Search NASA⌕ Search

Engineering topics

Wheatley, John B

Publications and source records attributed to Wheatley, John B.

Wind-Tunnel Tests of 10-foot-diameter Autogiro Rotors

Report presents the results of a series of 10-foot-diameter autogiro rotor models tested in the NACA 20-foot wind tunnel. Four of the models differed only in the airfoil sections of the blades, the sections used being the NACA 0012, 0018, 4412, and 4418. Three additional models employing the NACA 0012 section were tested, in which a varying portion of the blade near the hub was replaced by a streamline tube with a chord of about one-fourth the blade chord.

Wheatley, John B↗

An analytical and experimental study of the effect of periodic blade twist on the thrust, torque, and flapping motion of an autogiro rotor

An analysis is made of the influence on autogiro rotor characteristics of a periodic blade twist that varies with the azimuth position of the rotor blade and the results are compared with experimental data. The analysis expresses the influence of this type of twist upon the thrust, torque, and flapping motion of the rotor. The check against experimental data shows that the periodic twist has a pronounced influence on the flapping motion and that this influence is accurately predicted by the analysis. The influence of the twist upon the thrust and torque could be demonstrated only indirectly, but its importance is indicated.

Wheatley, John B↗

An analysis of the factors that determine the periodic twist of an autogiro rotor blade, with a comparison of predicted and measured results

Report presents an analysis of the factors that determine the periodic twist of a rotor blade under the action of the air forces on it. The results of the analysis show that the Fourier coefficients of the twist are linear expressions involving only the tip-speed ratio, the pitch setting, the inflow coefficient, the pitching-moment coefficient of the blade airfoil section, and the physical characteristics of the rotor blade and machine. The validity of the analysis was examined by using it to predict the twist of a rotor whose twist characteristics had previously been measured in flight. The agreement between the calculated and experimental results was satisfactory.

Wheatley, John B↗

Analysis and Model Tests of Autogiro Jump Take-off

An analysis is made of the autogiro jump take-off, in which the kinetic energy of the rotor turning at excess speed is used to effect a vertical take-off. By the use of suitable approximations, the differential equation of motion of the rotor during this maneuver is reduced to a form that can be solved. Only the vertical jump was studied; the effect of a forward motion during the jump is discussed briefly. The results of model tests of the jump take-off have been incorporated in the paper and used to establish the relative accuracy of the results predicted from the analysis. Good agreement between calculation and experiment was obtained by making justifiable allowances.

Wheatley, John B↗

A study of autogiro rotor-blade oscillations in the plane of the rotor disk

An analysis of the factors governing the oscillation of an autogiro rotor blade in the plane of the rotor disk showed that the contribution of the air forces to the resultant motion was small and that the oscillation is essentially a direct effect of the rotor-blade flapping motion. A comparison of calculated oscillations with those measured in flight on three different rotors disclosed that the calculations gave satisfactory agreement with experiment. The calculated air forces on the rotor blade appear to be larger than the experimental ones, but this discrepancy can be attributed to the deficiencies in the strip analysis.

Wheatley, John B↗

The Influence of Wing Setting on the Wing Load and Rotor Speed of a PCA-2 Autogiro as Determined in Flight

Flight tests were made on PCA-2 autogiro with wing settings of 2.2 degrees, 0.9 degrees, and -0.5 degrees. The wing load and rotor speed were measured in steady glides. The results obtained show that a wide variation in rotor speed as a function of air speed can be obtained by a suitable adjustment of the wing setting; that by decreasing the wing setting the upper safe flying speed, determined by the decrease is rotor speed, is greatly increased; and that the interference of the wing on the rotor thrust and lift coefficients is negligible.

Wheatley, John B↗

Wind-Tunnel Tests of a 10-foot-diameter Gyroplane Rotor

This report presents the results of wind-tunnel tests on a model gyroplane rotor 10 feet in diameter. The rotor blades had zero sweepback and zero offset; the hub contained a feathering mechanism that provided control of the rotor rolling moment, but not of the pitching moment. The rotor was tested with 4 blades and with 2 blades. The entire useful range of pitch settings and tip-speed ratios was investigated including the phase of operation in which the rotor turned very slowly, or idled.

Wheatley, John B↗

Wind-tunnel Tests of a Cyclogiro Rotor

During an extensive study of all types of rotating wings, the NACA examined the cyclogiro rotor and made an aerodynamic analysis of that system (reference 1). The examination disclosed that such a machine had sufficient promise to justify an experimental investigation; a model with a diameter and span of 8 feet was therefore constructed and tested in the 20-foot wind tunnel during 1934. The experimental work included tests of the effect of the motion upon the rotor forces during the static-lift and forward-flight conditions at several rotor speeds and the determination of the relations between the forces generated by the rotor and the power required by it.

