Engineering topics
Publications and source records attributed to White, R. P., Jr..
The problem of establishing the state of the technology is approached by first identifying the various characteristics of rotor noise and then assessing the state of technology in understanding and predicting the most important of these rotor noise characteristics in a real-world environment.
The results of a recent wind tunnel test program to evaluate the effectiveness of the Tip Air Mass Injection (TAMI) system in modifying the blade tip vortex occurring during helicopter flight is described with attention to the effect of this modification on the impulsive noise. The measurement program is explained, and the correlation between experimental and predicted results is discussed. Topics considered include the effect of descent rate on noise pressure time histories, the effect of air mass injection on noise, and the analysis based on a dB(A) weighted approach. Impulsive noise generated by the interaction of a helicopter rotor blade and the concentrated tip vortex during forward flight descent is a primary contributor to acoustic annoyance as it draws early attention to the presence of the helicopter.
A research investigation was conducted to assess the potential of the Tip Air Mass Injection system in reducing the noise output during blade vortex interaction in descending low speed flight. In general it was concluded that the noise output due to blade vortex interaction can be reduced by 4 to 6 db with an equivalent power expenditure of approximately 14 percent of installed power.
Wind tunnel tests were conducted to determine the influence of various parameters on the noise produced by the interaction of the main rotor wake with the tail rotor. Parameters found to be of significance were the location of the main rotor vortex interaction on the tail rotor disk, the direction of rotation of the tail rotor, the lateral tail rotor-fin spacing, and the operating mode of the tail rotor. Of lesser importance were the main rotor thrust coefficient, longitudinal spacing between rotors, and tail rotor-to-main rotor rotational speed ratios. Analysis of the interaction noise characteristics using a simplified representation of the aerodynamic phenomena occurring during the interaction showed that existing predictive techniques could be modified and extended to predict the pertinent noise characteristics.
The possibility of reducing blade-slap noise and high-frequency air loads and of increasing performance by tip air mass injection (TAMI) is investigated. The discussion is limited to two types of TAMI: chordwise injection with air injected at the blade tip in a chordwise direction and spanwise injection with air injected in a spanwise direction. Experimental and analytical results indicate that a properly designed TAMI system can restructure the near field characteristics of a concentrated vortex that trails off the tip of a lifting surface, that the tip vortex is spread by the application of chordwise TAMI, that mixing exists between the injected air mass and the vortex flow which enhances vortex decay, that the net power requirements to implement the system on operational helicopters are within acceptable levels, that maximum drop of noise level reductions of about 25 dB can be achieved, and that a decrease in the drag induced by the tip vortex in a spanwise TAMI system can be obtained by restructuring the vortex as it forms along the airfoil chord and by moving the vortex farther outboard of the tip.
Computer program for determining characteristic functions of aeroelastic instabilities of helicopter rotor in forward flight
Periodic loading prediction on rotating structural components of helicopters and VTOL aircraft
Explore the source record for details and available documents.