Engineering topics

Waters, M. H.

Publications and source records attributed to Waters, M. H..

At least 19 records

NASA NTRS1992

Structural and aerodynamic considerations for an oblique all-wing aircraft

A key design issue for the Oblique All-Wing aircraft is the packaging of the payload compartment, the fuel tanks, and the other internal components within the airfoil. The internal arrangement of such vehicles is strongly coupled to the exterior vehicle geometry. For example, the height requirements of a passenger cabin directly influence the aircraft thickness and span. As a result, the internal arrangement strongly affects aerodynamic performance and structural weight. Configuration criteria are defined and/or discussed, and a baseline aircraft is developed. Also, some of the major tradeoffs that affect structural weight and aerodynamic performance are presented.

Waters, M. H.↗

NASA NTRS1983

Vertical Profiles for Turbojet-Powered Aircraft

OPTIM generates profile of altitude, airspeed, and flightpath angle as function of range between given set or origin and destination points for particular models of transport aircraft. Profile is optimized in sense of minimizing fuel or time or in minimizing direct operating cost expressed as combination of fuel and time.

Sorensen, J. A.↗

NASA NTRS1983

Computer programs for generation and evaluation of near-optimum vertical flight profiles

Two extensive computer programs were developed. The first, called OPTIM, generates a reference near-optimum vertical profile, and it contains control options so that the effects of various flight constraints on cost performance can be examined. The second, called TRAGEN, is used to simulate an aircraft flying along an optimum or any other vertical reference profile. TRAGEN is used to verify OPTIM's output, examine the effects of uncertainty in the values of parameters (such as prevailing wind) which govern the optimum profile, or compare the cost performance of profiles generated by different techniques. A general description of these programs, the efforts to add special features to them, and sample results of their usage are presented.

Sorensen, J. A.↗

NASA NTRS1981

Airborne method to minimize fuel with fixed time-of-arrival constraints

A method for generating a minimum-fuel, fixed-range, fixed-time-of-arrival flight path in an on-board flight management system computer for commercial aircraft is described. It is shown that up to 6% of the fuel otherwise used can be saved by means of this capability, despite time-of-arrival delays of up to 30 min, by a medium-range, tri-jet transport aircraft.

Sorensen, J. A.↗

NASA NTRS1981

Generation of optimum vertical profiles for an advanced flight management system

Algorithms for generating minimum fuel or minimum cost vertical profiles are derived and examined. The option for fixing the time of flight is included in the concepts developed. These algorithms form the basis for the design of an advanced on-board flight management system. The variations in the optimum vertical profiles (resulting from these concepts) due to variations in wind, takeoff mass, and range-to-destination are presented. Fuel savings due to optimum climb, free cruise altitude, and absorbing delays enroute are examined.

Sorensen, J. A.↗

NASA NTRS1980

Practical solutions to the aircraft minimum fuel, fixed-range, fixed time-of-arrival trajectory optimization problem

A practical scheme is presented for generating fixed range, minimum fuel vertical flight profiles that also satisfy time-of-arrival constraints. The resulting algorithm is suitable for incorporation into an on-board flight management system. Example results show that such a capability can save up to 6% of fuel burned in flights subject to delays because of terminal area congestion.

Sorensen, J. A.↗

NASA NTRS1978

Requirements for regional short-haul air service and the definition of a flight program to determine neighborhood reactions to small transport aircraft

An evaluation of the current status and future requirements of an intraregional short haul air service is given. A brief definition of the different types of short haul air service is given. This is followed by a historical review of previous attempts to develop short haul air service in high density urban areas and an assessment of the current status. The requirements for intraregional air service, the need for economic and environmental viability and the need for a flight research program are defined. A detailed outline of a research program that would determine urban community reaction to frequent operations of small transport aircraft is also given. Both the operation of such an experiment in a specific region (San Francisco Bay area) and the necessary design modifications of an existing fixed wing aircraft which could be used in the experiment are established. An estimate is made of overall program costs.

