NASA Simulation Activites Supporting the Columbia Accident Investigation and Space Shuttle Return to Flight
No abstract available
Whitlow, Woodrow, Jr.↗
Engineering topics
Whitlow, Woodrow, Jr.
Publications and source records attributed to Whitlow, Woodrow, Jr..
Advanced Propulsion Systems for Low-Cost Access to Space
NASA's Space Access Goal Ensure the provision of space access and improve it by increasing safety, reliability, and affordability. (1) The launch phase continues to be the highest risk period of any space mission. (2) Launch costs remain an obstacle to the complete utilization of space for research, exploration, and commercial purposes (3) Improving the Nation's access to space through the application of new technology is one of NASA's primary roles.
Whitlow, Woodrow, Jr.↗
Technology Requirements for the 21st Century: A NASA Perspective
This report provides an overview on the following:NASA Vision and Mission; Aeronautics Technology; Space Technology;and Education Programs.
Whitlow, Woodrow, Jr.↗
NASA's Vision for 21st Century Aircraft
This paper presents NASA's Vision for the 21st Century Aircraft. The contents include: 1) NASA Vision; 2) NASA Installations; 3) Research and Technology Products; 4) Future Plans; 5) Revolutionary Vehicles; 6) Aeropropulsion-NASA's Future Direction; 7) Gas Turbine Revolution; 8) Variable Capability, Ultra High Bypass Ratio Intelligent Engines: Fundamental Technologies; 9) Distributed Vectored Propulsion; and 10) Alternative Energy Propulsion. This paper is in viewgraph form.
Whitlow, Woodrow, Jr.↗
Probabilistic Methods for Structural Design and Reliability
This report describes a formal method to quantify structural damage tolerance and reliability in the presence of a multitude of uncertainties in turbine engine components. The method is based at the material behavior level where primitive variables with their respective scatter ranges are used to describe behavior. Computational simulation is then used to propagate the uncertainties to the structural scale where damage tolerance and reliability are usually specified. Several sample cases are described to illustrate the effectiveness, versatility, and maturity of the method. Typical results from this method demonstrate, that it is mature and that it can be used to probabilistically evaluate turbine engine structural components. It may be inferred from the results that the method is suitable for probabilistically predicting the remaining life in aging or in deteriorating structures, for making strategic projections and plans, and for achieving better, cheaper, faster products that give competitive advantages in world markets.
Chamis, Christos C.↗
Innovative Airbreathing Propulsion Concepts for High-speed Applications
The current cost to launch payloads to low earth orbit (LEO) is approximately loo00 U.S. dollars ($) per pound ($22000 per kilogram). This high cost limits our ability to pursue space science and hinders the development of new markets and a productive space enterprise. This enterprise includes NASA's space launch needs and those of industry, universities, the military, and other U.S. government agencies. NASA's Advanced Space Transportation Program (ASTP) proposes a vision of the future where space travel is as routine as in today's commercial air transportation systems. Dramatically lower launch costs will be required to make this vision a reality. In order to provide more affordable access to space, NASA has established new goals in its Aeronautics and Space Transportation plan. These goals target a reduction in the cost of launching payloads to LEO to $lo00 per pound ($2200 per kilogram) by 2007 and to $100'~ per pound by 2025 while increasing safety by orders of magnitude. Several programs within NASA are addressing innovative propulsion systems that offer potential for reducing launch costs. Various air-breathing propulsion systems currently are being investigated under these programs. The NASA Aerospace Propulsion and Power Base Research and Technology Program supports long-term fundamental research and is managed at GLenn Research Center. Currently funded areas relevant to space transportation include hybrid hyperspeed propulsion (HHP) and pulse detonation engine (PDE) research. The HHP Program currently is addressing rocket-based combined cycle and turbine-based combined cycle systems. The PDE research program has the goal of demonstrating the feasibility of PDE-based hybrid-cycle and combined cycle propulsion systems that meet NASA's aviation and access-to-space goals. The ASTP also is part of the Base Research and Technology Program and is managed at the Marshall Space Flight Center. As technologies developed under the Aerospace Propulsion and Power Base Research and Technology Program mature, they are incorporated into ASTP. One example of this is rocket-based combined cycle systems that are being considered as part of ASTP. The NASA Ultra Efficient Engine Technology (UEET) Program has the goal of developing propulsion system component technology that is relevant to a wide range of vehicle missions. In addition to subsonic and supersonic speed regimes, it includes the hypersonic speed regime. More specifically, component technologies for turbine-based combined cycle engines are being developed as part of UEET.
Whitlow, Woodrow, Jr.↗
Airframe Systems: Research and Technology Base Program
The author argues that the aeronautics research and technology base has shifted from a discipline focus to a program focus. The program planning is progressing as Level I is complete and Level II plans are under development, while there is significant inter-center planning and coordination taking place. These programs are addressing problems that are important to the nation namely, "the three pillars to success" which are; access to space, global civil aviation and revolutionary technology leaps.
