Engineering topics
Publications and source records attributed to Watkins, Erik Benjamin.
Subsurface formations provide vast resource for energy generation, energy storage, and carbon sequestration. Sustainable energy generation from shale oil/gas and integrity of longterm storage necessitate understanding fluid behavior in nanoporous geomedia (e.g., shale caprock) under dynamic pressure conditions.
Here, in this work, neutron reflectometry (NR) studies of the bio-mimetic polymer, polydopamine (PDA), deposited from differing initial concentrations of precursor material dopamine hydrochloride for a range of polymerization times, is reported. PDA can form a complex and highly versatile polymer film, with many structure studies having been performed previously, but a comprehensive structural determination of PDA by NR is lacking in the literature. It was found that simple box models were incapable of fully explaining the observed data, necessitating the use of a composite model consisting of the weighted average of both the 1 and 2 box models to fully capture the heterogeneous nature of the PDA film structure. Confocal laser scanning microscopy (CLSM) and atomic force microscopy (AFM) were performed to capture the surface structure and relative mechanical difference between the separate domains of the PDA. The CLSM results provide evidence that the PDA domains are larger than the coherent scattering length of a neutron used in these measurements, 10μm, supporting the need for a composite model. The AFM measurements show complex structure below the coherence length provide physical justification for the two box model. It was determined that film structure and quality are both heavily impacted by the initial concentration of dopamine hydrochloride and the polymerization time, giving confidence to the highly customizable nature of PDA as an adhesion promoting interface treatment in composite systems, such as plastic bonded explosives (PBX).
Understanding and improving hydrocarbon yields during enhanced oil recovery (EOR) in unconventional reservoirs is complicated by the intrinsic mineralogical and geochemical heterogeneity of shale formations. Here, in this study, we utilized small-angle neutron scattering (SANS) and ultra-small-angle neutron scattering (USANS) to investigate the degree of oil retention and its location in the nanoporous shale matrix for two mineralogically distinct shale samples. The two samples, dubbed “dark” and “light” based on their color, were taken from adjacent strata in a Wolfcamp shale core. While both samples contained kerogen, the dark sample contained more kerogen and clay (43.7 wt %) while the light sample contained more calcite (54.9 wt %). Samples were presaturated with decane, a model hydrocarbon, prior to pressure cycling with methane. Results showed significantly more retention of decane in 1.5–10 nm radius pores of both, likely indicating that oil is retained within kerogen nanopores. Although the dark sample had a higher porosity of 8.7%, versus 3.3% for the light sample, more pores were accessible to decane and a higher percentage of the imbibed decane was removable from the light sample compared to the dark sample. The majority of decane was not recoverable for the dark sample, indicating that EOR with methane can be challenging. These new findings can help to model expected recoveries of in-place oil from heterogeneous shale formations, as well as inform improved EOR strategies.
Slides for a presentation about various newly observed fluid behaviors, particularly in the shale industry, given at a Texas A&M University seminar.
Interfacial strength plays a critical role in the mechanical properties of a composite system. In this work, a proven mock high explosive (HE), 5-iodo-2’-deoxyuridine (IDOX) was coated by the adhesive promoting polymer polydopamine (PDA), then formulated with an Estane binder system to form an improved HE mock composite. An extensive comparison study of mechanical properties was performed to determine the effects, if any, of PDA on the composite system. To aid in interpretation of the mechanical test data, neutron reflectometry experiments were performed to determine the thickness and structure of the as deposited PDA films. The mechanical performance of PDA-treated IDOX was then compared to untreated specimens by compression testing in the Brazilian disk geometry. The results strongly suggested that the structure of PDA consists of two layers: one low in density caused by polymer agglomerates attaching to the substrate during polymerization, and the second high in density caused by controlled linear deposition of polydopamine. Finally, the mechanical testing showed that PDA greatly increased the stiffness and yield strength of IDOX based mocks without causing any disruption to the underlying crystal system.
SANS is a powerful tool for probing porosity and pore size distribution changes in situ. First-of-their-kind SANS measurements have led to new insights into hydrocarbon behavior under confinement in shale nanopores.
Abstract not provided.
