/Ge metal oxide semiconductor capacitor. No kinks from 1 MHz to 4 kHz and a leakage current density of 2.6x10{sup -6} A/cm{sup 2} at 1 V with an equivalent oxide thickness of 2.5 nm. The interface characterization using a conductance method showed that interface trap density at the near midgap was 8x10{sup 12} eV{sup -1} cm{sup -2} and a mean capture cross section of holes was extracted to be 10{sup -16} cm{sup 2}.
No abstract prepared.