Operational Performance of the CLAS12 Longitudinally Polarized Target for Run Group C
Explore the source record for details and available documents.
Engineering topics
Publications and source records attributed to Wei, Xiangdong.
Explore the source record for details and available documents.
Explore the source record for details and available documents.
Explore the source record for details and available documents.
Our energy-hungry world is burning. A long-term solution, possibly the only ultimate one, that is just approaching the horizon after decades of struggle, is fusion. Recent developments allow us to apply techniques from spin physics to advance the viability of this critical option. The cross section for the primary fusion fuel in a tokamak reactor, D+T /to sigma + n, would be increased by a factor of 1.5 if the fuels were spin polarized parallel to the local field. Simulations predict further non-linear power gains in large-scale machines such as ITER, due to increased alpha heating. These are significant enhancements that could lower the requirements needed to reach ignition and could be used to extend useful reactor life by compensating for neutron degradation of critical components. The potential realization of such benefits rests on the survival of spin polarization for periods comparable to the energy containment time. Interest in polarized fuel options had an initial peak of activity in the 1980s, where calculations predicted that polarizations could in fact survive a plasma environment. However, concerns were raised regarding the cumulative impacts of fuel recycling from the reactor walls. In addition, the technical challenges of preparing and handling polarized materials prevented any direct tests. Over the last several decades, this situation has changed dramatically. Detailed simulations of the ITER plasma have projected negligible wall recycling in a high power reactor. In addition, a combination of advances in three areas - polarized material technologies developed for nuclear and particle physics as well as for medical imaging, polymer pellets developed for Inertial Con nement, and cryogenic injection guns developed for delivering fuel into the core of tokamaks - have matured to the point where a direct in situ measurement is possible. A Jefferson Lab - DIII-D/General Atomics - University of Virginia collaboration is developing designs for a proof-of-principle polarization survival experiment using the isospin mirror reaction, D +3 He /to sigma + p, at the DIII-D tokamak in San Diego.
The design, fabrication, operation, and performance of a helium-3/4 dilution refrigerator and superconducting magnet system for holding a frozen-spin polarized hydrogen deuteride target in the Jefferson Laboratory CLAS detector during photon beam running is reported. The device operates both vertically (for target loading) and horizontally (for target bombardment). Moreover, the device proves capable of maintaining a base temperature of 50 mK and a holding field of 1 Tesla for extended periods.
The march towards electricity production through tokamaks requires the construction of new facilities and the inevitable replacement of the previous generation. There are, however, research topics that are better suited to the existing tokamaks, areas of great potential that are not sufficiently mature for implementation in high power machines, and these provide strong support for a balanced policy that includes the redirection of existing programs. Spin polarized fusion, in which the nuclei of tokamak fuel particles are spin-aligned and favorably change both the fusion cross-section and the distribution of initial velocity vectors of charged fusion products, is described here as an example of a technological and physics topic that is ripe for development in a machine such as the DIII-D tokamak. In this study, such research and development experiments may not be efficient at the ITER-scale, while the plasma performance, diagnostic access, and collaborative personnel available within the United States’ magnetic fusion research program, and at the DIII-D facility in particular, provide a unique opportunity to further fusion progress.
Explore the source record for details and available documents.
