Search NASA⌕ Search

Engineering topics

Weingarten, N. C.

Publications and source records attributed to Weingarten, N. C..

7 records
All sourcesNASA NTRSDOE OSTI
NASA NTRS1986

The interpretation of flying qualities requirements for flight control design

The flying requirements of MIL-F-8785(C) are interpreted in terms of command/response configurations, and pilot preference for flight control systems configurations of angle of attack, or pitch rate command, specified independently for the short period and phugoid dynamics, is determined using the Total-In-Flight-Simulator aircraft. The results show that for either command configuration, the short term response applies to the angle of attack response of the vehicle, and that this response must satisfy the omega(n) vs n/alpha requirement. The preference in the long term for angle of attack command indicates that the pilot wants the aircraft to fly in the direction it is pointing, and an attitude hold system is not found to be preferred unless attitude hold results in flight path angle hold.

Rynaski, E. G.↗
NASA NTRS1984

An in-flight investigation of a twin fuselage configuration in approach and landing

An in-flight investigation of the flying qualities of a twin fuselage aircraft design in the approach and landing flight phase was carried out in the USAF/AFWAL Total In-Flight Simulator (TIFS). The objective was to determine the effects of actual motion and visual cues on the pilot when he was offset from the centerline of the aircraft. The experiment variables were lateral pilot offset position (0, 30 and 50 feet) and effective roll mode time constant (.6, 1.2, 2.4 seconds). The evaluation included the final approach, flare and touchdown. Lateral runway offsets and 15 knot crosswinds were used to increase the pilot's workload and force him to make large lateral corrections in the final portion of the approach. Results indicated that large normal accelerations rather than just vertical displacements in rolling maneuvers had the most significant degrading effect on pilot ratings. The normal accelerations are a result of large lateral offset and fast roll mode time constant and caused the pilot to make unnecessary pitch inputs and get into a coupled pitch/roll oscillation while he was making line up and crosswind corrections. A potential criteria for lateral pilot offset position effects is proposed. When the ratio of incremented normal aceleration at the pilot station to the steady state roll rate for a step input reaches .01 to .02 g/deg/sec a deterioration of pilot rating and flying qualities level can be expected.

Weingarten, N. C.↗
NASA NTRS1983

Application of Calspan pitch rate control system to the Space Shuttle for approach and landing

A pitch rate control system designed for use in the shuttle during approach and landing was analyzed and compared with a revised control system developed by NASA and the existing OFT control system. The design concept control system uses filtered pitch rate feedback with proportional plus integral paths in the forward loop. Control system parameters were designed as a function of flight configuration. Analysis included time and frequency domain techniques. Results indicate that both the Calspan and NASA systems significantly improve the flying qualities of the shuttle over the OFT. Better attitude and flight path control and less time delay are the primary reasons. The Calspan system is preferred because of reduced time delay and simpler mechanization. Further testing of the improved flight control systems in an in-flight simulator is recommended.

Weingarten, N. C.↗
NASA NTRS1982

In-flight investigation of the effects of pilot location and control system design on airplane flying qualities for approach and landing

The handling qualities of large airplanes in the approach and landing flight phase were studied. The primary variables were relative pilot position with respect to center of rotation, command path time delays and phase shifts, augmentation schemes and levels of augmentation. It is indicated that the approach and landing task with large airplanes is a low bandwidth task. Low equivalent short period frequencies and relatively long time delays are tolerated only when the pilot is located at considerable distance forward of the center of rotation. The control problem experienced by the pilots, when seated behind the center of rotation, tended to occur at low altitude when they were using visual cues of rate of sink and altitude. A direct lift controller improved final flight path control of the shuttle like configurations.

Weingarten, N. C.↗
NASA NTRS1978

Identification of the stability parameters of an aeroelastic airplane

Phase variable transformations are used to construct the mathematical model of an aeroelastic aircraft in a form that is amenable to partial or piecemeal acceptance of parameters estimated from flight data. The problem is one of parameter identification of large scale dynamic systems involving a system matrix characterized by about 200 elements. A mathematical model of the USAF Total In-Flight Simulator was computed using the FLEXSTAB program. As data became available during the progress of the flight test program, it was processed and substituted in the mathematical model for parameters obtained from the FLEXSTAB program. Results tend to show a progressive and orderly transition from an analytically defined mathematical model to one obtained from the flight tests of the actual aircraft.

Rynaski, E. G.↗
NASA NTRS1975

A study for active control research and validation using the Total In-Flight Simulator (TIFS) aircraft

The results of a feasibility study and preliminary design for active control research and validation using the Total In-Flight Simulator (TIFS) aircraft are documented. Active control functions which can be demonstrated on the TIFS aircraft and the cost of preparing, equipping, and operating the TIFS aircraft for active control technology development are determined. It is shown that the TIFS aircraft is as a suitable test bed for inflight research and validation of many ACT concepts.

Chen, R. T. N.↗