Weise, David | Search NASA

DOE OSTI2021

Dynamic infrared gas analysis from longleaf pine fuel beds burned in a wind tunnel: observation of phenol in pyrolysis and combustion phases

Pyrolysis is the first step in a series of chemical and physical processes that produce flammable organic gases from wildland fuels that can result in a wildland fire. We report results using a new time-resolved Fourier transform infrared (FTIR) method that correlates the measured FTIR spectrum with an infrared thermal image sequence, enabling the identification and quantification of gases within different phases of the fire process. The flame from burning fuel beds composed of pine needles (Pinus palustris) and mixtures of sparkleberry, fetterbush, and inkberry plants was the natural heat source for pyrolysis. Extractive gas samples were analyzed and identified in both static and dynamic modes synchronized to thermal infrared imaging: a total of 29 gases were identified including small alkanes, alkenes, aldehydes, nitrogen compounds, and aromatics, most previously measured by FTIR in wildland fires. This study presents one of the first identifications of phenol associated with both pre-combustion and combustion phases using ca. 1 Hz temporal resolution. Preliminary results indicate ~2.5× greater phenol emissions from sparkleberry and inkberry compared to fetterbush, with differing temporal profiles.

09 BIOMASS FUELS↗

DOE OSTI2020

Analyzing Wildland Fire Smoke Emissions Data Using Compositional Data Techniques

By conservation of mass, the mass of wildland fuel that is pyrolyzed and combusted must equal the mass of smoke emissions, residual char and ash. For a given set of conditions, these amounts are fixed. This places a constraint on smoke emissions data which violates statistical assumptions for many of the methods currently used to analyze these data such as linear regression, analysis of variance, and t-tests. These data are inherently multivariate and non-negative parts of a whole. This paper introduces the field of compositional data analysis to the emissions community and provides examples of appropriate statistical treatment of emissions data. It is shown that modified combustion efficiency should not be used as a predictor variable for other smoke emissions because it is not an independent variable. An alternative method based on compositional linear trends to estimate trace gas composition using CO and CO2 is presented. The data used in this paper resulted from projects the DOD/DOE/EPA Strategic 586 Environmental Research and Development Program projects RC-1648 and 1649. The senior 587 author appreciates the guidance and R scripts provided by Prof. Girty at San Diego State 588 University to estimate linear trends by perturbation. J. P.-A. was supported by the Spanish 589 Ministry of Science, Innovation and Universities under the project CODAMET (RTI2018-590 095518-B-C21, 2019-2021). The data used in this study have been previously published and are 591 available in the original publications. DRW conceived the initial manuscript (70 percent) and 592 performed the bulk of the data analysis. JPA provided statistical guidance and compositional data 593 expertise and contributed 20 percent of the manuscript. TJJ and HJ were extensively involved in 594 the study that provided the data. TJJ provide smoke emissions expertise and HJ provided 595 combustion expertise. The authors declare that they have no conflict of interest. The use of trade 596 or firm names in this publication is for reader information and does not imply endorsement by 597 the U.S. Department of Agriculture of any product or service.

simplex, compositional data analysis, balance, log↗