Engineering topics

Wilke, Stephen K. (ORCID:0000000346747049)

Publications and source records attributed to Wilke, Stephen K. (ORCID:0000000346747049).

4 records

DOE OSTI2024

Plutonium oxide melt structure and covalency

Advances in nuclear power reactors include the use of mixed oxide fuel, containing uranium and plutonium oxides. The high-temperature behaviour and structure of PuO 2-x above 1,800 K remain largely unexplored, and these conditions must be considered for reactor design and planning for the mitigation of severe accidents. Here, in this study, we measure the atomic structure of PuO 2-x through the melting transition up to 3,000 +/- 50 K using X-ray scattering of aerodynamically levitated and laser-beam-heated samples, with O/Pu ranging from 1.57 to 1.76. Liquid structural models consistent with the X-ray data are developed using machine-learned interatomic potentials and density functional theory. Molten PuO 1.76 contains some degree of covalent Pu-O bonding, signalled by the degeneracy of Pu 5f and O 2p orbitals. The liquid is isomorphous with molten CeO 1.75 , demonstrating the latter as a non-radioactive, non-toxic, structural surrogate when differences in the oxidation potentials of Pu and Ce are accounted for. These characterizations provide essential constraints for modelling pertinent to reactor safety design. The molten structure of plutonium oxide-a component of mixed oxide nuclear fuels-is measured, showing some degree of covalent bonding. Its atomic structure is similar to that of cerium oxide, which could be a non-radioactive structural surrogate.

11 NUCLEAR FUEL CYCLE AND FUEL MATERIALS↗

DOE OSTI2024

Comparing Pr 3+ and Nd 3+ for deactivating the Er 3+ : 4 I 13/2 level in lanthanum titanate glass

Erbium lanthanum titanate glasses were prepared by levitation melting for the spectroscopic study of ways to promote the mid-infrared fluorescence. Two series of heavily erbium doped glasses (15 wt%) were prepared with the addition of either Pr 3+ or Nd 3+ in amounts relative to Er 3+ of 0.05, 0.1, and 0.2. Both ions quench the lower Er 3+ laser level with the Pr 3+ doing so more rapidly. Although high co-dopant concentrations result in higher energy transfer, as clearly evidenced in upconversion and downconversion fluorescence measurements, the mid-infrared lifetime also suffers a reduction and, therefore, a balance must be struck in the co-dopant concentration. Lifetime and spectral measurements indicate that, at a fixed relative co-dopant amount, Pr 3+ is more effective than Nd 3+ at removing the bottleneck of the Er 3+ 4 I 13/2 level. Moreover, consideration of the lifetimes alongside the absorption data of the individual ions indicates that despite the large absorption cross-section of Nd 3+ at 808 nm, the concentration needed to yield more absorbed power than utilizing direct 976 nm excitation of Er 3+ results in unfavorable lifetimes of the mid-infrared transition. In the end, Pr 3+ prevails as the superior co-dopant in terms of the effects on fluorescence lifetimes as well as potential laser system design considerations. In a unique self-doping approach, a reducing melt atmosphere of Ar instead of O 2 creates a small fraction of Ti 3+ . In 5Er 2 O 3 -12La 2 O 3 -83TiO 2 glass, the presence of Ti 3+ quenches the 4 I 13/2 emission about 2.6 times more than the 4 I 11/2 when lifetimes are compared to an O 2 melt environment. As an additional means of increasing the mid-infrared emission, the effect of temperature on the mid- and near- infrared lifetimes of a lightly doped lanthanum titanate composition is investigated between 77-300 K. The mid-infrared lifetime increases by ∼30% while the near-infrared lifetime increases by ∼10%, which suggests in addition to co-doping, active cooling of the gain media will further enhance performance.

Materials Science↗

DOE OSTI2023

Mid-infrared luminescence properties of erbium and dysprosium doped lanthanum titanate glasses

Glasses of composition x RE 2 O 3 -(17− x ) La 2 O 3 -83 TiO 2 were prepared by levitation melting from x = 0.1 to 9 for RE=Er and at x =0.1 and 1 for RE=Dy. The glasses have high transition temperature, exhibit low OH, and 1 mm thick discs are transparent out to 6 μ m. Mid-infrared emission lineshapes and lifetimes are comparable to what is seen in tellurite glasses containing Er 3+ and Dy 3+ . For x fixed at 1, the Er 3+ : 4 I 11/2 → 4 I 13/2 transition at 2716 nm has a fluorescence lifetime of 254 μ s and the Dy 3+ : 6 H 13/2 → 6 H 15/2 transition at 2957 nm has a fluorescence lifetime of 9.09 μ s. The results indicate that doped lanthanum titanate glasses offer the thermal stability of a ’hard’ glass with the host properties typically associated with ’soft’ glasses. Problems with the measurement of spectral features in the mid-infrared that could erroneously be assigned as resulting from rare-earth ion emissions are presented and discussed.

36 MATERIALS SCIENCE↗

DOE OSTI2023

Review of Current Software for Analyzing Total X-ray Scattering Data from Liquids

The popularity of the pair distribution function (PDF) analysis of X-ray total scattering data has steadily grown as access to ex situ synchrotron data has expanded. Due to the broadening of the PDF user community, there is a growing demand for software that can be used to extract PDFs and is accessible to non-expert users. While user-friendly options have been developed over the past decade for fast, streamlined data analysis, care must be taken in both processing the data and understanding any limitations, especially in the case of liquids. In this review, the same scattering data are analyzed using different total X-ray scattering software, in order to compare the accuracy of the extracted structure factors and associated pair distribution functions. The goal is to assess the best practices for extracting the most accurate liquid data for each software package. The importance of absolute normalization and the application of the most appropriate corrections are emphasized via quantitative comparisons between liquid sulfur and water. Additionally, an awareness of the competing conventions used to define the PDF in crystallography and liquids/glasses is crucial for both the downstream analyses of the data and a comparison with the previous results in the literature.

Gallington, Leighanne C. (ORCID:0000000203837522)↗