Solid, frozen-spin targets of molecular HD were rst developed for nuclear physics by a collaboration between Syracuse University and Brookhaven National Lab. They have been successfully used in measurements with photon beams, rst at the Laser-Electron-Gamma-Source [1] and most recently at Je erson Lab during the running of the E06-101 (g14) experiment [2]. Preparations are underway to utilize the targets in future electron experiments after the completion of the 12 GeV JLab upgrade [3]. HD is an attractive target since all of the material is polarizable, of low Z, and requires only modest holding elds. At the same time, the small contributions from the target cell can be subtracted from direct measurements. Reaching the frozen-spin state with both high polarization and a signi cant spin relaxation time requires careful control of H2 and D2 impurities. Commercially available HD contains 0.5 - 2% concentrations of H2 and D2. Low-temperature distillation is required to reduce these concentrations to the 104 level to enable useful target production. This distillation is done using a column lled with heli-pack C [4] to give good separation e ciency. Approximately 12 moles of commercial HD is condensed into the mechanically refrigerated system at the base temperature of 11K. The system is then isolated and the temperature stabilized at 18K producing liquid HD, which is boiled by a resistive heater. The circulation established by the boil-o condensing throughout the column then ltering back down produces a steady-state isotopic separation permitting the extraction of HD gas with very low H2 and D2 content. A residual gas analyzer initially monitors distillation. Once the H2 concentration falls below its useful operating range, samples are periodically collected for analysis using gas chromatography [5] and Raman scattering. Where the measurement techniques overlap, good agreement is obtained. The operation of the distillery and results of gas analysis will be discussed. References [1] Phy. Rev. Lett. 101 (2009) 172002. [2] www.jlab.org/exp_prog/proposals/06/PR-06-101.pdf [3] www.jlab.org/exp_prog/proposals/12/PR12-12-009.pdf, www.jlab.org/exp_prog/proposals/12/PR12-12-010.pdf, and www.jlab.org/exp_prog/proposals/11/PR12-11-111.pdf [4] Nucl. Inst. Meth. 664 (2012) 347, www.wilmad-labglass.com/Products/LG-6730-104/ [5] Rev. Sci. Instrum. 82, 024101 (2011).
Solid HDice targets are polarized by bringing the HD crystal to thermal equilibrium at low temperature and high magnetic field, typically 10-20 mK and 15 Tesla, at Jefferson Lab. In this regime, due to its smaller magnetic moment, the resulting polarization for D is always at least three times smaller than for H. The controlled amount of polarizing catalysts, o-H2 and p-D2, used in the process of reaching a frozen-spin state, further limit the maximum achievable D polarization. Nonetheless, H and D polarizations can be transferred from one to the other by connecting the H and D sub-states of the HD system with RF. In a large target, the RF power needed for such transitions is effectively limited by non-uniformities in the RF field. High efficiency transfers can require substantial RF power levels, and a tuned-RF circuit is needed to prevent large temperature excursions of the holding cryostat. In this paper, we compare the advantages and limitations of two different RF transfer methods to increase D polarization, Forbidden Adiabatic and Saturated Forbidden RF Transitions. The experience with the HD targets used during the recently completed E06-101 experiment in Hall-B of Jefferson Lab is discussed.
During the Jefferson Labaratory E06-101 (g14) experiment \cite{g14} utilizing photons on solid HD and performed in Hall B, two opportunities arose for targets to be subjected to multi-GeV electron beams in week-long campaigns of dose accumulation and NMR polarization measurements. This was in preparation for conditionally approved electron experiments after the 12 GeV JLab upgrade\cite{trans}. Besides the important thermal effects, evidence consistent with screening of the NMR and with decay of the target polarization was observed during bombardment and for a time afterwards. The solid hydrogens have been the subject of previous radiation damage studies, both for possible polarized DT fusion\cite{Forrest97} and for production of dynamically polarized nuclear targets\cite{Radtke04}. We synthesize all this information into an overall picture that can guide on-going development of the HDice target system for future use.
Large, portable frozen-spin HD (Deuterium-Hydride) targets have been developed for studying nucleon spin properties with low backgrounds. Protons and Deuterons in HD are polarized at low temperatures (~10mK) inside a vertical dilution refrigerator (Oxford Kelvinox-1000) containing a high magnetic field (up to 17T). The targets reach a frozen-spin state within a few months, after which they can be cold transferred to an In-Beam Cryostat (IBC). The IBC, a thin-walled dilution refrigerator operating either horizontally or vertically, is use with quasi-4{pi} detector systems in open geometries with minimal energy loss for exiting reaction products in nucleon structure experiments. The first application of this advanced target system has been used for Spin Sum Rule experiments at the LEGS facility in Brookhaven National Laboratory. An improved target production and handling system has been developed at Jefferson Lab for experiments with the CEBAF Large Acceptance Spectrometer, CLAS.