Wheatley, John B↗

Wing Pressure Distribution and Rotor-Blade Motion of an Autogiro as Determined in Flight

This report presents the results of tests in which the pressure distribution over the fixed wing of an autogiro was determined in both steady and accelerated flight. In the steady-flight condition, the rotor-blade motion was also measured. These data show that in steady flight the rotor speed as a function of the air speed is largely affected by the variation of the division of load between the rotor and the wing; as the load on the wing increases, the rotor speed decreases. In steady flight the presence of the slipstream increased both the wing lift at a given air speed and the maximum lift coefficient of the wing above the corresponding values without the slipstream. In abrupt high-speed turns, the wing attained a normal force coefficient of unity at almost the initial value of the air speed and experienced its maximum load before maximum acceleration occurred.

Wheatley, John B↗

An aerodynamic analysis of the autogiro rotor with a comparison between calculated and experimental results

This report presents an extension of the autogiro theory of Glauert and Lock in which the influence of a pitch varying with the blade radius is evaluated and methods of approximating the effect of blade tip losses and the influence of reversed velocities on the retreating blades are developed. A comparison of calculated and experimental results showed that most of the rotor characteristics could be calculated with reasonable accuracy, and that the type of induced flow assumed has a secondary effect upon the net rotor forces, although the flapping motion is influenced appreciably. An approximate evaluation of the effect of parasite drag on the rotor blades established the importance of including this factor in the analysis.

Wheatley, John B↗

Full-Scale Wind-Tunnel Tests of a PCA-2 Autogiro Rotor

This report presents the results of force tests on and air-flow surveys near PCA-2 autogiro rotor in the NACA full-scale wind tunnel. The force tests were made at three pitch settings and several rotor speeds; the effect of fairing protuberances on the rotor blade was determined. Induced downwash and yaw angles were determined at low tip-speed ratios in a plane 1 1/2 feet above the path of the blade tips. The results show that the maximum l/d of the rotor cannot be appreciably increased by increasing the blade pitch angle above about 4.5 degrees at the blade tip; that the protuberances on the blades cause more than 5 percent of the total rotor drag; and that the rotor center-of-pressure travel is very small.

Wheatley, John B↗

The aerodynamic analysis of the gyroplane rotating-wing system

An aerodynamic analysis of the gyroplane rotating-wing system is presented herein. This system consists of a freely rotating rotor in which opposite blades are rigidly connected and allowed to rotate or feather freely about their span axis. Equations have been derived for the lift, the lift-drag ratio, the angle of attack, the feathering angles, and the rolling and pitching moments of a gyroplane rotor in terms of its basic parameters. Curves of lift-drag ratio against lift coefficient have been calculated for a typical case, showing the effect of varying the pitch angle, the solidarity, and the average blade-section drag coefficient. The analysis expresses satisfactorily the qualitative relations between the rotor characteristics and the rotor parameters. As disclosed by this investigation, the aerodynamic principles of the gyroplane are sound, and further research on this wing system is justified.

Wheatley, John B↗

A Comparison Between the Theoretical and Measured Longitudinal Stability Characteristics of an Airplane

This report covers an investigation of the application of the theory of dynamic longitudinal stability, based on the assumption of small oscillations, to oscillations an airplane is likely to undergo in flight. The investigation was conducted with a small parasol monoplane for the fixed-stick condition. The period and damping of longitudinal oscillations were determined by direct measurements of oscillations in flight and also by calculation in which the factors that enter the theoretical stability equation were determined in flight. A comparison of the above-mentioned characteristics obtained by these two methods indicates that the theory is applicable to the conditions encountered in flight.

Soule, Hartley A↗

Lift and Drag Characteristics and Gliding Performance of an Autogiro as Determined in Flight

This report presents the results of flight test of the Pitcairn "PCA-2" autogiro. Lift and drag coefficients with the propeller stopped have been determined over approximately a 90 degree range of angles of attack. Based on the sum of fixed-wing and swept-disk areas, the maximum lift coefficient is 0.895, the minimum drag coefficient with propeller stopped is 0.015, and the maximum l/d with propeller stopped is 4.8. Lift coefficients were found also with the propeller delivering positive thrust and did not differ consistently from those found with propeller stopped. Curves of gliding performance included in this report show a minimum vertical velocity of 15 feet per second at an air speed of 36 miles per hour and a flight-path angle of -17 degrees. In vertical descent the vertical velocity is 35 feet per second.

Wheatley, John B↗

Torsion in box wings

Logical analysis of a box wing necessitates the allowance for the contribution of the drag spars to the torsional strength of the structure. A rigorous analysis is available in the use of the Method of Least Work. The best logical method of analysis is that applying Prandtl's Membrane Analogy. The results so obtained vary by a negligible amount from those obtained by the rigorous method.

Wheatley, John B↗

Simplified aerodynamic analysis of the cyclogiro rotating wing system

A simplified aerodynamic theory of the cyclogiro rotating wing is presented herein. In addition, examples have been calculated showing the effect on the rotor characteristics of varying the design parameters of the rotor. A performance prediction, on the basis of the theory here developed, is appended, showing the performance to be expected of a machine employing this system of sustentation. The aerodynamic principles of the cyclogiro are sound; hovering flight, vertical climb, and a reasonable forward speed may be obtained with a normal expenditure of power. Auto rotation in a gliding descent is available in the event of a power-plant failure.

Wheatley, John B↗