Data for "Predictive modeling of NSTX discharges with the updated MULTI-MODE anomalous transport module"
Explore the source record for details and available documents.
Engineering topics
Publications and source records attributed to Weiland, J..
Explore the source record for details and available documents.
This study aims to incorporate the effects of fast particles into our present fluid model for tokamak transport. The parameter ε f = ω / ω f, where ω is the mode frequency and ω f is the typical frequency of the fast particles, which enters as a factor in front of the fast particle response. Thus, for trapped fast particles, where ω f = ω pres the precession frequency of the fast particles, this parameter is of order 10 – 2 for drift waves, and thus, the fast particle response can be neglected. However, ε f will be of order 1 for fast particle modes such as in the fishbone instability. An important turbulence property, affecting both these limits, is resonance broadening. Effects of resonance broadening have recently been considered for fast particle instabilities, often coupled directly to the linear growth rate, while we here consider the original Dupree formulation where the turbulence directly drives a nonlinear frequency shift. Resonance broadening has a general tendency to counteract dissipative wave particle resonances. This has been observed for fast particle instabilities. Here, there is a resonant external source for the fast particles, so the instability survives if this source is dominant over the resonance broadening. For drift waves, however, external sources are not resonant since ε f << 1. Furthermore, the resonance broadening is able to remove the dissipative wave particle resonance completely.
Nonlinearities appear in almost all systems. Earlier, we focused on those in plasmas, ionospheric scattering, and the world population. As turned out, the estimate of the population growth made in 1974 is in astonishing agreement with the United Nations estimates and agrees with our present data to within 2%. Here, a particularly important role, both for the population evolution and wave interaction in plasmas, is played by non-Markovian effects (effects depending on the past time). For the population growth, this occurs due to a delay of one generation in the set of population limiting actions, while, for plasmas, it is caused by nonlinear frequency shifts.
The purpose of these integrated ITER simulations is to identify dependencies that can impact the performance of ITER. The dependence of fusion power production, temperature and density pedestals, and core profiles on varying magnetic-q, edge density fueling strength, neoclassical transport, magnetic field strength, and alpha heating, are examined. It is noted that ion modes usually dominate the interior, while electron modes dominate the barrier. The electron mode without flow shear is substantially stronger. The q increase tends to cause more kinetic ballooning modes at the edge and the q decrease means that the peeling is getting worse, but the ballooning is getting better. The large edge q tends to provide hollow density while small edge q gives normal density profile. This is consistent with the observation that the density of particles is inversely proportional to the density of the plasma current. The rise in the source of the edge particle increases the density of the edge and the reaction rate close to the edge increases temperature fluxes, resulting in weak pedestal barriers. When neoclassical transport is turned off or the strength of B-field is increased, the pronounced edge barriers are identified. In addition, a distinct effect on the magnetohydrodynamic (MHD) modes is observed due to the increased B-field. The interesting aspect is that the barrier collapses about q = 2 as the stability of MHD has decreased to replace the barrier with a continuous slope but with roughly the same fusion power. This would actually be good for a reactor. The slope of the H-mode pedestal is found to be reduced due to the alpha heating. It is expected that the problem of edge-localized modes causing damage to the first wall will be eased. The effects of circular, elongated, and general geometry on plasma profiles are also compared and contrasted. The circular geometry has a hollow density profile and no edge or internal thermal transport barrier (ETB or ITB). However, both ETBs and ITBs can be found in the elongated geometry. In general geometry, there is a weaker ETB, comparable ITBs, but a higher edge particle transport barrier than in elongated geometry. Higher density near the edge, on the other hand, causes more wall erosion, so elongated geometry might be the best option.
Microtearing mode (MTM) real frequency, growth rate, magnetic fluctuation amplitude and resulting electron thermal transport are studied in systematic NSTX scans of relevant plasma parameters. Here, the dependency of the MTM real frequency and growth rate on plasma parameters, suitable for low and high collision NSTX discharges, is obtained by using the reduced MTM transport model. The plasma parameter dependencies are compared and found to be consistent with the results obtained from MTM using the Gyrokinetic GYRO code. The scaling trend of collision frequency and plasma beta is found to be consistent with the global energy confinement trend observed in the NSTX experiment. The strength of the magnetic fluctuation is found to be consistent with the gyrokinetic estimate. In earlier studies, it was found that the version of the Multi-Mode (MM) anomalous transport model, which did not contain the effect of MTMs, provided an appropriate description of the electron temperature profiles in standard tokamak discharges and not in spherical tokamaks. When the MM model, which involves transport associated with MTMs, is incorporated in the TRANSP code and is used in the study of electron thermal transport in NSTX discharges, it is observed that the agreement with the experimental electron temperature profile is substantially improved.
Phase 1 called for the following tasks: (1) completion of code to generate intermediate files containing the individual DIRBE observations which would be used to make the superpixelized maps; (2) completion of code necessary to generate the maps themselves; and (3) quality control on test-case maps in the form of point-source extraction and photometry. Items 1 and 2 are well in hand and the tested code is nearly complete. A few test maps have been generated for the tests mentioned in item 3. Map generation is not in production mode yet.
The Diffuse Infrared Background Experiment (DIRBE) on the Cosmic Background Explorer (COBE) satellite is designed to conduct a sensitive search for an isotropic cosmic infrared background radiation over the spectral range from 1 to 300 micrometers. The cumulative emissions of pregalactic, protogalactic, and evolving galactic systems are expected to be recorded in this background. The DIRBE instrument, a 10 spectral band absolute photometer with an 0.7 deg field of view, maps the full sky with high redundancy at solar elongation angles ranging from 64 to 124 degrees to facilitate separation of interplanetary, Galactic, and extragalactic sources of emission. Initial sky maps show the expected character of the foreground emissions, with relative minima at wavelengths of 3.4 micrometers and longward of 100 micrometers. Extensive modelling of the foregrounds, just beginning, will be required to isolate the extragalactic component. In this paper, we summarize the status of diffuse infrared background observations from the DIRBE, and compare preliminary results with those of recent rocket and satellite instruments.