A Study of Impinging Spray G on Transient Thermal Loading and Fuel FilmDeposition
Explore the source record for details and available documents.
Engineering topics
Publications and source records attributed to White, Logan.
Explore the source record for details and available documents.
Imaging using THz waves has been a promising option for penetrative measurements in environments that are opaque to visible wavelengths. However, available THz imaging systems have been limited to relatively low frame rates and cannot be applied to study fast dynamics. This work explores the use of upconversion imaging techniques based on nonlinear optics to enable wavelength-flexible high frame rate THz imaging. UpConversion Imaging (UCI) uses nonlinear conversion techniques to shift the THz wavelengths carrying a target image to shorter visible or near-IR wavelengths that can be detected by available high-speed cameras. This report describes the analysis methodology used to design a prototype high-rate THz UCI system and gives a detailed explanations of the design choices that were made. The design uses a high-rate pulse-burst laser system to pump both THz generation and THz upconversion detection, allowing for scaling to acquisition rates in excess of 10 kHz. The design of the prototype system described in this report has been completed and all necessary materials have been procured. Assembly and characterization testing is on-going at the submission of this report. This report proposes future directions for work on high-rate THz UCI and potential applications of future systems.
Abstract not provided.
Abstract not provided.
High-fidelity simulations of an experimental rotating detonation engine with an axial air inlet were conducted. The system operated with hydrogen as fuel at globally stoichiometric conditions. Instantaneous data showed that the detonation front is highly corrugated, and is considerably weaker than an ideal Chapman–Jouguet wave. Regions of deflagration are present ahead of the wave, caused by mixing with product gases from the previous cycle, as well as the injector recovery process. It is found that as the post-detonation high pressure flow expands, the injectors recover unsteadily, leading to a transient mixing process ahead of the next cycle. The resulting flow structure not only promotes mixing between product and reactant gases, but also increases likelihood of autoignition. These results show that the detonation process is very sensitive to injector design and the transient behavior during the detonation cycle. Phase-averaged statistics and conditionally averaged data are used to understand the overall reaction structure. As a result, comparisons with available experimental data on this configuration show remarkable good agreement of the predicted reacting flow structure.
The ability of Additive Manufacturing to create complex 3D objects has attracted the attention of a wide variety of industries [1]. This in turn has led to detailed studies investigating the relationship between AM processing parameters and final part characteristics such as porosity and texture [2]. However little research has been done to study the effects of these subsequent characteristics on these parts’ performance [3]. In this study, 316L stainless steel samples were additively manufactured to have common AM defects. The samples were deformed plasticly while undergoing in-situ microtomography and diffraction measurements.
The goal is to understand the effect of AM defect type on tensile behavior.
Introduce defects into laser powder bed fusion stainless steel samples by controlling processing parameters. Perform in-situ x-ray microtomography on L-PBF stainless steel samples during plastic deformation. Relate defect characteristics and evolution to tensile behavior. Understand how processing conditions translate to initial defect characteristics. Track and evaluate defect evolution as a function of plastic deformation. Determine how deformation and fracture mechanics change as a result of AM defects.
Observe the change in density, size, shape, and orientation of defects in 3D printed materials using in-situ synchrotron XCT during tensile testing.