Feher, K.↗

NASA NTRS1977

Analysis of turbofan propulsion system weight and dimensions

Weight and dimensional relationships that are used in aircraft preliminary design studies are analyzed. These relationships are relatively simple to prove useful to the preliminary designer, but they are sufficiently detailed to provide meaningful design tradeoffs. All weight and dimensional relationships are developed from data bases of existing and conceptual turbofan engines. The total propulsion system is considered including both engine and nacelle, and all estimating relations stem from physical principles, not statistical correlations.

Waters, M. H.↗

NASA NTRS1976

Conceptual design of reduced energy transports

The paper reports the results of a conceptual design study of new near-term fuel-conservative aircraft. A parametric study was made to determine the effects of cruise Mach number and fuel cost on the optimum configuration characteristics and relative economic performance. Supercritical wing technology and advanced engine cycles were assumed. For each design, the wing geometry was selected to maximize an economic figure of merit which reflects the potential rate of return on investment. Based on the results of the parametric study, a reduced energy configuration was selected. Compared with existing transport design, the reduced energy design has a higher aspect ratio wing with lower sweep, and cruises at a slightly lower Mach number. It yields about 30% more seat-miles/gal than current wide-body aircraft. At the higher fuel costs anticipated in the future, the reduced energy design has about the same economic performance as existing designs with the same technology level. As an example of a far-term technology application, a design with a composite material wing was also investigated.

Ardema, M. D.↗

NASA NTRS1976

Thrust and wing loading requirements for short haul aircraft constrained by engine noise and field length

Propulsion system and wing loading requirements are determined for a mechanical flap and an externally blown flap aircraft for various engine noise levels and two engine cycles. Both aircraft are sized to operate from a 914m (3000 ft) runway and perform the same mission. For each aircraft concept, propulsion system sizing is demonstrated for two different engine cycles - one having a fan pressure ratio of 1.5 and a bypass ratio of 9, and the other having a fan pressure ratio of 1.25 and a bypass ratio of 17.8. The results presented include the required thrust-to-weight ratio, wing loading, resulting gross weight, and direct operating costs, as functions of the engine noise level, for each combination of engine cycle and aircraft concept.

Bowles, J. V.↗

NASA NTRS1975

Design of short haul aircraft for fuel conservation

Current jet fuel prices of twice the 1972 level have significantly changed the characteristics of airplane design for best economy. The results of a contract with the NASA Ames Advanced Concepts and Missions Division confirmed the economic desirability of lower design cruise speeds and higher aspect-ratio wings compared to designs developed in the by-gone era of low fuel price. Evaluation of potential fuel conservation for short-haul aircraft showed that an interaction of airfoil technology and desirable engine characteristics is important: the supercritical airfoil permits higher aspect ratio wings with lower sweep; these, in turn, lower the cruise thrust requirements so that engines with higher bypass ratios are better matched in terms of lapse rate; lower cruise speeds (which are also better for fuel and operating cost economy) push the desired bypass ratio up further. Thus, if fuel prices remain high, or rise further, striking reductions in community noise level can be achieved as a fallout in development of a 1980s airplane and engine. Analyses are presented of developmental trends in the design of short-haul aircraft with lower cruise speeds and higher aspect-ratio wings, and the effects on fuel consumption of design field length, powered lift concepts, and turboprop as well as turbofan propulsion are discussed.

Bowden, M. K.↗

NASA NTRS1975

Conceptual design of reduced energy transports

This paper reports the results of a conceptual design study of new, near-term fuel-conservative aircraft. A parametric study was made to determine the effects of cruise Mach number and fuel cost on the 'optimum' configuration characteristics and on economic performance. Supercritical wing technology and advanced engine cycles were assumed. For each design, the wing geometry was optimized to give maximum return on investment at a particular fuel cost. Based on the results of the parametric study, a reduced energy configuration was selected. Compared with existing transport designs, the reduced energy design has a higher aspect ratio wing with lower sweep, and cruises at a lower Mach number. It yields about 30% more seat-miles/gal than current wide-body aircraft. At the higher fuel costs anticipated in the future, the reduced energy design has about the same economic performance as existing designs.