Whitlow, Woodrow, Jr.↗
Research in unsteady aerodynamics and computational aeroelasticity at the NASA Langley Research Center
This paper presents recent results in the unsteady aerodynamics and computational aeroelasticity research programs at the NASA Langley Research Center. These programs include development of two types of computational methods: methods that use structured computational meshes and those that use unstructured meshes. Results show that an aeroelastic analysis method that uses unsteady transonic small disturbance (TSD) potential aerodynamics and structured, Cartesian meshes is capable of accurate analysis of complex aircraft configurations. The paper describes recent enhancements to the TSD method that allow analysis of vehicles with swept, flexible vertical surfaces and flexible fuselages and presents selected results that verify the accuracy of the new capabilities. Modifications to a structured-mesh Euler/Navier-Stokes method to allow aeroelastic analysis are described, and a wing flutter analysis using the resulting method is presented. Advantages of using unstructured meshes for the analysis of complex configurations are discussed. The paper presents development of unstructured-mesh Euler/Navier-Stokes methods for unsteady aerodynamics and aeroelastic analysis. Spatial and temporal adaption methods on unstructured meshes are described, and selected results are presented.
Whitlow, Woodrow, Jr.↗
An overview of aeroelasticity studies for the National Aero-Space Plane
The National Aero-Space Plane (NASP), or X-30, is a single-stage-to-orbit vehicle that is designed to takeoff and land on conventional runways. Research in aeroelasticity was conducted by the NASA and the Wright Laboratory to support the design of a flight vehicle by the national contractor team. This research includes the development of new computational codes for predicting unsteady aerodynamic pressures. In addition, studies were conducted to determine the aerodynamic heating effects on vehicle aeroelasticity and to determine the effects of fuselage flexibility on the stability of the control systems. It also includes the testing of scale models to better understand the aeroelastic behavior of the X-30 and to obtain data for code validation and correlation. This paper presents an overview of the aeroelastic research which has been conducted to support the airframe design.
Ricketts, Rodney H.↗
Analysis of aeroelastic and resonance responses of a wind tunnel model support system
Vibrations of the National Transonic Facility model support system were analyzed using CAP-TSD (Computational Aeroelasticity Program-Transonic Small Disturbance), a three-dimensional transonic small disturbance potential code designed for aeroelastic analysis of complex configurations. The model support system was represented as a tunnel-spanning flexible wing whose structural properties were obtained from measured responses. Aeroelastic transients were calculated, assuming no structural damping, and analyzed to obtain modal stability characteristics. The results showed that there is a tendency toward a hump mode instability in one of the modes and that there are other weakly damped or unstable modes. The close proximity of the solid wind-tunnel diffuser side walls to the model support system was shown to have adverse effects on its aeroelastic stability characteristics. When the effects of the wind-tunnel walls were modeled, the analyses indicated the presence of wind-tunnel resonance modes which were not present when free-air boundary conditions were used.
Whitlow, Woodrow, Jr.↗
Calculating Transonic Flows About Airfoils
Small disturbances and aeroelastic effects simulated. XTRAN2L computer program used to calculate two-dimensional transonic flows about airfoils. Uses time-accurate, alternating-direction, implicit (ADI) finite-difference scheme to solve two-dimensional complete unsteady transonic small-disturbance equation. Engquist-Osher monotone spatial differencing used in ADI solution algorithm to provide robust and efficient program. Written in FORTRAN V.
Seidel, David A.↗
Application of a full potential method to AGARD standard airfoils
One of the most important uses of method that calculate unsteady aerodynamic loads is to predict and analyze the aeroelastic responses of flight vehicles. Currently, methods based on transonic small disturbance potential aerodynamics are the primary tools for aeroelastic analysis. Flow solutions obtained using isentropic potential theory can be highly inaccurate and even multivalued, because they do not model the effects of entropy that is produced when shock waves are in the flow field. From the results that are presented, it is concluded that nonisentropic potential methods more accurately model Euler solutions than do isentropic methods. The primary effects of modeling shock generated entropy are: (1) to eliminate mulitple flow solutions when strong shock waves are in the flow field; and (2) to bring the strengths and locations of computed shock waves into better agreement with those calculated using Euler method and those measured during experiments.
