Search NASA⌕ Search

Engineering topics

Wiencek, Tom

Publications and source records attributed to Wiencek, Tom.

Grain growth in U–7Mo alloy: A combined first-principles and phase field study

Grain size is an important factor in controlling the swelling behavior in irradiated U-Mo dispersion fuels. Increasing the grain size in U-Mo fuel particles by heat treatment is believed to delay the fuel swelling at high fission density. In this work, a multiscale simulation approach combining first-principles calculation and phase field modeling is used to investigate the grain growth behavior in U-7Mo alloy. The density functional theory based first-principles calculations were used to predict the material properties of U-7Mo alloy. The obtained grain boundary energies were then adopted as an input parameter for mesoscale phase field simulations. The effects of annealing temperature, annealing time and initial grain structures of fuel particles on the grain growth in U-7Mo alloy were examined. The predicted grain growth rate was compared well with the empirical correlation derived from experiments.

Mei, Zhi-Gang↗

Grain Growth and Bubble Evolution in U-Mo Alloy by Multiscale Simulations

Increased grain size in U-Mo dispersion fuel is believed to affect the fuel swelling at high fission density. In this work, a multiscale simulation approach combining first-principles calculation and phase-field modeling is used to investigate the grain growth behavior in U-Mo alloys. The material properties of U-Mo alloys predicted by first-principles calculations are incorporated into the mesoscale phase-field models to study the effect of annealing temperature, annealing time and the initial grain structures of fuel particles on the grain growth. The grain growth rate is evaluated and compared with experiment. Meanwhile, the gas bubble evolution kinetics in irradiated U-Mo alloy fuels is investigated to understand its effect on fuel swelling. We systematically examine the effect of Xe, vacancy, and SIA concentration, fission defect generation, and elastic interaction on the growth kinetics of gas bubble. The bubble size distribution and swelling of U-Mo are simulated and compared to experimental measurements.

Mei, Zhi-Gang↗

Coated U(Mo) Fuel: As-Fabricated Microstructures

As part of the development of low-enriched uranium fuels, fuel plates have recently been tested in the BR-2 reactor as part of the SELENIUM experiment. These fuel plates contained fuel particles with either Si or ZrN thin film coating (up to 1 µm thickness) around the U-7Mo fuel particles. In order to best understand irradiation performance, it is important to determine the starting microstructure that can be observed in as-fabricated fuel plates. To this end, detailed microstructural characterization was performed on ZrN and Si-coated U-7Mo powder in samples taken from AA6061-clad fuel plates fabricated at 500°C. Of interest was the condition of the thin film coatings after fabrication at a relatively high temperature. Both scanning electron microscopy and transmission electron microscopy were employed. The ZrN thin film coating was observed to consist of columns comprised of very fine ZrN grains. Relatively large amounts of porosity could be found in some areas of the thin film, along with an enrichment of oxygen around each of the the ZrN columns. In the case of the pure Si thin film coating sample, a (U,Mo,Al,Si) interaction layer was observed around the U-7Mo particles. Apparently, the Si reacted with the U-7Mo and Al matrix during fuel plate fabrication at 500°C to form this layer. The microstructure of the formed layer is very similar to those that form in U-7Mo versus Al-Si alloy diffusion couples annealed at higher temperatures and as-fabricated U-7Mo dispersion fuel plates with Al-Si alloy matrix fabricated at 500°C.

11 NUCLEAR FUEL CYCLE AND FUEL MATERIALS↗