Polymers are widely implemented materials often used for safety and security in our daily lives. However, we do not have a thorough understanding of the phase transformations of these materials when exposed to extreme condition, high strain rate, events. To study polymers in these severe environments, we performed plate impact experiments that impart a one-dimensional shock wave, at high pressures and temperatures, to observe the materials response. Generally, velocimetry is the experimental diagnostic used to capture the movement of high velocity interfaces to then calculate the mechanical variables associated with shock compression. However, when a material undergoes a phase transition, such as between two crystalline phases or melting to decomposition during shock compression, velocimetry does not explicitly indicate what structural change occurred. At the Dynamic Compression Sector at the Advanced Photon Source gas gun driven compression has been paired with x-ray diffraction, providing the ability to study both the shock parameters and structural changes concurrently. We explored high density polyethylene (HDPE) both on its reactants Hugoniot (<10.12 GPa) and within its transition region (24.3 GPa) where HDPE is hypothesized to decompose from reactants to products. With x-ray diffraction we observed both polymer chain compression and crystal structure reorientation from orthorhombic to monoclinic above 6 GPa, as well as either a possible phase change or chemical decomposition at 24.3 GPa. With these experiments we were able to determine the crystalline and amorphous Hugoniot loci at pressures below the polymer transition region.
A thin film of uranium oxide was deposited by polymer assisted deposition on a single crystal lanthanum aluminate - strontium aluminum tantalate substrate. The deposition resulted in formation of epitaxial thin film of uranium oxide, which could be attributed to α-U 3 O 8 or α-UO 3 . X-ray diffraction revealed preferential orientation along (100) in case of α-U 3 O 8 or (001) for α-UO 3 for the thin film. A combination of x-ray and neutron reflectometry proved the sample to be α-U 3 O 8 . Furthermore, the film was of 17 nm thickness covered by a capping layer. The less dense capping layer could be a manifestation of surface water adsorbed on the sample.
Here, we report studies of the Fermi potential and loss per bounce of ultracold neutrons (UCNs) on a deuterated scintillator (Eljen-299-02D). These UCN properties of the scintillator enable its use in a wide variety of applications in fundamental neutron research.
Radiography is an important non-destructive characterization tool for many LANL missions. Contrast in conventional radiography results from attenuation of the incoming x-ray or neutron beam by the object. Neutrons have a great benefit in detecting light elements (e.g. hydrogen) in the presence of heavier elements and penetrate deeper than X-rays into many materials, but neutron radiography resolution is typically limited to ~50 μm. Cracks, voids, pores and a variety of other features smaller than this resolution are therefore undetectable in attenuation based neutron imaging. However, novel neutron imaging modalities leveraging off of interferometric methods, so-called neutron grating interferometry (NGI), are able to spatially map sub-micron features and interfacial features while also exploiting the neutron’s sensitivity to light elements and isotope specific contrast to enable material characterization otherwise impossible.
In this paper, in-situ time-of-flight neutron diffraction experiments were performed on uranium-niobium alloy with 6 wt% Nb to study the lattice parameter-composition relationship for the body centered cubic (bcc) alloys. Based on lattice-parameter measurements of Nb-supersaturated γs phase over the range of 450 – 790 °C, an improved Vegard's-type relationship was established for determination of Nb concentrations at elevated temperatures. Neutron diffraction data were also collected as a function of aging time over the 450 - 600 °C range when γs phase decomposed isothermally into the mixture of orthorhombic α-U and Nb-rich bcc phase, as well as at room-temperature on the alloys aged ex-situ at 500 °C up to five years. From these measurements, the average Nb concentrations in the bcc phase were determined based on the Rietveld refinements of weight fraction and mass conservation relations (lever rule). Over the 15at% – 78at% range of Nb concentrations that correspond to different experimental aging times, the lattice parameters at constant temperatures exhibit a nonlinear S-shaped variation with Nb concentration, and the associated excess volumes of mixing can be described by a subregular solution model of the Redlich–Kister type of polynomial. Over the full range of composition the S-shaped deviation from Vegard's law can be modeled using a combination of an elastic continuum model and a perturbation to the radii of the solute atoms in the solvent, suggesting that electronic interactions between solute and solvent atoms could play an important role in the compositional dependence of lattice parameter for the γ-phase U-Nb alloys. While Vegard's law is a straightforward and reasonably good approximation for the bcc solid solutions in the U-Nb system, the Nb concentrations determined from the weight fraction refinements of diffraction data provide internally consistent, mass-conserving estimates of solute redistribution for the monotectoid reaction.