Engineering topics
Publications and source records attributed to Welch, R. V..
The dynamic control laws utilized by the TOPEX/Poseidon (T/P) spacecraft attitude determination and control subsystem to command and maneuver the satellite during normal mission mode (NMM) laws are described. Results show that the vehicle is able to respond to the dynamic attitude commands while at the same time providing ample disturbance rejection capability.
A predictive temperature estimation technique which can be used to drive a model of the Sunrise/Sunset thermal 'snap' disturbance torque experienced by low Earth orbiting spacecraft is described. The twice per orbit impulsive disturbance torque is attributed to vehicle passage in and out of the Earth's shadow cone (umbra), during which large flexible appendages undergo rapidly changing thermal conditions. Flexible members, in particular solar arrays, experience rapid cooling during umbra entrance (Sunset) and rapid heating during exit (Sunrise). The thermal 'snap' phenomena has been observed during normal on-orbit operations of both the LANDSAT-4 satellite and the Communications Technology Satellite (CTS). Thermal 'snap' has also been predicted to be a dominant source of error for the TOPEX satellite. The fundamental equations used to model the Sunrise/Sunset thermal 'snap' disturbance torque for a typical solar array like structure will be described. For this derivation the array is assumed to be a thin, cantilevered beam. The time varying thermal gradient is shown to be the driving force behind predicting the thermal 'snap' disturbance torque and therefore motivates the need for accurate estimates of temperature. The development of a technique to optimally estimate appendage surface temperature is highlighted. The objective analysis method used is structured on the Gauss-Markov Theorem and provides an optimal temperature estimate at a prescribed location given data from a distributed thermal sensor network. The optimally estimated surface temperatures could then be used to compute the thermal gradient across the body. The estimation technique is demonstrated using a typical satellite solar array.
It is shown here that during normal on-orbit operations the TOPEX low-earth orbiting satellite is subjected to an impulsive disturbance torque caused by rapid heating of its solar array when entering and exiting the earth's shadow. Error budgets and simulation results are used to demonstrate that this sunrise/sunset torque disturbance is the dominant Normal Mission Mode (NMM) attitude error source. The detailed thermomechanical modeling, analysis, and simulation of this torque is described, and the predicted on-orbit performance of the NMM attitude control system in the face of the sunrise/sunset disturbance is presented. The disturbance results in temporary attitude perturbations that exceed NMM pointing requirements. However, they are below the maximum allowable pointing error which would cause the radar altimeter to break lock.
The augmented Modular Attitude Control Subsystem (MACS) is described, with emphasis on the significant hardware modifications that have been incorporated into the Landsat MMS (Multimission Modular Spacecraft) MACS design to satisfy the Topex/Poseidon mission attitude control and determination requirements. Particular attention is given to a modification consisting in the addition of an earth pointing safe hold mode utilizing yaw coarse sun sensors to provide a yaw-slew capability for maintaining adequate illumination of the solar array. The design utility of this augmented MACS module for future spacecraft applications is pointed out.
This paper presents an overall technical description of the on-board attitude determination system for The Ocean Topography Experiment (Topex) satellite. The stellar-inertial attitude determination system being designed for the Topex satellite utilizes data from a three-axis NASA Standard DRIRU-II as well as data from an Advanced Star Tracer (ASTRA) and a Digital Fine Sun Sensor (DFSS). This system is a modified version of the baseline Multimission Modular Spacecraft (MMS) concept used on the Landsat missions. Extensive simulation and analysis of the MMS attitude determination approach was performed to verify suitability for the Topex application. The modifications to this baseline attitude determination scheme were identified to satisfy the unique Topex mission requirements.
A technical description of the design and analysis of the Earth Pointing Safe Hold mode (EPSHM) for the Ocean Topography Experiment (TOPEX) satellite is presented. The EPSHM serves as the primary hardwired analog backup controller for safe-haven satellite operations in the event of on-orbit anomalies. The EPSHM is a modified version of the baseline Multimission Modular Satellite (MMS) EPSHM used on the Landsat-4 mission. Modifications to the MMS baseline EPSHM used on Landsat-4 were required to satisfy the unique TOPEX operational requirements. One such TOPEX operational requirement is that the EPSHM provide a spacecraft yaw-axis slewing capability to maintain adequate illumination of the solar array. The EPSHM architecture, constituent hardware components, performance requirements and predicted on-orbit performance are described.
This paper presents a proposed on-board Telescope Protection Algorithm (TPA) for the Space Infrared Telescope Facility (SIRTF). This TPA consists of hardware and software capable of performing both fail-operational and fail-safe modes of operation. In the fail-operational mode, each ephemeris load and slew/dwell command sequence is checked on-board before use. The slew command monitor detects unallowable slew/dwell commands and transfers control to an algorithm which slews to and maintains a safe telescope orientation while preserving precise attitude determination and control. This fail-operational mode is also given the authority to autonomously restart the slew/dwell sequence at a point beyond the faulty command. The fail-safe system consists of software and hardware which detects impending earth, moon, or sun avoidance zone violations and activates a backup hardware safe hold mode. The subject TPA and relevant sensor complement were designed for the SIRTF mission; however, this system can easily be used as a basis for failure detection and correction in a wide range of other missions.
The Ocean Topography Experiment satellite will carry a modular Attitude Determination and Control Subsystem (ADCS) which contains all equipment required for attitude determination, stabilization, and control, as well as hydrazine thruster firing control, during all mission phases. Attention is presently given to the ADCS's architecture, constituent hardware components, performance requirements, and predicted on-orbit performance compliance, with emphasis on the design and analysis of the Normal Mission Mode control algorithm furnishing the primary scientific data-acquisition operational mode. This mode's attitude determination and control of on-orbit performance is predicted to better than 43 arcsec.
An integrated hardware/software fault tolerant system for an earth oriented, computer controlled spacecraft is described. The design philosophy as well as the rationale behind the chosen fault tolerant system is outlined. In-flight performance of the system is included for several different instances where the Failure Detection and Correction system acted autonomously to protect the spacecraft. This system exceeded the expectations of the designers by demonstrating the capability to provide a measure of safety to the spacecraft for inadvertent and undesirable ground commands as well as satisfying its primary function of monitoring the flight hardware and software for failures.
A class of second order linear time-invariant systems which are unstable for any constant feedback but which are stabilized by a two level periodic feedback is identified. Necessary and sufficient conditions for this type of stabilization are found. In addition, the sensitivity of the closed-loop system to changes in feedback gains is investigated.