Search NASA⌕ Search

Engineering topics

Whitaker, H. P.

Publications and source records attributed to Whitaker, H. P..

9 records
All sourcesNASA NTRSDOE OSTI
NASA NTRS1978

Application of digital control to a magnetic model suspension and balance model

The feasibility of using a digital computer for performing the automatic control functions for a magnetic suspension and balance system (MSBS) for use with wind tunnel models was investigated. Modeling was done using both a prototype MSBS and a one dimensional magnetic balance. A microcomputer using the Intel 8080 microprocessor is described and results are given using this microprocessor to control the one dimensional balance. Hybrid simulations for one degree of freedom of the MSBS were also performed and are reported. It is concluded that use of a digital computer to control the MSBS is eminently feasible and should extend both the accuracy and utility of the system.

Luh, P. B.↗
NASA NTRS1978

A Wind-Tunnel Investigation of Tilt-Rotor Gust Alleviation Systems

The alleviation of the effects of gusts on tilt rotor aircraft by means of active control systems was investigated. The gust generator, the derivation of the equations of motion of the rotor wing combination, the correlation of these equations with the results of wind tunnel model tests, the use of the equations to design various gust alleviating active control systems, and the testing and evaluation of these control systems by means of wind tunnel model tests were developed.

Ham, N. D.↗
NASA NTRS1975

Use of active control systems to improve bending and rotor flapping response of a tilt rotor VTOL airplane

The results are summarized of an analytical study of the use of active control systems for the purpose of reducing the root mean square response of wing vertical bending and rotor flapping to atmospheric turbulence for a tilt-rotor VTOL airplane. Only the wing/rotor assembly was considered so that results of a wind tunnel test program would be applicable in a subsequent phase of the research. The capabilities and limitations of simple single feedback configurations were identified, and the most promising multiloop feedback configurations were then investigated. Design parameters were selected so as to minimize either wing bending or rotor flapping response. Within the constraints imposed by practical levels of feedback gains and complexity and by considerations of safety, reduction in response due to turbulence of the order of 30 to 50 percent is predicted using the rotor longitudinal cyclic and a trailing edge wing flap as control effectors.

Whitaker, H. P.↗
NASA NTRS1975

Flight control systems research

Research on flight control systems is reviewed. Investigations were conducted to evaluate and test a recent method of calculation of the performance index, application to various example designs, and programming for the discrete data control system case.

Whitaker, H. P.↗
NASA NTRS1975

System design of a rudder coordination system

The application of the parameter optimization computer program to the design of a rudder coordination system for the F-8 airplane is summarized. The flight condition was Mach 0.56 at 20,000 feet altitude. The system configuration selected consisted of signal paths that fed yaw rate and aileron signals to the rudder. The two signal paths were summed and then modified by a high pass filter to eliminate any steady state bias signal. The input axis of the yaw gyro was perpendicular to the aircraft zero lift line and the trim angle of attack was 7.75 degrees. The parameter optimization was used to design the complete system first, and then a root locus analysis of the individual component effects was made. The results are presented.

Whitaker, H. P.↗
NASA NTRS1973

Flight control systems research

Theoretical development is reported for the parameter optimization design technique needed for digital flight control system design. The results of an example case study applying the optimization technique for continuous systems to an F-8 aircraft feedback control system are presented. The concept of evolving the simplest system configuration that is capable of meeting a specified set of performance requirements is illustrated in this work.

Whitaker, H. P.↗
NASA NTRS1972

Parameter uncertainties in control system design.

Development of a design method for including the effects of parameter uncertainties in the design of linear control systems. The approach taken to this problem may be classified as a special case of the stochastic control problem. Thus the formulation is based on the minimization of the expected value of a quadratic performance index defined in terms of the system state vector. The uncertainty in the value of the performance index is the result of the statistical nature of the system parameters rather than a random input signal. It is shown that the expected value of the performance index may be written as a sum of two terms under the assumption of first-order variations of the system state. The first of these terms expresses the nominal performance of the system when the system parameters assume their mean values. The second term represents the effect of the uncertainties on the expected value of the performance index, and is interpreted as an index of system sensitivity.

Palsson, T.↗