Engineering topics

Willey, Ronald J.

Publications and source records attributed to Willey, Ronald J..

5 records

NASA NTRS1993

Comparison of kinetic models for atom recombination on high-temperature reusable surface insulation

Five kinetic models are compared for their ability to predict recombination coefficients for oxygen and nitrogen atoms over high-temperature reusable surface insulation (HRSI). Four of the models are derived using Rideal-Eley or Langmuir-Hinshelwood catalytic mechanisms to describe the reaction sequence. The fifth model is an empirical expression that offers certain features unattainable through mechanistic description. The results showed that a four-parameter model, with temperature as the only variable, works best with data currently available. The model describes recombination coefficients for oxygen and nitrogen atoms for temperatures from 300 to 1800 K. Kinetic models, with atom concentrations, demonstrate the influence of atom concentration on recombination coefficients. These models can be used for the prediction of heating rates due to catalytic recombination during re-entry or aerobraking maneuvers. The work further demonstrates a requirement for more recombination experiments in the temperature ranges of 300-1000 K, and 1500-1850 K, with deliberate concentration variation to verify model requirements.

Willey, Ronald J.↗

NASA NTRS1989

Mechanistic model for catalytic recombination during aerobraking maneuvers

Several mechanistic models are developed to predict recombination coefficients for use in heat shield design for reusable surface insulation (RSI) on aerobraking vehicles such as space shuttles. The models are applied over a temperature range of 300 to 1800 K and a stagnation pressure range of 0 to 3,000 Pa. A four parameter model in temperature was found to work best; however, several models (including those with atom concentrations at the surface) were also investigated. Mechanistic models developed with atom concentration terms may be applicable when sufficient data becomes available. The requirement is shown for recombination experiments in the 300 to 1000 K and 1500 to 1850 K temperature range, with deliberate concentration variations.

Willey, Ronald J.↗

NASA NTRS1989

Arc jet diagnostics tests

Two objectives were addressed during a 10 week 1988 NASA/ASEE summer faculty fellowship at the Johnson Space Center Atmospheric Reentry Materials Structures Evaluation Facility (ARMSEF). These objectives were the evaluation of mass spectrometry for the measurement of atomic and molecular species in an arc jet environment, and the determination of atomic recombination coefficients for reaction cured glass (RCG) coated high temperature surface insulation (HRSI) materials subjected to simulated reentry conditions. Evaluation of mass spectrometry for the measurement of atomic and molecular species provided some of the first measurements of point compositions in arc jet tunnel environments. A major objective of this project centered around the sampling residence time. A three staged vacuum sampling system pulled the molecules and atoms from the arc jet to a quadrupole ionization mass spectrometer in 400 milliseconds. Conditions investigated included a composition survey across the nozzle exit at 3 cm z-distance from the nozzle exit for 3 different currents. Also, a point composition survey was taken around a shock created by the presence of a blunt body.

Willey, Ronald J.↗

NASA NTRS1987

Raman spectra of adsorbed layers on space shuttle and AOTV thermal protection system surface

Surfaces of interest to space vehicle heat shield design were struck by a 2 W argon ion laser line while subjected to supersonic arc jet flow conditions. Emission spectra were taken at 90 deg to the angle of laser incidence on the test object. Results showed possible weak Raman shifts which could not be directly tied to any particular parameter such as surface temperature or gas composition. The investigation must be considered exploratory in terms of findings. Many undesirable effects were found and corrected as the project progressed. For instance, initial spectra settings led to ghosts which were eliminated by closing the intermediate of filter slit of the Spex from 8 to 3 mm. Further, under certain conditions, plasma lines from the laser were observed. Several materials were also investigated at room temperature for Raman shifts. Results showed Raman shifts for RCC and TEOS coated materials. The HRSI materials showed only weak Raman shifts, however, substantial efforts were made in studying these materials. Baseline materials showed the technique to be sound. The original goal was to find a Raman shift for the High-temperature Reusable Surface Insulation (HRSI) Reaction Cured borosilicate Glass (RCG) coated material and tie the amplitude of this peak to Arc jet conditions. Weak Raman shifts may be present, however, time limitations prevented confirmation.

Willey, Ronald J.↗

NASA NTRS1987

The identification of excited species in arc jet flow

Spectrographic work done at the Atmospheric Reentry Material and Structures Facility (arc jet) located at the Johnson Space Center has led to the identification of several excited molecular and atomic states. The excited molecular states identified are: first positive nitrogen system, second positive nitrogen system, the first negative nitrogen system, the gamma system for nitric oxide, and the 306.4 nm system of OH. Excited atoms identified were nitrogen, oxygen, hydrogen, silicon, copper, sodium, barium, potassium, and calcium. The latter five are considered contaminants. Excited molecular states of oxygen were not seen, suggesting full dissociation of oxygen molecules to oxygen atoms within the arc column and nozzle. Further, evidence exists that O(-) may be present since a background continuum is seen, and because of the existence of positive species (first negative system of N2(+)). Interpretation of spectrographic plates was enhanced by the use of a microdensitometer, and by the application of a second order least squares routine which determined wavelength as a function of plate location. Results of this work will ultimately improve models used in the calculation of heat transfer rates to the space shuttle and the aerobraking orbit transfer vehicles.

Willey, Ronald J.↗