Search NASA⌕ Search

Engineering topics

White, J.

Publications and source records attributed to White, J..

32 records · Page 2

High Efficiency Synchronous Rectification in Spacecraft

This paper examines the implementaion of MOSFETs as synchronous rectifiers which results in a substantial improvement in power processing efficency and therefore may result in significant reduction of spacecraft mass and volum for the same payload.

Spacecraft Power↗

Synopsis of early field test results from the gravity gradiometer survey system

Although the amount of data yielded by the initial airborne and surface tests was modest, it was sufficient to demonstrate that the full gravity gradient tensor was successfully measured from moving platforms both in the air and on the surface. The measurements were effectively continuous with spatial along-track resolution limited only by choice of integration lengths taken to reduce noise. The airborne data were less noisy (800 E squared/Hz typical) than were the Gravity Gradiometer Survey System (GGSS) measurements taken at the surface (5000 E squared/Hz typical). Single tracks of surface gravity disturbances recovered from airborne data were accurate to 3 to 4 mgal in each component of gravity when compared to 5 x 5 mean gravity anomalies over a 90 km track. Multitrack processing yielded 2 to 3 mgal when compared to 5 x 5 mean anomalies. Deflection of the vertical recovery over a distance of 150 km was about one arcsecond.

Brzezowski, S.↗

Advanced science and applications space platform

Requirements for and descriptions of the mission equipment, subsystems, configuration, utilities, and interfaces for an Advanced Science and Applications Space Platform (ASASP) are developed using large space structure technology. Structural requirements and attitude control system concepts are emphasized. To support the development of ASASP requirements, a mission was described that would satisfy the requirements of a representative set of payloads requiring large separation distances selected from the Science and Applications Space Platform data base. Platform subsystems are defined which support the payload requirements and a physical platform concept is developed. Structural system requirements which include utilities accommodation, interface requirements, and platform strength and stiffness requirements are developed. An attitude control system concept is also described. The resultant ASASP is analyzed and technological developments deemed necessary in the area of large space systems are recommended.

White, J.↗

An assessment of future computer system needs for large-scale computation

Data ranging from specific computer capability requirements to opinions about the desirability of a national computer facility are summarized. It is concluded that considerable attention should be given to improving the user-machine interface. Otherwise, increased computer power may not improve the overall effectiveness of the machine user. Significant improvement in throughput requires highly concurrent systems plus the willingness of the user community to develop problem solutions for that kind of architecture. An unanticipated result was the expression of need for an on-going cross-disciplinary users group/forum in order to share experiences and to more effectively communicate needs to the manufacturers.

Lykos, P.↗

Extended applications study of AMOOS and AMRS

The potential advantages of the Aeromaneuvering Orbit-to-Orbit Shuttle (AMOOS) over the all-propulsive Orbit Transfer Vehicle (OTV) are shown. In particular, the kit concept studies and the dual fueled AMOOS studies show its versatility and option potential over the all-propulsive vehicle. All of this potential of AMOOS and the Aeromaneuvering Recovery System (AMRS) depends upon the ability to control the trajectory during atmospheric flight and so use an ablative TPS. In turn, this TPS must be light weight, which can be attained by spraying a lightweight ablator directly onto the load bearing skin.

White, J.↗

Aeromaneuvering Orbit Transfer Vehicles for the space transport system

Alternatives to all-propulsive manned Orbit Transfer Vehicles (OTV) are presented that utilize aeromaneuvering in combination with propulsive maneuvering. A summary of the results of feasibility and concept definition studies is induced along with a discussion of the advantages and disadvantages of aeromaneuvering as compared with all-propulsive vehicles. Manned aeromaneuvering OTV concepts are described, including the Aeromaneuvering Orbit-to-Orbit Shuttle (AMOOS) for future orbital transportation and the Aeromaneuvering Recovery System (AMRS) for emergency recovery of crewmen from high-altitude orbits. Data are provided regarding aeromaneuvering OTV configurations, performance, systems, tradeoffs, mission applications, and major design parameters, such as dynamic pressure, heating rates, and guidance.

Hethcoat, J. P.↗

Applications Study of Aero-Maneuvering Orbit-to-Orbit Shuttle (AMOOS), Executive Summary

Preliminary designs and the supporting analysis for both the Aeromaneuvering Orbit-to-Orbit Shuttle (AMOOS) and the Aeromaneuvering Recovery System (AMRS) are presented. The AMOOS design is shown to yield from twice to almost three times the high energy, round-trip payloads as a purely propulsive vehicle of the same weight. Typically AMOOS can perform a crew rotation mission to equatorial geosynchronous orbit in one space shuttle launch. The flight test program analysis modeled parameters such as maximum dynamic pressure, heating rates, guidance, stability and recovery. Two model flight schedules were developed, one consisting of four flights and the other of two flights. The former is considered a very low risk, high information return program whereas the latter is a minimal cost program consistent with reasonable data returns and chance of success. The AMOOS and AMRS guidance scheme developed using linear regulator theory proved a precise and accurate guidance scheme. Both it and a classical linear system's based scheme were evaluated using 65 simulated trajectories in which the position in the entry corridor and the atmospheric density were varied randomly.

White, J.↗

Feasibility and tradeoff study of an aeromaneuvering orbit-to-orbit shuttle (AMOOS)

This study establishes that configurations satisfying the aeromaneuvering orbit-to-orbit shuttle (AMOOS) requirements can be designed with performance capabilities in excess of the purely propulsive space tug. In view of this improved potential of the AMOOS vehicle over the propulsive space tug concept it is recommended that the AMOOS studies be advanced to a stage comparable to those performed for the space tug. This advancement is needed in particular in areas that are either peculiar to AMOOS or not addressed in sufficient detail in these studies to date. These areas include the thermodynamics problems, navigation and guidance, operations and economics analyses, subsystems and interfaces. The aeromaneuvering orbit-to-orbit shuttle (AMOOS) is evaluated as a candidate reusable third stage to the two-stage earth-to-orbit shuttle (EOS). AMOOS has the potential for increased payload capability over the purely propulsive space tug by trading a savings in consumables for an increase in structural and thermal protection system (TPS) mass.

White, J.↗

Correlations among the parameters of the spherical model for eclipsing binaries.

Correlation coefficients have been computed to investigate the parameters used to describe the spherical model of an eclipsing binary system. Regions in parameter hyperspace have been identified where strong correlations exist and, by implication, the solution determinacy is low. The results are presented in tabular form for a large number of system configurations.

Sobieski, S.↗