Ardema, M. D.↗

NASA NTRS1975

Summary of the recent short-haul systems studies

The results of several NASA sponsored high density short haul air transportation systems studies are reported as well as analyzed. Included are the total STOL systems analysis approach, a companion STOL composites study conducted in conjunction with STOL systems studies, a STOL economic assessment study, an evaluation of STOL aircraft with and without externally blown flaps, an alternative STOL systems for the San Francisco Bay Area, and the quiet, clean experimental engine studies. Assumptions and results of these studies are summarized, their differences, analyzed, and the results compared with those in-house analyses performed by the Systems Studies Division of the NASA-Ames Research Center. Pertinent conclusions are developed and the more significant technology needs for the evaluation of a viable short haul transportation system are identified.

Savin, R. C.↗

NASA NTRS1975

Advanced subsonic aircraft concepts for passenger transportation

This paper discusses the potential for new subsonic transport aircraft designs that may evolve in the relatively near future, taking into account the added requirements for improved environmental compatibility and the potential constraints due to system congestion, substantial financial risk, and higher fuel costs or limited availability. Reflecting these additional requirements, potential aircraft developments are presented for new CTOL transports with significantly improved fuel economy, new STOL transports with improved short field capability, and new VTOL transports that could provide direct city-center service.

Waters, M. H.↗

NASA NTRS1974

Prospects for reduced energy transports: A preliminary analysis

The recent energy crisis and subsequent substantial increase in fuel prices have provided increased incentive to reduce the fuel consumption of civil transport aircraft. At the present time many changes in operational procedures have been introduced to decrease fuel consumption of the existing fleet. In the future, however, it may become desirable or even necessary to introduce new fuel-conservative aircraft designs. This paper reports the results of a preliminary study of new near-term fuel conservative aircraft. A parametric study was made to determine the effects of cruise Mach number and fuel cost on the optimum configuration characteristics and on economic performance. For each design, the wing geometry was optimized to give maximum return on investment at a particular fuel cost. Based on the results of the parametric study, a nominal reduced energy configuration was selected. Compared with existing transport designs, the reduced energy design has a higher aspect ratio wing with lower sweep, and cruises at a lower Mach number. It has about 30% less fuel consumption on a seat-mile basis.

Ardema, M. D.↗

NASA NTRS1974

Conceptual design of a lift fan plus lift/cruise fighter aircraft

Results of a design synthesis and mission analysis of a supersonic VTOL fighter aircraft are presented. Propulsive lift is provided by a single turbotip-driven lift fan and deflected thrust from a high performance turbofan cruise engine fitted with an afterburner for supersonic flight. The inlet and thrust diverter in the main engine tail-pipe are seen to be the principal design problems. V/STOL and supersonic design tradeoffs are addressed in lift fan sizing and placement, reaction and aerodynamic control sizing, fuselage volume requirements, and area ruling. Range and turn rate are used as figures of merit.-

Hill, G. C.↗

NASA NTRS1974

Propulsion system sizing for powered lift and mechanical flap quiet aircraft

A method of propulsion system sizing for mechanical flap and externally blown flap aircraft is demonstrated. Included in this study is the effect of various levels of noise suppression on the aircraft final design characteristics. Both aircraft are sized to operate from a 3000-ft runway and perform the same mission. For each aircraft concept, propulsion system sizing is demonstrated for two different engine cycles - one having a fan pressure ratio of 1.5 and a bypass ratio of 9 and the other having a fan pressure ratio of 1.25 and a bypass ratio of 17.8. The results presented include the required thrust to weight ratio and wing loading and the resulting gross weight and direct operating costs as functions of the engine noise level for each of the four combinations of engine cycles and aircraft concepts.

Bowles, J. V.↗

NASA NTRS1974

Long range view of materials research for civil transport aircraft

The impact of various material technology advancements on the economics of civil transport aircraft is investigated. Benefits of advances in both airframe and engine materials are considered. Benefits are measured primarily by improvements in return on investment for an operator. Materials research and development programs which lead to the greatest benefits are assessed with regards to cost, risk, and commonality with other programs. Emphasis of the paper is on advanced technology subsonic/transonic transports (ATT type aircraft) since these are likely to be the next generation of commercial transports.

Ardema, M. D.↗