Engineering topics

Webster, J.

Publications and source records attributed to Webster, J..

4 records

DOE OSTI2026

Design and development of optical modules for the BUTTON-30 detector

BUTTON-30 is a neutrino detector demonstrator located in the STFC Boulby underground facility in the north-east of England. The main goal of the project is to deploy and test the performance of the gadolinium-loaded water-based liquid scintillator for neutrino detection in an underground environment. This will pave the way for a future large-volume neutrino observatory that can also perform remote monitoring of nuclear reactors for nonproliferation. This paper describes the design and construction of the watertight optical modules of the experiment.

COMSOL simulations↗

NASA NTRS2016

APES: Acute Precipitating Electron Spectrometer - A High Time Resolution Monodirectional Magnetic Deflection Electron Spectrometer

We present a description of the Acute Precipitating Electron Spectrometer (APES) that was designed and built for the Ground-to-Rocket Electron Electrodynamics Correlative Experiment (GREECE) auroral sounding rocket mission. The purpose was to measure the precipitating electron spectrum with high time resolution, on the order of milliseconds. The trade-off made in order to achieve high time resolution was to limit the aperture to only one look direction. The energy selection was done by using a permanent magnet to separate the incoming electrons, such that the different energies would fall onto different regions of the microchannel plate and therefore be detected by different anodes. A rectangular microchannel plate (MCP) was used (15 mm x 100 mm), and there was a total of 50 discrete anodes under the MCP, each one 15 mm x 1.5 mm, with a 0.5 mm spacing between anodes. The target energy range of APES was 200 eV to 30 keV.

Michell, R. G.↗

NASA NTRS2003

The auditors are coming: a practical guide for engineering projects

This paper presents a description of the typical audit process, a list of do's and don'ts for projects undergoing an audit, how to design basic audit preparations into the project's design, and resources for further information on auditing issues.

audit auditors auditing↗

NASA NTRS1981

Mechanical characterization of PMR-15 graphite/polyimide bolted joints

Data are presented for the static and viscoelastic performance of Celion 6000/PMR-15 graphite/polyimide composite belted joints over the 21 to 315 C temperature range. Two laminate configurations were obtained by sectioning a panel into subpanels oriented parallel and perpendicular to the laminate principal direction. Three replicates of each specimen geometry were tested at each of the test temperatures for the two laminate configurations, and failure load was defined as the maximum load attained as indicated by the load/deflection curve. Effects of strain-rate on strength and failure mode behavior were assessed at room temperature for strain rates of 0.002, 0.01, 0.10, and 1.00/s, and creep behavior was examined for the case of bearing deformations at temperatures of 21 and 177 C. Results are presented, including: (1) two distinct mechanisms were responsible for bearing failure and related to laminate configuration, (2) the + or - 45 deg plies carried the shearing load in composite bolted joints, and (3) the material exhibited strain-rate sensitivity which varied with laminate configuration.

Wilson, D. W.↗