Whitlow, Woodrow, Jr.↗
Analysis of vibrations of the National Transonic Facility model support system using a 3-D aeroelastic code
Vibrations of the National Transonic Facility model support system were analyzed using Computational Aeroelasticity Program-Transonic Small Disturbance, a three-dimensional transonic small disturbance code designed for aeroelastic analysis of complete aircraft. The model support system was represented as a tunnel-spanning flexible wing whose structural properties were obtained from measured responses. Aeroelastic transients were calculated and analyzed to obtain modal stability characteristics. The results show that there is tendency to exhibit a hump mode instability in one of the modes, and that there are other weakly damped or unstable modes. Most of the motion is in the aft section of the model support system. The close proximity of the solid wind-tunnel diffuser side walls to the model support system is shown to have adverse effects on its aeroelastic stability characteristics. When the effects of the wind-tunnel walls are modeled, the analyses indicate the presence of wind-tunnel resonance modes which are not present when free-air boundary conditions are used.
Whitlow, Woodrow, Jr.↗
Application of unsteady aerodynamic methods for transonic aeroelastic analysis
Aerodynamic methods for aeroelastic analysis are applied to various flow problems. These methods include those that solve the three dimensional transonic small disturbance (TSD) potential equation, the two dimensional (2-D) full potential (FP) equation, and the 2-D thin layer Navier-Stokes equations. Flutter analysis performed using TSD aerodynamics show that such methods can be used to analyze some aeroelastic phenomena. For thicker bodies and larger amplitude motions, a nonisentropic FP method is presented. The unsteady FP equation is modified to model the entropy jumps across shock waves. The conservative form of the modified equation is solved in generalized coordinates using an implicit, approximate factorization method. Pressures calculated on the NLR 7301 and NACA 64A010A airfoils using the nonisentropic FP method are presented. It is shown that modeling shock generated entropy extends the range of validity of the FP method. A Navier-Stokes code is correlated with pressures measured on a supercritical airfoil at transonic speeds. When corrections are made for wind tunnel wall effects, the calculations correlate well with the measured data.
Whitlow, Woodrow, Jr.↗
Application of a nonisentropic full potential method to AGARD standard airfoils
An entropy-correction method for the unsteady full potential equation is presented. The unsteady potential equation is modified to model the entropy jumps across shock waves. The conservative form of the modified equation is solved in generalized coordinates using an implicit, approximate factorization method. A flux-biasing differencing method, which generates the proper amounts of artificial viscosity in supersonic regions, is used to discretize the flow equations in space. Calculated results are presented for the NLR 7301, NACA 0012, and NACA 64A010A airfoils. Comparisons of the present method and solutions of the Euler equations are presented for the NLR 7301 airfoil, and comparisons of the present method and experimental data are presented for all three airfoils. The comparisons show that the present method more accurately models solutions of the Euler equations and experiment than does the isentropic potential formulation. In addition, it is shown that modeling shock-generated entropy extends the range of validity of the full potential method.
Whitlow, Woodrow, Jr.↗
Application of a nonisentropic full potential method to AGARD standard airfoils
An entropy-correction method for the unsteady full potential equation is presented. The unsteady potential equation is modified to model the entropy jumps across shock waves. The conservative form of the modified equation is solved in generalized coordinates using an implicit, approximate factorization method. A flux-biasing differencing method, which generates the proper amounts of artificial viscosity in supersonic regions, is used to discretize the flow equations in space. Calculated results are presented for the NLR 7301, NACA 0012, and NACA 64A010A airfoils. Comparisons of the present method and solutions of the Euler equations are presented for the NLR 7301 airfoil, and comparisons of the present method and experimental data are presented for all three airfoils. The comparisons show that the present method more accurately models solutions of the Euler equations and experiment than does the isentropic potential formulation. In addition, it is shown that modeling shock-generated entropy extends the range of validity of the full potential method.
Whitlow, Woodrow, Jr.↗
Application of unsteady aerodynamic methods for transonic aeroelastic analysis
Aerodynamic methods for aeroelastic analysis are applied to various flow problems. These methods include those that solve the three-dimensional transonic small disturbance (TSD) potential equation, the two-dimensional full potential (FP) equation, and the thin-layer Navier-Stokes equations. Flutter analysis performed using TSD aerodynamics shows that such methods can be used to analyze some aeroelastic phenomena. For thicker bodies and larger amplitude motions a nonisentropic full potential method is presented.
Whitlow, Woodrow, Jr.↗
Computational unsteady aerodynamics for aeroelastic analysis
This report summarizes the status of computational unsteady aerodynamics methods for aeroelastic analysis and makes recommendations for future research activities. The flight conditions for which various types of flows exist are described and the aeroelastic phenomena that can occur in those flight regimes are discussed. Some important aeroelastic problems of current interest are described, and the aerodynamic methods needed to analyze them are presented. The capabilities and limitations of existing unsteady aerodynamics methods are discussed. Computer resources required to perform aeroelastic analysis of various flight vehicle configurations are presented. Recommendations for future research are made, and schedules for completion of proposed research tasks are presented.
Whitlow, Woodrow, Jr.↗